- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Hi, determine if your car uses R134 or R12 refrigerant. You will notice screw type connectors on the both the High Pressure Side and Low Pressure Side lines in models using R12 refrigerant. R134 compatible models have quick connect valves on both sides. Models made before 1995 may use the old R12 refrigerant. If this is the case, you must have your Chrysler's air conditioning system retrofitted to use R134 refrigerant. Mixing R12 and R134 refrigerants is dangerous and may cause damage to your vehicle.
Check your air conditioning system pressure using an automotive air conditioning pressure gauge. Keep in mind that in order to get an accurate reading, the air conditioner has be turned on the coldest setting with maximum blowing power.
Remove the Low Pressure Side port valve cap and set it aside. The location of the port varies, but it is usually in front of the engine block. Attach the refill hose to the port on the Low Pressure Side of the air conditioning system. The Low Pressure Side port is smaller the High Pressure Side port. Because the ports are different sizes, the refill kit hose should fit only on the Low Pressure Side port. Additionally, the High Pressure Side port will usually have a red cap or be marked with an H or the word High
Allow the air conditioner to **** the refrigerant out of the can by slowly turning the valve on the refill kit hose. Pay attention to the way you hold the can. Most kits will have you hold the can upright when you recharge the air conditioning system. It may take as long as 10 minutes to empty a single can.
Turn the valve to the off position and remove the refill hose from the port. Recap the port before closing the hood.
Let the air conditioner stay on for at least 30 minutes. This allows the refrigerant to move throughout the entire system.
it is on low pressure line the easy way is to find the low pressure line going to the evapater coil in dash from the compresser the other high presser line will be going to the condenser in front of the radiator.hope this helps
under the hood there is two a/c valves, one says H for high side and one says L for low side... hook up to the low side and turn the a/c on max with the car running and then charge. you really need a pressure gauge to know how much to put in. too much freon will make it blow hot also, you need the right amount of pressures, just go slow filling it up and keep checking the a.c temp out of the vents.
the low pressure valve is the longer skinnier one. The low pressure valve should be on the fatter of the hoses in the engine compatrtment. Try close to the compressor. if you stil cannot locate it i can check my service manuals or the exact location.
Newer vehicle come with R134 vs R12. Since the two are not compatible, R134 has larger fittings. AC system has two ports, High and Low. Low is return to AC Compressor and high is output. High port is first following line from compressor to condenser (condenser is at front of vehicle like a second radiator). Keep following line till you find high port (paint cap red). Second port is low (paint cap blue).