Need replacement molding for around doors on a 94 Cavalier conv.

Go to a GM parts store and get the part number of the hinge. They will be able to tell you what vehicles that part number will be used on. Go on line for parts and see what vehicles use that part number. Go to a GM wrecker and see how many vehicles use the hinge you want.

check a web sight www.autopartswarehouse.com they may have it if not try www.partsgeek.com

Remove Old Mirror
1. 1 Open the side door to the Chrysler Town & Country, and find thescrew that holds the side mirror molding in place.
   
2. 
   Take the screw out and remove the molding panel that attached around the outside of the power mirror.
   
3. 
   Remove the bolts connecting the mirror to the door assembly. If equipped, unplug the power side view mirror wiring harness connector.
   
4. 
   Unplug the electric connectors, and pull the mirror out of the molding.
   

I suggest visit autozone.com (free register) and check the GM Cavalier/Sunbird/Skyhawk/Firenza 1982-1994 Repair Guide information.

Good luck.

IF I,M UNDERSTANDING THIS RT., THE LATCH IS LOOSE BECAUSE OF PLAY WITH THE RUBBER ALMOST GONE? WHT U CAN TRY IS A TYPE OF STICK ON FOAM. SOMIETHING LIKE THE RUBBER MOLDING AROUND UR DOORS.......CANADIAN TIRE SELLS DIFFERENT TYPES OF MATERIALS LIKE THAT.....OR OTHER CAR PARTS STORES IN UR AREA ,WHEREVER U MAY BE,,, REMOVE WT,S LEFT IN THAT CORNOR& CUT & SHAPE THE MATERIAL .....GD LK, CHARLIE

you must pull the door pannel, with the window up you will see 2 bolts on the inside remove the latch rod first then the bolts !!

there are clips that pull out of holes in door around perimeter of door remove panel, that should give you access 

You can try a lock-jock lockout tool by sliding it down the out side of the glass to unlock the door from the inside at the door latch assembly.

you will have to take off the top dash pad first. its not too hard just take your time. there are several small bots/screws for the dash pad, in the glove box, and pop off the side panels on the out side of the dash, the part that the door closes against. also pop off the defroster vent and if i remember right there are a couple in there to. the dash pad will need to be poped up and lifted out. then just look around the plastic molding you will see more bolts holding that down, just take your time and make sure you get them all. i missed one and broke a small bit off of mine, but ot still went back in fine. it is a little tricky getting it from around the instrument panel and the steering wheel. but like i said its not hard just take your time.

they just pop into place push hard :) you'll hear the click when it goes in.