Question about 1991 Acura Integra Hatchback

1 Answer

Head gasket was replace now it idels to 3500 rpm. also when try to give it gas you have to feather it to keep it from falling on its face..

Posted by on

  • musclecarman Jun 24, 2009

    I have look all over and cant find it for anything, I took and drove it around the block and had to feather the gas alot and hard to even get it to go, but it would go after a few seconds.

    Where would I start to look for the leak? Is there a big hose or a small hose that would cause this? I used the same intake manifold gasket but it still look good. I dont hear any whisteling anywhere

  • musclecarman Jun 24, 2009

    ok I will go grab so cleaner from the store and try it....I will let you know if that works.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 72 Answers

It sounds like a serious vacuum leak.

Posted on Jun 24, 2009

  • pwasas Jun 24, 2009

    It's best to replace the gasket, if there is just a little tear it will cause a leak. Spray some intake cleaner or carb cleaner around the intake and vacuum hose area to see if there is a change. that's a good way to find a leak. Or a hose could have been left off.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1991 s10 falls on it face when i give it gas replaced tps temp cap rotor plugs and wires


Fuel delivery problem, or bad vacuum leak at gaskets, or vacuum hoses causing terrible fuel-air mixture. You will need a repair manual to be able to read codes and understand the ECU error codes, but it may help you understand the issues.

Apr 14, 2015 | Cars & Trucks

1 Answer

1999 bmw 316i compact flat spots & hesitation from 3500 RPM


the flat spot is a missing instruction in the CPU program in the ECM. Run the fault codes to check for faulty sensors or have the CPU program reset using the scanner. Loose wires would give a problem all over and not just at particular rpms

Dec 24, 2014 | BMW Cars & Trucks

1 Answer

My 94 nissan sentra doesn't run smooth over 3000 rpm or if you mash the gas pedal


I have a 2000 Chevy Tahoe that did the same thing. I changed the oil pump, new oil, and head gasket. It now has power and doesn't fall on its face when I step into the throttle hard. Hope this helps.

Apr 21, 2014 | 1994 Nissan Sentra 4-Door

3 Answers

Low rpm at idel


Sounds like there is a vacuum leak. I's there a check engine light on? If so is there any lean codes?

Jul 13, 2013 | 2003 Ford Taurus

1 Answer

When giving my 1995 GMC Sierra gas when the light goes green it falls plum on its face like its overloaded with fuel but feather the gas pedal it clears up and runs fine anyone have any ideas. Done...


Have the fault codes read. Replace the faulty units with
genuine one because most aftermarket units are not set for OEM cpu units and are not completely compatible.. Check for mass air flow sensor fault.

May 11, 2013 | Cars & Trucks

2 Answers

1990 BMW 525i stalling, ruff idel.


Your fuel injectors maybe clogged up,have them cleaned.

Apr 25, 2017 | Cars & Trucks

1 Answer

When i start it for the first time everyday it idels ruff and when i give it gas it just falls flat on its face. its like it only gets enough fuel for an idel even though the gas pedal is on the floor. but...


Try changing the pickup coil in the distributor? This one had a lot of mechanics baffled, the guy at Auto Zone nailed it on the head. Cheap fix if that is it. Always overlooked

Nov 26, 2010 | 1992 Chevrolet C1500

3 Answers

Engine wont go over 3000 rpm while driving


Is the check engine light on? If so check what codes are stored. It sounds like the m a p sensor.
Good luck dont forget to rate.

Mar 08, 2009 | 2000 Chevrolet 3500

Not finding what you are looking for?
1991 Acura Integra Hatchback Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...