Question about 2001 Mercury Sable

1 Answer

Right rear signal light needs replacing - 2001 Mercury Sable

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mercury Master
  • 4,369 Answers

You need to remove the lamp assembly to replace the bulb. here is the procedure:

Rear Lamp Assembly —Sable Four Door Removal and Installation

  1. Remove the luggage compartment scuff plate.
  1. Pull back the luggage compartment carpet.
  1. Disconnect the rear lamp assembly electrical connector.
  1. Remove the nuts.
right rear signal light needs replacing - 04eb075.gif
  1. Remove the rear lamp assembly.
    1. Pull the lamp assembly away from the body.
    1. Disconnect the rear lamp assembly bulb connectors.
    1. Remove the rear lamp assembly.
  1. CAUTION: To prevent water from entering the luggage compartment, make sure the rubber grommet is fully seated.
    To install, reverse the removal procedure.

Posted on Jun 25, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turn signal lights not working. turn on emergency flashers and the right signal flashes and bath back lights and the front right flash but the left front don't. any idea's


The 2 filament on the LH Front turn signal is most likely burned out, ...........or the ground to it, & the entire socket needs replaced. Caution lights, send signals to ALL FRONT & REAR lights. All turn signal lights must be in working order, as it is a "pulsating" currect surge sent to the bulbs, LH or RH, depending which direction you wisk to turn. If 1 filament is broken, the circuit is incomplete, & no flash will occur. Usually you will get one light that stays on, & the front or rear missing lighting, is the one whichis the culpret.

Aug 29, 2011 | 2001 Ford F150 Styleside SuperCrew

2 Answers

The Right Turn Signal comes on, but doesn't blink on my 95 Buick Park Ave. I have a State Inspection coming up and need to get it fixed by this weekend.


It sounds like one of the signal lights is out. The best way to find out is to turn the hazards on and check if they blink. If they do then you might need a turn signal relay.

Good Luck

May 11, 2011 | 1995 Buick Park Avenue

1 Answer

Front right signal lights come on but don't blink, rear right does not come on at all. Left side is working fine.


That means that the right rear bulb is blown and needs to be replaced and then you should have your turn signals back to working right. I hope this helps you and good luck.

Mar 29, 2011 | 1992 Plymouth Acclaim

1 Answer

I have a 2002 pontiac aztek. My rear right signal/brake lamp does not work. When i signal left, the front and rear left lights flash normally. When i signal right, the front right light flashes normally...


as for the faster flashing thats as simple as a blown bulb, replace the bulb and see if that fixes the problem, it may fix the lot because the other symptoms you mention are a bad connection, if bulb is fine check the connection isnt loose or corroded over. if it is simply file it back to establish better connectivity,

Jun 22, 2010 | 2002 Pontiac Aztek

2 Answers

I need to find the fuse for the back right turn signal


I seriously doubt the right rear turn signal is fused all by itself. if the other signals function it isn't a fuse. Check the bulbs closer and also if someone wired in trailer lights start looking there first, they probably used scotch locks to connect wires and something isn't connected well or corroded etc..

Nov 04, 2009 | 1998 Ford Expedition

1 Answer

Right turn signal doesn't work.


the next step and almost certainly the problem is the turn signal switch, have seen this symptom on other years around yours and switch fixed it.

Sep 09, 2009 | 2002 Chevrolet Monte Carlo

4 Answers

Brake light, Turn signal not working rear right 06' Focus


I have a 2000 ford focus no brake lights. with the brake lights the transmission would not go into drive .replaced the brake light switch checked fuse replaced turn signal switch with no results then i moved onto the wiper switch and replaced it as much to my supp rise it fixed the problems

Jul 26, 2009 | 2000 Ford Focus

1 Answer

Brake light/turn signal no not work on left side only.


check fuse number 7 in Engine Compartment Fuse Box , if its ok you need change turn signal switch

Mar 15, 2009 | 1996 Ford F150 Regular Cab

1 Answer

Right signal and brake light


Looks like the problem is in the turn signal switch. This is a common problem. When the turn signal switch goes bad it will cause problems as mentioned above by you. Replace the turn signal mechanism.

Feb 25, 2009 | 2002 Ford Excursion

Not finding what you are looking for?
2001 Mercury Sable Logo

Related Topics:

279 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

fordexpert

Level 3 Expert

5495 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...