Question about 1994 Chrysler LeBaron

2 Answers

Every time we try and put the convertible top down the window cracks. Is there something that needs to be unlatched in the back where the window is??

Posted by on

  • yadayada
    yadayada May 11, 2010

    THAT IS A GOOD QUESTION.

  • chrisbock May 11, 2010

    soft top or hard

×

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Lower windows b4 putting top up silly :)

Posted on Nov 24, 2011

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 93 Answers

If you don't have anything in the well, the frame is out of allingment.
This is often caused by lowering the top while the car is moving.
Take it to a top shop.
You say, "Every time". If you had it replaced, the installer should have seen and corrected the problem.

Karl at topgunwon.com

Posted on Jan 25, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My convertible top on my 2001 mustang will not go follow down, passenger side gets stuck back bar bends


In the rear quarter panel in front of the rear wheel and behind the rear speakers there is a Hydraulic Lift Cylinder or piston that moves to bring the top up and down. Sometimes a nut that holds that piston in place will get loose and need to be re-tightened. While there you may also check the bushing that keeps it snug on the bolt. It often cracks and makes the cylinder woobly.
There is a link below for a new one from American Muscle...

https://www.americanmuscle.com/convert-top-cylinder-9904.html?utm_content=Restoration%20-%20Exterior%7COPR&utm_campaign=AMM%201979-2004%20No%20Years&utm_source=google-pla&utm_medium=shopping&T5_Var3=blue&T5_Var4=101815&intl=0&gclid=CMnGsJH5_dgCFUzkfgodHy8FFA&gclsrc=ds

Aug 28, 2017 | 2001 Ford Mustang Convertible

1 Answer

Tried to ppen the convertible top. It got halfway and stopped. Put the top back down. Tried to open it again and something cracked or snapped. Now the trunk won't open, but the lock on the trunk makes a...


sounds as though the bowden cable may have snapped. pull the lever under the rear seat to disengage the motors in the boot to further investigate

Apr 15, 2011 | 1996 BMW 318

1 Answer

When the top is put down on my 2004 New Beetle GLS Convertible 1.8L Turbo, there is a beeping noise that continues. How do you stop the beeping noise once the top is down?


Just in case you still needing assistance.......

The micro switch in the handle assembly where you unlatch the roof is bad or out of adjustment.

Dec 19, 2010 | 2004 Volkswagen New Beetle Convertible

1 Answer

How do you put the top down. I have a rental, and their is no owner's guide.


1.Empty the trunk of all contents
2.Park on a level surface and set parking brake, shift auto trans into Park or manual into R
3.Turn the ignition off.
4.Open the trunk.
5.Pull down the convertible top latch located above the rearview mirror and turn it counterclockwise to unlatch . Leave the latch open and turned to prevent damage.
6.Pull rearward on the side edge of the convertible top and pull it off of
the windshield frame.
7.Push the convertible top down into the trunk
8.After the top is stored, push on the convertible top to ensure that the top is fully retracted and securely stored.
9.Close thet runk by pressing down from the rear center of it with a swift, firm motion.

Sep 05, 2009 | 2007 Pontiac Solstice Convertible

1 Answer

I have a 2005 PT Cruiser. The convertible top was down. When I went to put it back up, I had no power. The fuse was fine. I bled the pressure off the cylinders and manually put the top up. The wondows on...


HYDRAULIC PUMP/MOTOR ASSEMBLY Any diagnosis of the power top system should begin with the use of a scan tool and the proper Diagnostic Procedures Information. The scan tool can provide confirmation that the Controller Area Network (CAN) data bus is functional, that all of the electronic modules are sending and receiving the proper messages on the CAN data bus, and that the power top motor is being sent the proper hard wired output by the driver window regulator module.


NOTE: The convertible top system is equipped with a hydraulic bypass screw that is used to relieve pressure from the hydraulic system in the event that the top must be manually raised or lowered (such as a low battery or a convertible top operating concern). Always verify that the bypass screw is tight in the pump housing prior to replacing a hydraulic pump/motor assembly (Refer to 23 - Body/Convertible Top - Standard Procedure). If the power top is completely inoperative and the hydraulic pump/motor assembly is suspect, perform the following:

(Refer to 23 - Body/Seats/SEAT BACK - Removal).(Refer to 23 - Body/Convertible Top/ASSEMBLY, Hydraulic - Removal). If not OK, use a scan tool and the proper Diagnostic Procedures Information to complete diagnosis of the power top system.

On convertible vehicles, the convertible top switch is hard wired to both window regulator modules by the Power Top Switch Mux circuit. When a top operation input is received by the driver window module, it will ground the respective relay control circuit which in turn will operate the motor. If the convertible top switch is pressed and held to the down position second detent, it will command both modules to drop all windows to the fully down position. The windows cannot be raised when the convertible top switch is in the top down position. When the switch is held in the top up position and all four windows are fully up, the modules will lower the respective front window 40 mm (1.6 in), lower the respective rear window approximately 55 mm (2 in) and the driver window module will ground the top up relay control circuit. Once the top is back up the windows will not raise automatically.

Your missing that you don't have a clue on how the electronic's on your vehicle work . Your best bet , take it to a qualified repair shop . Your trying to fix something you have no clue on how it works , going at it blind .

Jan 04, 2018 | Chrysler PT Cruiser Cars & Trucks

1 Answer

2005 crossfire top wont go down


This can be caused by your trunk lid not being all the way shut .  But the most times this has happened to me the separator panel that lifts out toward you and latches to separate top from trunk space is not lifted into the latched position.. very frustrating till i figured it out.  Hope this helps helps.  

Apr 03, 2009 | 2007 Chrysler Crossfire Convertible

3 Answers

1997 Saab Convertible top is broken, and the rain is coming in!


the rear of the top under the back window is drawn down into place and latched by its own motor that simply pulls or pushes two rods. If the motor stopped moving for whatever reason, simply fold down the back seat, reach your arm through the little access at the top of the boot on the drivers side and pop the rods out of place and latch/unlatch manually. this takes a flashlight and some inspection time to do at first if you dont know what your feeling for.

i have the same problem with my 98 900s

Jan 30, 2009 | 1997 Saab 900

1 Answer

Letting the top down


I had the same problem for four years until I purchased a CD from Ebay titled "BMW E30 Convertible". I discovered, that I was opening the top up incorrectly. The top works fine. Unlatch the top from the windshield frame, then lift up the back half of the top, unlatch the top lid, rise it up and lower the top into the compartment, close and latch the soft top lid. Hopes this helps.

Jan 29, 2009 | 1987 BMW 3 Series

3 Answers

The top on my 2005 mini cooper s will not go down .


often times this problem ends up needing a front sunroof section of the conv top replaced. The cable that drives the hooks to unlatch is most likely broken and that is currently the only fix. EXPENSIVE. Sorry

Jan 19, 2009 | 2007 Mini Cooper S Convertible

Not finding what you are looking for?
1994 Chrysler LeBaron Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...