Mazda lantis 1993

Hey Harry,
Sounds like you may have installed/mis-aligned/forgot/incorrectly installed something.. you need to get someone(a qualified pro) to look at your work.. Did you make sure the sliders were clean and had a little anti seize/hi-temp grease on them and the o-rings?
Did you tighten the lug nuts while the tires were OFF the ground..IF NOT.. jack up the car.. loosen all the lugs and re tighten the lug nuts in a criss-cross pattern..BEFORE you put them back on the ground!!
Please get someone to look at it before you drive it anymore.

Hi Heiko:
I Googled your question. Here is the link that contains the results.
Hoefully you will find your answer.
https://www.google.ca/#q=firing+order+in+a+1993+mazda+lantis+2+litre+v6+engine
Cheers

Hi Dave:
On many engines, the thermostat is on the engine, under the fitting that is connected to the hose that comes from the top of the radiator. Undo the 2 bolts that secure it to get to the thermostat.

u need a shop manual--buy a haynes or librarysec629--if u put car in gear and push it while someone else looks at the distributer rotor-ull see it turn--chec the web out for masda details or go to magicmechanic and send him the question

dry the distributor with some hair gum with carefully. and the wires dry it very well+spark plug, and any parts that was exposed to the water. see the diagram and dry every part.
God bless you

buy a haynes workshop manual ,not enough upload capacity on this site to put anything like this on here

7 flashes usually means passenger seat airbag problem. Try jiggling the sensor connectors under the seat.

It could be the brake light switch that is bad. that is located under the dash behind the pedal, the pedal presses the switch and turns the brake lights on.

some ford cars use mazda parts probe etc