Question about 1998 Pontiac Bonneville

Open Question

Remove starter from 1998 pontiac bonneville sse

Metal shroud covering starter. shroud bolted on passanger side but appears to have been welded on driver side. any way to remove rear starter bolt with out removing shroud?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Brian032472
  • 150 Answers

SOURCE: fuse box

CHeck the owners manual index or the back side of the fuse box cover place they are usually in both locations. If neither are available you can order a owners manual on line or with the local dealer. The parts store should have a repair manual for your car also with this information

Posted on Nov 04, 2008

johnny5846
  • 379 Answers

SOURCE: 1999 Pontiac Bonneville serpentine belt installation.

if you look by the crankshaft pulley to the right you will see a tubular looking shaft about 1" diameter , you will notice you can't get the belt out from under this piece , it has a nut on it , once you take the nut off , you will notice it has a star shaped point on the tip of the stud , it requires a reverse torx socket or wrench to remove the stud , when you get the stud out the tube piece it can be removed , then the belt comes off , replace the belt , now comes the tricky part , fitting that tube spacer back into its spot , it can be difficult , once its in place put the stud back in , and put the nut on and tighten it , your pretty much a pro now . thanks.

Posted on Dec 30, 2008

michigan man
  • 3533 Answers

SOURCE: Pontiac radio codes

recommend a dealership or a place that installs radios that has access to these codes

Posted on Jan 06, 2009

  • 599 Answers

SOURCE: how do i remove the

ignition? tilt column?... steering wheel puller..lock plate remover....hazard pin puller.. down til you remove collar for ignition.. key in acc use pin the remove lock cylinder and key assembly.reverse

Posted on Jan 14, 2009

MrScary66613
  • 1990 Answers

SOURCE: serpentine belt for 1997 pontiac bonneville sse w/ supercharger

http://www.mvreader.com/multiview/dayco/catalogSearch.php?autoCatalogSearch=1&make=PONTIAC&model=BONNEVILLE&year=1997&year_from=&year_to=&engine=All&l=n

This should help. Please Rate My Response! Thanks!

Posted on Feb 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the starter bolts on 1994 pontiac bonneville


guessing you either have a 3.1 or 3.8 L engine, if so they will be located on bottom side of starter on front of engine should be a 14 mm or poss 15mm bolt head however it may have a splash shield covering the bolts which should be a 10 mm bolt probably 2 of them holding splash shild on

Sep 27, 2012 | 1994 Pontiac Bonneville

1 Answer

Where is the fuel pump relay located in a 1991 Pontiac Bonneville SSE


Hi, the Fuel Pump Relay is located in the Relay Center. The Relay Center is located behind RH side of Instrument Panel (I/P) , top of RH shroud..

Jul 24, 2011 | 1991 Pontiac Bonneville

2 Answers

How do I locate the starter on a 1998 Pontiac bonneville. Car will not start the key turns all the way and the lights and radio still work but it does not start up.


you didnt say what size motor you have , i believe the starter is located right after the fan shroud attached to the engine.

Feb 06, 2011 | 1998 Pontiac Bonneville

1 Answer

Where is the starter located on a 1999 pontiac bonneville


Open the hood, look down behind the fans on the front of the engine at the bottom right side. You will need to disconnect the negative battery cable; jack up and safely support the car, get underneath, remove the wide plastic splash pan (10 mm bolts) that goes between the bumper and the front crossmember. Once that is out, you can easily see - and remove - the connections on the starter. One big one, (15mm?)a positive cable from the battery, and one little one, (5/16 or 9/32) from the trans. Remove the 2 plastic flywheel covers. (10 mm bolts - Gotta kinda twist the one to get it out.) Then remove the two 15mm (head) bolts that hold in the starter. Make note of any shims that fall out when you remove the starter.

Apr 10, 2010 | 1998 Pontiac Bonneville

1 Answer

Is there cabin filtes to clean?


do not clean them. replace them. onder the passanger side dash board. there is a cover on the bottom of the dash. remove the cover, usally black plable plastic. then you see the air box unit. onit is another cover shaped like an l. it goes on the bottom and the side. it is about 3 inches wide and 6 inches long on the side and bottom. held in by 1 bolt remove cover and pull out filters. have a shop vac ready. usually leaves and other debris fasll out.

Dec 31, 2009 | 1999 Pontiac Bonneville

2 Answers

1998 pontiac grand prix starter


disconnect the negative battery terminal first then disconnect the positive treminal so there are no accidents, raise the car safely go underneath & remove the starter cover should be 3 10mm bolts holding the cover on then remove the 2 through starter bolts 15mm then disconnect the + battery cvable from starter then disconnect the solenoid wire should be a 7 mm bolt. good luck

Sep 10, 2009 | 1998 Pontiac Grand Prix

1 Answer

Removal of starter on Pontiac bonneville?


13 and 15 mm bolts for the starter itself. 10 and 13mm for the wiring harness. Should be dead center underneath the front of your motor.

Jul 08, 2009 | 1998 Pontiac Bonneville

1 Answer

How do i replace the ignition coils on v6 93 pontiac bonneville (


you sure can do it yourself,some models the coil packs are bolted up seperatly usually 2 small bolts some models you have to replace all coils,either way you can do it! have a good day DB

Jan 31, 2009 | 1993 Pontiac Bonneville

3 Answers

Pontiac radio codes


recommend a dealership or a place that installs radios that has access to these codes

Jul 18, 2008 | 1998 Pontiac Bonneville

Not finding what you are looking for?
1998 Pontiac Bonneville Logo

Related Topics:

331 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...