Question about 2005 Chevrolet Colorado

1 Answer

The AC wire connection is burnt out. If I replace the wire, how much labor is involved? It goes from under the dash to inside the dash.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 508 Answers

Depends on your expertise could take 15min to 3 hrs be careful to not disturb anything ele wiring wise!!!you also haft to find out why wire burnt could be ac clutch or to big of fuse? Good Luck!!!

Posted on Jun 24, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have changed the cabin air filter in my truck, and the ac still doesnt blow that hard, blows cold just not hard


Hello: Check the wires at the blower motor and also check the module wires connector (6 wires) if any are burnt or the module is burnt replace all the burnt items. These components are under the passenger side of the dash.

Aug 03, 2011 | GMC Sierra 1500 Cars & Trucks

2 Answers

My 2004 Dodge Stratus a/c blows air from the front window defogger vents, not from the ac vents, causing the window to fog up. It switches intermittently from each sometimes, too.


It sounds like you blew your 'hvac' fuse which should be located under the dash on the drivers side, just pull the cover off the fuse panel and on the backside of the cover it should say which fuse is which and when you pull out the fuse if you look at the side of the fuse there is a metal wire that runs through the fuse and if that wire is burnt then the fuse is bad. And if the fuse is not there then it is in the instrument/fuse panel under the hood. hopefully this works for you

Apr 29, 2011 | 2004 Dodge Stratus

1 Answer

Bought a used 1998 chevy suburban yesterday and found that the reason the dome lights cig lighters etc and the power windows dont work is because someone put aftermarket electronics in and did a shoddy job...


I would try to repair the wiring that is damaged with similar gauge wire, solder and use heat shirk tubing. Trying to replace the entire harness would be rather involved. I would remove all the aftermarket electronics.

Oct 18, 2010 | 1998 Chevrolet Suburban

1 Answer

Removal of truck radio


There are two, if it's 1/4 inch round it goes to the antena if it's a single black wire connected by itself in the middle radio it's the ground and connects to the chassis. All other wires run into the connecter and feed speakers and has the power to it.

Jul 04, 2010 | 1988 Chevrolet K1500

1 Answer

Where is the evaporator core at? and how much


The evap core is located inside the heater/ac box which unfortunately is under the dash board.

The core itself is not too pricey, say under $200. The lions share of the bill is labor to remove the dash, evacuate the A/C system, and then reinstall them in reverse order.

Depending on vehicle, bill could be as much as $1500, but more likely $500-$1000.

May 20, 2010 | 2004 Mitsubishi Galant

1 Answer

1988 ford f 250, ignition issue. i went out to


replace the ignition switch (actuator) it is worn inside, i had the same problem awhile back I replaced it had no more problems, the contacts get burnt at that point and works now and then, so that should take care of the problem

Mar 25, 2017 | 1988 Ford F 250

1 Answer

How do I control the ac/heater "under the hood" near firewall? The ac/heat do not switch out when knob turned. Had broken knob and cable replaced but problem lies deeper. Was told you can do this manually...


the ac/ heater controls is inside ur instrument panel/ u need to remove the instrument panel to give u access to check whats wrong with ur controls and u need set of tools to do that and be careful when removing panel boards as it easily breaks....

Apr 07, 2010 | 1995 Honda Accord

2 Answers

Blower for hvac will not work?


For an '06 H3: If the fuse is okay (in the underhood fuse block), pull out the HVAC blower resistor and check it for burnt connections. It's located right under the glove box in the air plenum, easily accessed, and has a red male 6pin(?) plug in it. Mine had a burnt terminal that fused the two together. I went to the Hummer Dealer, and bought the replacement resistor and wiring harness. Parts are #10397098 (resistor) @ $37.74 and #25867517 (harness) @ $32.90. Both were easily replaced for a total of $70.64 plus tax. Save yourself $106 per hour labor and do it yourself. Easy fix.

Jul 14, 2009 | 2006 Hummer H3

1 Answer

Our fan/ac will only blow on occassion and sometimes won't blow at all and then sometimes come on all of a sudden.


check the connections at the blower motor and blower resistor under the right sie of the dash. If the connections look green or burnt replace the resistor connector

Jul 02, 2009 | 2004 GMC Envoy

3 Answers

Radiator fan on my 1994 toyota camry


there are actually 3 temp sensors. 1 is on the top of the engine that goes to temp gauge in dash has 1 wire. next to it is a 3 wire sensor for engine control and choke. on the bottom of the radiator next to the hose is a 2 wire sensor. loosen all 3 but leave connected. get engine hot past halfway point on dash gauge. with ac off disconnect 1 sensor at time. start with 2 wire under radiator. it takes the most abuse. fan will come on when you disconnect broken sensor. 2sensor must agree for fan to stay on till engine cools when turned off. note this is solution i used after verifying fuses, fuseable links and relays worked.WOO HOO! make sure you check both the fuse box under hood and fuse boxleft side of steering wheel my ECU fuse was inside my bros was outside.ECU B on my car goes to nothing and is under hood. Had it confused with ECU on wiring diagram.DOH!

Jan 18, 2009 | 1994 Toyota Camry

Not finding what you are looking for?
2005 Chevrolet Colorado Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...