Question about 1995 Buick Century

1 Answer

How to replace a starter on 94 century . The starter tries to turn over and then stopsand buzzes loudly and I have to turn it off and try again. Will it hurt to continue to do this. It always starts after 2 or 3 tries.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 439 Answers

It will not hurt, but this means your starter is going out and will need to be replaced soon.

Posted on Jun 25, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a nissan almera 2007 it has 100,00 plus mile,s.the engine will not turn over.When i try to start it it just give,s a buzz sound.The batterie is fully charged starter seem,s ok the buzz sound is...

This sounds like your starter is getting stuck which is not that uncommon , sometimes giving it a tap with the hammer can free it up .... thats a tap not a smash ! is your car a manual or automatic ? if it is a manual i would clutch start the car just to get it running and after it has warmed up turn it off and try to restart it again just to eliminate other problems , you dont need a computer program for this fix but you might have to replace the starter .

Sep 26, 2017 | 2001 Nissan Almera Tino

2 Answers

I replaced my starter on my 94 ford ranger. my truck won't start, when it cranks, it makes a loud grinding noise. How can I fix this problem?

When buying starter motors it is essential that the starter pinion teeth are of the same pitch as the flywheel ring gear. Not all starters from the same make fit different engines because of this problem. However I would be checking that I had put the starter in the housing properly as any misalignment will cause your problem

Apr 25, 2014 | 1994 Ford Ranger Supercab

1 Answer

94 ford e350 van wont turn over when I turn the key it just makes a buzz sound good battery checked cables

Sounds like either the starter or starter solenoid. With the key in the "On" position try using one side (either positive or negative) of a pair of jumper cables. Locate the starter solenoid and clip one lead to the battery side of the solenoid, and just quickly touch the other lead to the other side of the solenoid. If the starter engages, replace the solenoid. If not, carefully check the positive cable from the battery to the solenoid for cracks, exposed wire, corrosion and good, tight connection. Good luck.

Sep 30, 2013 | 2004 Ford F150

2 Answers

Loud click and buzz when trying to start car

your starter is shot. The click and the ting sound is your bendex not engaging properly. You can catch car on fire, or mess up your computer if you keep trying to start it. Be sure to disconnect the battery when you change it. Good luck

Jan 17, 2013 | 2002 Chevrolet Impala

1 Answer

My 94 Buick Century wont start? Trying to figure out if it is the starter...I hear fuel pump engaging light and everything work. when I go to start does nothing...

Check your battery voltage, sound to me like your battery cold cranking amps is low. Its enough the power the lights but not turn the engine over. Have the battery replace

Jun 06, 2012 | 1994 Buick Century

1 Answer

My 89 buick century starts and rus for awhile then dies and sometime does not start i put a new starter on two days age and it still doing it no check lights on

My 94 regal would sometimes start and sometimes not. Sometimes would just die like you turned off the key... after replacing many parts I ended up replacing the crankshaft position sensor and the camshaft positon sensor and it has worked great ever since...

Oct 28, 2009 | 1989 Buick Century

1 Answer

I have a 94 chevy truck. 4.3L v6 and never had a

it sounds like your ignition switch could be bad, it is mounted on the steering column under the dash, it is the actual switch that activates the ignition and starter when you turn your key. if it is going bad it will give the same symptoms that you have described.

Aug 24, 2009 | 1994 Chevrolet C1500

2 Answers

Car won't start; Replacement Key from GM or Starter Bad?

Check the cylinder, maybe the magnetic spot is not contacting the correct area of the cylinder. Cylinder may be loose, also poosibly bad computer chips on the keys.

Jul 23, 2008 | 2001 Buick Century

Not finding what you are looking for?
1995 Buick Century Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides