Question about 1981 Toyota Corona

1 Answer

Why did my 1993 toyota corona wont start after it stopped going while i was driving

I was driving 100km and the motor stopped going but lights ect still work. now the car wont turnover not evan after we tried tow starting it. the motor is not seized we have put a new battery in it and it still wont turn over.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    Visited the website for 3 consecutive days.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 157 Answers


Posted on May 18, 2014


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: rav 4 2008

Electronic throttle control motor may have failed.

Posted on Sep 12, 2008

  • 112 Answers

SOURCE: 1993 toyota camry 4 cylinder will not start

Pull off a spark plug... VERY CAREFULLY have someone watch the plug as you try and start the car, DO NOT touch it while turning key, just look for a spark...

Posted on Oct 03, 2008

  • 6982 Answers

SOURCE: driving and car died and now wont start it has power and turns over just wont start

You need to isolate the problem. If it starts when you spray carb cleaner into the throttle body while cranking then problem is in fuel system.(pump, pump relay, filter or fuse) If not, then look into ignition system. Use any manual to get specific testing instructions and do not buy anything till you verify by testing that you really need that part or it can get unnecessarily expensive.
If you need more info on anything, just ask, but at the point you are at, careful testing will tell you far more than anyone here can tell you.

Posted on May 22, 2009

  • 784 Answers

SOURCE: 2002 Toyota Corolla S. Replaced battery this

Look for a lose connection at the crank shaft sensor. This is a signal needed for obtaining tachometer as well as turning on the fuel pump.

Posted on Oct 14, 2009

  • 10 Answers

SOURCE: central locking from my 95 toyota celica key fob


Posted on Apr 09, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Hi I have a 1993 toyota lexcen starts and drives fine then I turn left it stalls on me and after leaving it 4 a few minutes it starts again please help

What's up with that is a harness lose a motor mount
broke and when the engine lifts up while Turing and pulls on harness check all plugs and mounts.wierd problem always fun to find good luck

Feb 14, 2015 | Toyota Cars & Trucks

1 Answer

My 1993 Toyota 4 runner 2wd wont work but my 4wd does .. in 2wd the drive or reverse wont go but will in 4wd

Hi do check gear linkages or cable adjustments.otherwise possible gearbox malfunction.

Jan 05, 2015 | 1993 Toyota 4Runner

1 Answer

I have a 1993 Toyota AE 100 Auto. The automatic gears does not engage after covering a distance of 100km and over at an average speed of 80Km/hrs. When stopped and started again, it engages for a distance...

Hello and welcome to FixYa!
As a first course of action, I strongly suggest that you replace the transmission fluid and filter. If it's burnt, issues like this occurs. It can be a bad TCM (transmission control module) too, have it checked and replaced if necessary.
Hope this helps and thank you for using FixYa! Have a good one!

May 04, 2011 | 1992 Toyota Corolla

1 Answer

Was driving my 1999 toyota camery home and it just cut out , lights ect still work , will turn over but wont start

Stop trying to start it. Have someone turn the the engine over, while you look inside the valve cover through the oil filler. W/ flashlight see if rocker arms are moving if not timing belt is broken.

Jun 06, 2009 | 1993 Toyota Camry V6

2 Answers

90 toyota 4 runner over rev'ing

is your ECT Power switched on this causes higher revs

May 27, 2009 | 1991 Toyota 4Runner

1 Answer

Starting Toyota Estima Lucida

There are various things this could be ie inhibitor switch on auto box relays wiring fault or ignition barrel problems try putting the starting the car in N instead of P and wiggle gear lever about other option bypass everything and connect a live feed straight to starter motor cranking wire which is located on the starter motor, if car still wont turn over tap starter motor with a hammer, if hammer trick works then you need a new starter

Jan 28, 2009 | 1993 Toyota Previa

1 Answer

90 toyota 4 runner over rev'ing

Go ahead, get the TPS close, we'll final adjust it later.

Oct 15, 2008 | 1991 Toyota 4Runner

Not finding what you are looking for?
1981 Toyota Corona Logo

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides