Hazards are working but rear tail brake and turn signals have stopped working along with the dash lights
SOURCE: 93 Oldsmobile Cutlass
check for a crossed filament in the brake lamp bulbs on the right side. have seen this many times before- usually at 5:00 on fridasy when i was on the way out the door
good luck
SOURCE: 2001 Olds Silouhette - The blinker on the dash blinks quickly
NO PROBLEM TURN ON THE RIGHT BLINKER THEN WALK AROUND THE CAR MAKE SURE FRONT AND REAR BULBS ARE FLASHING... IF YOU HAVE A BULB OUT YOU WILL NOT OFFER ENOUGH OF A LOAD TO THE FLASHER... WILL CAUSE IT TO FLASH FAST... IF OK THEN MAKE SURE THE PROPER BULB NUMBER ON BULBS AND MAKE SURE CORRECT BULBS USED IN VEHICLE.... IF OK CHANGE FLASHER
SOURCE: turn signals dont work
For 1993 Oldsmobile Cutlass Ciera 3.3L FI OHV
6cyl. you have two flasher units, one for Hazard Light and one for Turn Signal...
The hazard flasher is located in the convenience center, under the dash,
on the left side kick panel. The turn signal flasher is installed in a
clamp attached to the base of the steering column support inside the
car. In all cases, replacement is made by unplugging the old unit and
plugging in a new one.
Hope this help (remember comment and rated this help).
SOURCE: I have 95 olds cutlass sup. 3.1L Turn right the
most likely its your muti-funtion switch in the steering column.but first check your turn signal flasher & your emergency flasher
Testimonial: "It's looks like multi-function switch because all bulbs and fuse are look okay. I don't know how to replace the switch thus i have to go the shop. "
97 views
Usually answered in minutes!
×