Question about 2002 Ford F250 Super Duty SuperCab
I have a 1996 Subaru Legacy. The car is in fine working order except there is a constant on and off clicking noice coming from underneath the dash board on the drivers side. The noise start once you open the car door. The clicking wil last about a miniute, go off for 30 seconds then do on again. All lights blinkers work. The sound can be heard even is I turn the blinkers on. The noise still remains and cycles on and off. Any suggestions?
Try spraying some WD40 over the small switch that is half way down the front of both doors they are probably rusted up what we don't see much is what we all forget. should solve your problem. Hope this helps Best wishes, Malcolm Campbell.
Posted on Jul 03, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The clicking noise you are hearing is the temp door actuator. It is located in the center of the dash. If you look behind the radio from the Passenger side of the van you will see a white square box with a black or green connector in it. Remove the connector and then remove screws that hold the actuator in place. Install a new actuator and reconnect the wire connector. This should take care of your problem and your heater will be fixed. I hope this was helpful.
Posted on Jan 02, 2009
check all battey connections and system grounds. Check that the battery has 12v and holds properly when load tested. To check charging system, don't disconnect any battery leads...put a volt meter across the battery. when running, you should have at least 12.9v and volts should not drop. (usual reading is generally at or near 13) at idle with all accessories on voltage should be close to that as well. voltage should not exceed 14.Also make sure that drive belt is not slipping.
Posted on May 12, 2009
when the right blinker comes on and does not flash , make sure the front and rear turn signal lights are lit. Usually a blown front bulb will have a fast flashing type of indication something is wrong. A slow or no flash means the rear turn signal bulb is not lit. Bad bulb, or bad connection to the turn signal socket.
Posted on Aug 31, 2009
Tips for a great answer:
Feb 05, 2014 | 1996 Subaru Legacy
Sep 01, 2011 | 1995 Subaru Legacy
Oct 12, 2009 | 1995 Subaru Legacy
Jul 13, 2009 | 1996 Subaru Legacy
Apr 12, 2009 | 1996 Subaru Legacy
Jul 29, 2008 | 1991 Subaru Legacy
Jul 04, 2008 | 1996 Subaru Legacy
Oct 04, 2014 | 2002 Ford F250 Super Duty SuperCab
133 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: