Question about 1999 Cadillac DeVille

1 Answer

Yes i have juice to the blower motor, but it dont blow all fuses are good, freon is good

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 718 Answers

Cadillac 1999 DeVille
If the front blower motor is not running with battery level power to it, you may have bad blower resistors which controls the speed of the motor.. Unfortunately the resistors are built-in the motor. You may have to replace the motor. If you remove the motor, you can recheck it by direct wiring power to it. OR you may have loose wires.
Also check the Heater and A/C Programmer module.

Here's some info I found from another posting.

Red is positive 12 volts coming from fuse of circuit breaker. The black wire is either the ground or the main hot wire going to the blower motor (3 pin connection only), and the gray wire (if is is small in size) is a variable voltage coming from the body control module requesting speed for the blower motor.The blower control module varies voltage on the main wire going to the blower motor, supposedly in accordance with the requested voltage from the body control module. Usually if all fuses are okay and present on the apprpriate wire of the blower control module, the a blower motor that will not run or stays running after the key is turned off is the fault of the blower control module. If the blower control module has failed the the cause must be determined (over amping blower motor) or else new blower control module may fail when powered up.Usually blower control modules have more than three wires. Usual connections are: B+ (battery voltage) GND (chassis or engine ground), two large wires going directly to blower motor (can be any color, but are usually 10 guage in size), and an optional wire that reports voltage level back to the body control module.

Posted on Jun 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On my vauxhall vivaro van, the fan heater isn't very good and when I turn it to number 4 it blows the fuse, the fuse is a 32amp how do I can the fan motor??


Usually on cars there is a blower motor resistor that changes the amount of amperage to the fan motor. If that is fried or shorted out than you could be receiving too much juice and piping your fuse. Either way there is some kind of short.

Mar 28, 2013 | Cars & Trucks

1 Answer

Installed new blower motor. bearing shelled in old one. new motor won't blow. tested . it's good don't have power to moter. fuses good relay good. isthere a circuit breaker in wiring for b


I don't have a diagram for a 2008. On 2005 models the blower motor relay gets power from a 30amp fuse.
When the blower switch is in the high position the resistor is bypassed and power flows directly to the motor. The motor is grounded to the car.
The fan relay also gets power from a 7.5amp fuse and is controlled by the HVAC control on the dash.
Do you have power into and out of the relay?

Feb 25, 2013 | 2008 Mitsubishi Lancer

1 Answer

05' chevy impala ac problem


my A/C fuse keeps blowing out every time i put a new one.. It blows it about 15 minutes after the new one.. What can cause this?

May 25, 2012 | 2005 Chevrolet Impala

1 Answer

1992 323 mazda want blow heat out


REPLACE THERMOSTAT.IF ALREADY DONE.CHECK HEATER BLOWER MOTOR SEE IF POWER GOING TO HEATER BLOWER MOTOR.IF YES BLOWER MOTOR BAD.IF NO POWER GOING TO BLOWER MOTOR CHECK AC AND HEATER CONTROL FUSE AND CHECK BLOWER MOTOR FUSE AND RELAY IF ALL IS GOOD CHECK SEE IF POWER GOING TO AC AND HEATER CONTROL SWITCH IF YES THE AC AND HEATER CONTROL SWITCH COULD BE BAD.

Nov 10, 2011 | 1991 Mazda 323

1 Answer

My heat or air is not blowing out. But settings are working. Is there a fuse for blower, and where is it located?


Yes cehck the fuse box for blower motor fuse, if they are good then take the blower motor out and power it, if it works then change the blower motor resistor.

Sep 16, 2011 | 2003 GMC Envoy

2 Answers

The heater fan is not working. Is it a fuse?


fuses are the easy thing to check just pull one and look at it if you see a burned spot replace it, checking relays and blower motor resesters and blower motors are harder if you dont know how to do it. there best left to a shop to check.

Dec 16, 2010 | 1999 Plymouth Voyager

1 Answer

The blower fuse on my 2005 Kia Amanti has blown after only two weeks. Could a faulty blower replay be the problem


well first check the relay, and make sure power is going to blower motor., if it is then the blower motor may be bad and drawing to much juice and shorting it out enough to blow the fuse or relay. good luck!!

Apr 23, 2010 | 2005 Kia Amanti

2 Answers

Air conditioning and blowers not working, fuse blows immediatley after changing. there was a clicking noise heard before fuse blew. No display on dash unit. (2000 passat 1.9TDi Sport)


Try unplugging the blower resistor, located under the passenger side, under dash area, put a new fuse in and see if the fuse opens (blows). If it does not blow then unplug the blower located in roughly the same are and plug the resistor back in if it blows then it the resistor if not it's most likely the blower motor.
If the fuse blows when both resistor and the motor is unplugged the you need to unplug the a/c head unit and see if it still blows(open fuse)
Hope this helps

Mar 17, 2010 | Volkswagen Passat Cars & Trucks

1 Answer

Replaced blower motor, but still blowing fuse,


could be AC compressor clutch shorting out.try disconnecting AC compressor electrical connector and see if fuse still blows.

Dec 06, 2009 | 2001 Chevrolet Tracker

Not finding what you are looking for?
1999 Cadillac DeVille Logo

807 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...