Question about 2000 Daewoo Nubira

2 Answers

Owner's manual for nubira 2000

Dear stevenhurc
ok i need the parts for automatic transaxle and air conditioning systems

best regards,

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Daewoo Master
  • 450 Answers
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.


    An expert that got 20 achievements.


    An expert that got 10 achievements.

  • Daewoo Master
  • 80,406 Answers

ARE U REFERING TO ANOTHER POSTING? if so don't do that, we experts have no way to access these previous posts, what can i help u with?

Posted on Jun 24, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What causes a/c to stop working and all power to shut down

Air conditioning compressor located under the power steering pump will have a fault where the three wires enter the pump

Aug 01, 2014 | 2000 Daewoo Nubira

1 Answer

The problem is Im having a hard time finding a owners manual of my 2000 daewoo nubira SE

owners manuals r garbage--get a haynes or other repair book-fixya hasum or parts store

Aug 08, 2011 | 2000 Daewoo Nubira

1 Answer

How difficult is it to replace an engine in a 200 kia sephia

1998-01 Models
NOTE: The procedure for removing the engine requires removing
the transaxle along with the engine as an assembly. As a result, when the
halfshafts are pulled from the transaxle, a special plug/side gear holding tool
is recommended.

  1. Before servicing the vehicle, refer to the precautions in the beginning of
    this Section.
  2. Properly relieve the fuel system pressure.
  3. Remove or disconnect the following:

    • Battery cables
    • Battery and tray

  4. Drain and recycle the engine coolant.
  5. Remove or disconnect the following:

    • Data Link (DLC) from the Mass Air Flow (MAF) sensor bracket
    • Intake Air Temperature (IAT) and Mass Air Flow (MAF) sensor connectors
    • Air intake hose from the throttle body
    • Ventilation hose and fresh air duct
    • Accelerator and, if equipped, cruise control cables
    • Air cleaner assembly
    • Brake booster and purge control vacuum hoses from the intake manifold
    • Upper and lower radiator hoses
    • Fuel hose from the fuel injector rail
    • Heater hoses
    • Idle Air Control (IAC) and Throttle Position (TP) sensor connectors
    • Fuel injector electrical connectors
    • Starter and generator electrical connectors
    • Engine ground strap
    • Left and right splash shields
    • Exhaust manifold heat shield and 3 power steering pump bracket bolts
    • Air conditioning compressor mounting bolts and position it aside leaving the
      hoses attached
    • Ground strap from the top of the transaxle
    • No. 4 engine mount
    • Input/turbine speed sensor connector, if equipped with an automatic
    • Back-up light switch, if equipped with a manual transaxle
    • Vehicle Speed Sensor (VSS)
    • U-clip from the selector cable and the nut and washer from the transaxle
      linkage, if equipped with an automatic transaxle
    • Linkage and extension bar, then the clutch release cylinder and hydraulic
      hose, if equipped with a manual transaxle
    • Transaxle range switch and solenoid valve connectors, then the 2 transaxle
      oil cooler hoses, if equipped with an automatic transaxle
    • Front wheels
    • Oxygen (O2) sensor electrical connectors
    • Front exhaust pipe
    • Halfshafts

  6. Properly support the engine/transaxle assembly.
  7. Remove or disconnect the following:

    • 2 No. 2 engine mount-to-mounting member mounting bolts
    • 1 bolt from the No. 3 engine mount
    • 3 No. 1 engine mounting bolts, then carefully lift the engine/transaxle
      assembly from the vehicle

    To install:

  8. Installation is the reverse of the removal procedure. Note the following
    important steps.
  9. When possible, leave the engine mounting nuts/bolts loose (hand tight) until
    all mounts are aligned and bolted. This may help in aligning the
    engine/transaxle assembly in the vehicle.
  10. Tighten the engine mount bolts/nuts as follows:

    • No. 1 mounting bolts: 50-70 ft. lbs. (67-93 Nm)
    • No. 3 mounting bolts: 63-86 ft. lbs. (85-116 Nm)
    • No. 2 mounting nuts: 28-38 ft. lbs. (38-51 Nm)
    • No. 4 mounting bolts: 47-66 ft. lbs. (64-89 Nm)
    • No. 4 mounting nuts: 49-68 ft. lbs. (68-93 Nm)

  11. Install new circlips on the inner CV-joint stub shafts, if equipped,
    intermediate shaft. Grease the shaft splines before installing the
    halfshaft/intermediate shaft into the transaxle.
  12. Always install new gaskets and/or O-rings. Use new self-locking nuts,
    especially on the exhaust.
  13. Fill the engine and the transaxle with the proper types and quantities of
    oil. Fill the cooling system.
  14. Connect the negative battery cable, start the engine and check for leaks.
    Check all fluid levels.

prev.gif next.gif

Oct 30, 2010 | 2000 Kia Sephia

1 Answer

My nubira 2000 incident

You need to bring this to a body shop. They can give you the best advise. You have damage we can't see. Everything you get from us is just a guess and i'm sure your allready doing that.

Jul 14, 2009 | 2000 Daewoo Nubira

1 Answer

Shock while automatic transmission shifting in nubira 2000

the 2000 nubria s have three sensors on the side of the transmission that work on electrical charge and pressure you may have a bad ground to the sensor or a bad sensor best bet is find someone who has a obd sensor and check the codes and see what you get
good luck

Jul 03, 2009 | 2000 Daewoo Nubira

1 Answer

Nubira 2000 owner's manual clarification

manual comes with all daewoo models in one package cannot separate is 267mb.then have to run setup file in folder to install on pc all files are pdf format and auto password locked to pc on install. i can cut & paste info & post on site

Jun 23, 2009 | 2000 Daewoo Nubira

1 Answer

Air conditioning is not cooling

no ,most likely cause is low gas weight ?? this needs a special machine and a skilled technician to re-charge the system .NOT A DANGEROUS STUPID CAN OF GAS .this system should hold about 600grms of gas ,

Jun 12, 2009 | 2000 Daewoo Nubira

1 Answer

Nubira 2000 automatic transaxle fluid

can't shift out of park unless key is in emergency release. Is there possibly an electrical problem, problem with the transaxle...

Jun 06, 2009 | 2000 Daewoo Nubira

1 Answer

Nubira 2000 user manual pdf manual (english)

try this link to manual even though its 2004 manual is basically same just they updated info and put all paper based books into electronic form.(this link works !!)

Jun 06, 2009 | 2000 Daewoo Nubira

Not finding what you are looking for?
2000 Daewoo Nubira Logo

Related Topics:

728 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

80339 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides