Question about Peugeot 405

1 Answer

Peugeot 206 radiator fan relays

Hiya my relay wires and contacts have disintigrated on om 02 1.1 3dr where can i get replacement relays

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My fiancee's did this aswell, you need to get a new relay form peugeot (arounn £10) and 5 male conectors that will fit on the relay and cut the block off the wires and attach it this way. thats how i did it and it works a treat now mate.

hope that help mate, Ray.

Posted on Jul 05, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Peugeot 206 1,4HDi 2002 Where is the front Wind screen washer relay located? If there is Andy? The fuse is on society 14 but I dont finde the relay!

there is no relay on this circuit, switch, wiring, or pump if you have power at switch make sure there is a earth or ground also.

Feb 04, 2018 | Peugeot Cars & Trucks

1 Answer

Where is the air con relay located - 2000 Peugeot 206 1.6 petrol

if you mean the one thay controls the cooling fan then there is 2 of them located at the front of the car next to the cooling fan. these are probably behind a cover and are green in colour and have 5 pins and the wiring usually corrodes where it goes in to the plugs

if this was any help let me know

May 02, 2010 | 2005 Peugeot 405

1 Answer

Peugeot 306 diesel red stop light is on and both fans run

there are 2 relays inbetween the 2 fans behind the front grill the wiring to the relays tend to corrode.
what you need to do is replace both relays and the wiring conectors

Dec 02, 2009 | Peugeot 405 Cars & Trucks

1 Answer

I have a peugeot 406 LX, 1999, V-Reg, 4 door saloon. I previously had the same car but when the temp guage reaches near 110 the fans start. But in this car when the temp guage is below 90 the radiator...

there are 2 relays inbetween the fans they are known for the wiring corroding and causing problems with the relays
get this checked and replace the relays and conectors if needs be

Nov 17, 2009 | 2006 Peugeot 405

1 Answer

I have a 2001 206 gti and the engine just died

hiya mate if you have got a live at the fuel pump when engine is turning over then your relay is working.
you could possably have a fauly crank position sensor (which can be checked using a code reader) which would stop the engine from starting, also check the fuel pressure switch has not been activated (this is located on the n/s/f inner wing and is a small black unit with a red cap on it)
it would also be a good idea to make sure the timing belt has not snapped.

Sep 29, 2009 | Peugeot Liberte Cars & Trucks

2 Answers

My car is peugeot 206 1100 cc. My car temp is going up to 95 within ten mein from starting it what is the problem?The motor oil is checked, thermostat is working ok, no air in thw water cycle, and the...

From what you describe, I would consider looking at the Radiator Fan operation,and associated A/c and Radiator Fan Fuses circuit and Relays.

Aug 27, 2009 | 1994 Hyundai Excel

1 Answer

Engine cooling fan not cutting in Peugeot 206 2002 Cooling fan and motor have been replaced with main dealer parts

Try the cooling fan switch, it looks like a large brass nut with wires on it on the thermostat housing or radiator.
To test, pull off the wires and connect together, turn on ignition and the fans should cut in.
If they don't it could be the relay, fuse or broken wire.
The switch is easy to replace, unscrew and rescrew in the new one. Connect the wires, not important which way the wires go, and refill coolant.

Aug 07, 2009 | 1991 Peugeot 405

1 Answer

405 GLD Cooling Fan

Hmm, perhaps it is time for a noisy solution.

Get a 30 amp relay and wire the fans via directly to the battery via that relay. Of course, disconnecting them from where that are wired into the vehicle now.

For the fan control to the relay, wire something that is (+) when the ignition is in the 'run' position.

This, of course, is the quick n dirty fix. While this will work, you have an always on, noisy solution, and it will take quite some time for your vehicle to warm up in the winter time.

Just an idea should you not be able to correct the factory wiring, of which I have no idea.

Best of luck,

Mar 04, 2009 | 1991 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

2,113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

mike hayward

Level 2 Expert

279 Answers

Wahs Team

Level 2 Expert

215 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides