Question about 1994 Mazda 2WD B Series Pickup

1 Answer

Where is the fuel pump located and what does it look like (Mazda 94 Proceed)

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mazda Master
  • 4,369 Answers

I believe this is same truck as Ranger

Pump is in tank

Removal
NOTE: On some vehicles, fuel gauge sending unit is not available separately. On those vehicles, to replace sending unit, replace entire fuel pump .

  1. Remove fuel tank as described in this section.
Removal and Installation
NOTE: Make sure fuel tank is properly supported during removal and installation procedures.
  1. Drain fuel from fuel tank .
  1. Loosen fill pipe clamp.
  1. Remove bolts securing shield and bracket assembly to frame (5005) and remove assembly from vehicle.
  1. Remove fuel tank filler pipe from vehicle.
  1. Support fuel tank .
  1. Remove bolts and nuts from rear fuel tank support strap and remove rear fuel tank support strap .
  1. Remove bolt and nut from front fuel tank support strap and remove front fuel tank support strap .
  1. Lower fuel tank .
  1. Remove fuel feed hose at sender push connector.
  1. Remove fuel return hose at sender unit push connector.
  1. Disconnect sender and fuel pump electrical connector.
  1. Remove fuel vapor hose from fuel vapor valve .
  1. Lower fuel tank from vehicle
  1. Remove fuel tank to bench. Remove any dirt that has accumulated around the fuel pump attaching flange so that it will not enter the fuel tank during fuel pump removal.
  1. Turn the fuel tank sending unit locking retainer ring (9A307) counterclockwise with the Fuel Tank Lock Ring Wrench Tool T90T-9275-A or T86T-9275-A and remove fuel tank sending unit locking retainer ring .
  1. Remove the fuel pump and sender assembly.
  1. Remove fuel pump mounting gasket (9417) and discard.
  1. If necessary, disconnect spade connector and remove two screws and fuel gauge sending unit.

Posted on Jun 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whats the purpose of fuel shut off 94 mazda progete


The emergency fuel shut off switch is present to prevent gas fires in the event of an accident. It is an impact switch and disengages power to the pump after an accident. There has been situations where an accident caused fuel lines to break, the key was still supplying power to the pump, and a car fire resulted. This switch prevents such fires. Thanks and please rate.

Sep 04, 2011 | 1994 Mazda Protege

1 Answer

I ran my 1992 mazda marvie proceed out of fuel and suspect that the carb and injectors may be blocked, have replaced fuel filter but it still wont run or idle.Need to know how to strip and clean carb, etc


SOUND LIKE FUEL PUMP DAMAGED BECAUSE LACK OF FUEL. FUEL IN TANK.FUEL KEEP FUEL PUMP COOL AND LUBRICATED IF FUEL TANK GET TOO LOW OR EMPTY CAUSE FUEL PUMP OVER HEAT DAMAGE.

Nov 06, 2010 | Mazda B2600 Cars & Trucks

2 Answers

I put a new fuel pump on a 94 Mazda and now it won't work in the car but runs fine when I take it off and try it. Is there a relay or something like fuel cutoff? If so where is it


There are fuses for the fuel pump and should be located under the hood.You should not run the pump out of the fuel tank the fuel keeps the pump cool and it only takes about 15 seconds to destroy a new pump when running it out of the tank.Chances are you might have ruined the pump by running it out of the tank.

Feb 17, 2010 | 1994 Mazda 323

1 Answer

Fuel filter location/replacement My car is cutting out at 4000 RPM


2006 Mazda MX-5 Miata 2.0L MFI DOHC 4cyl
Mazda Car 2005-06 Repair Guide - Removal & Installation

The fuel filter on most Mazda cars can be located on a bracket in the left rear of the engine compartment, next to or beneath the brake master cylinder fluid reservoir or as part of the fuel pump assembly.

The filter on Mazda3 models is part of the fuel pump assembly.

The fuel filter is part of the pump assembly. Once the fuel pump is removed, remove the filter retainer and filter. refer to the fuel pump procedure or removal and installation.

I hope help you. Good luck.

Oct 12, 2009 | 2006 Mazda Miata

1 Answer

94 MAZDA MX3 REPLACED FUEL PUMP, HAS NO POWER TO PUMP, HAS SPARK, CRANKS BUT WONT START


check the fuel pump relay. it is located under the hood in the fuse box directly in front of the battery

Apr 16, 2009 | 1994 Mazda MX-3

1 Answer

Car dying out on acceleration


try having the air flow meter just behind the filter checked i hav a 94 proceed had similar problem and the air flow meter was the cause

Feb 26, 2009 | 1988 Mazda B2600 Cab Plus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

579 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...