SOURCE: How does a GMC Anti-Theft Work?
anti theft in you gm vehicle is to prevent some body from driving away with your vehicle. Not to prevent someone from breaking into it. You need to have a secondary alarm system installed. This will protect the contents of your Denali. Mike
SOURCE: i need to be walked
Here have information about #791 bypass module: Bulldogsecurity Model791
IF YOUR REMOTE STARTER IS CLICKING AND/OR
FLASHING THE PARKING LIGHTS AND IS NOT RESPONDING TO THE REMOTE, IT IS
IN SAFE MODE AND NEEDS TO BE INITIALIZED BY DOING THE FOLLOWING:
If you have a 4 button remote, you must ground the black/blue
hood pin
wire (raise hood if hood switch is installed). Apply 12volts to
blue/black brake wire (press and hold brake pedal if wire is installed).
Press and hold any button on your remote until clicking and flashing
stops. Unit will now respond to the remote. Remove ground from hood
pin wire and voltage from brake wire.
If you have a 2 button remote, hold brake and press any button on the
remote until clicking and flashing stops.
ADDENDUM
If
you have an RS1100 or RS1200 and
your vehicle runs for several seconds, shuts
off, restarts, runs, and shuts off again, perform
the following step:
Connect the Black/White tach wire (from the 16 pin plug) to the heavy
gauge White Ignition 1 wire and program the unit for Tach Mode (bottom
of page 19).
Witch model alarm have your vehicle?
Good luck.
Testimonial: "awesome info with lots of extras! went above and beyond the call of duty! "
SOURCE: i have a 2006 sierra slt dont know the anti theft
The dealer has the code just give them the serial number and they will want proof of ownership, you call the service are aand they should help you
SOURCE: Replaced front pads on 2006 gmc sierra now brakes go to floor at times
sounds as though there is air in the system get them bled to remove air then should be ok if not somthing worse going on
744 views
Usually answered in minutes!
×