Question about 1997 Chrysler Town & Country

Open Question

Fuel system buzzer location on a 1997 town and country

Don't work

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

garyq1970
  • 73 Answers

SOURCE: changing fuel filter on 2004 chrysler town and country

  1. Remove or disconnect the following:
    • Negative battery cable
  2. Raise the vehicle and support the fuel tank with a transmission jack.
    • Fuel line from the front of the tank
    • Ground strap
    • Inboard side of the fuel tank straps and front T strap fastener and lower the tank about 6 inches
    • Fuel lines from the fuel pump module
    • Fuel filter
  3. Installation is the reverse of removal. Tighten the fuel filter bolts to 40 inch lbs. (4.5 Nm), the main tank straps to 40 ft. lbs. (54 Nm) and the T strap to 250 inch lbs. (28 Nm).
  4. Start the engine and check for leaks.

Posted on Aug 24, 2008

short shadey
  • 421 Answers

SOURCE: location of the speed sensor on 1996 town & country

they are on the front drivers side of the transmisson and have two wires coming off them, there are two one is an input shaft sensor and the other is an output shaft sensor unless you have a 4 cyl van then there is only one sensor please rate -jeff

Posted on Sep 04, 2008

  • 2 Answers

SOURCE: locating fuel filter 1996 Town & Country 3.8

they say its on the right hand side slighty above the gas tank by the sending unit might have to remove the one strap

Posted on Jan 23, 2009

emissionwiz
  • 75051 Answers

SOURCE: where is the body control module located on a 1997 town & country

It is located on the back side of the underdash fuse box (junction block). You remove the lower steering column cover and knee blocker reinforcement. Then remove two plugs from the bottom of the BCM.
Remove the bolts holding the junction block to dash panel mounting bracket. Remove the junction block from the bracket. Remove screws holding the BCM to the junction block. Slide the BCM downward to disengage guide studs on jb from channels on BCM mounting bracket

Posted on Mar 23, 2009

  • 1986 Answers

SOURCE: need the location of the fuel filter fora 1996

It will either be inside the gas tank (real pain) or it'll be in front of the gas tank recessed into the frame.

Posted on Aug 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace the fuel filter on a Chrysler 1997 town and country 3.8 lxi


  • Relieve the fuel system pressure by removing the fuel pump relay from the power distribution center. Start the engine and allow it to run until it stalls. Try to start it again and let it run until it stalls. Repeat this procedure until it no longer will start. Turn the ignition off.
  • Disconnect the negative battery cable and raise the vehicle. Support the fuel tank with a transmission jack. Locate the fuel filter on the top of your Chrysler Town & Country fuel tank.
  • Remove the fuel line from the front of the tank and then the ground strap. Next, remove the inboard side of the fuel tank straps and front T-strap fastener. Lower the tank about 6 inches.
  • Detach the fuel lines from the fuel pump module and then remove the fuel filter. Put the new filter in its place. Tighten the fuel filter bolts to 40 inch pounds.
  • Reconnect the fuel lines to the fuel pump module and reposition the tank. Replace the front T strap fastener and tighten it to 250 inch pounds. Put the inboard fuel tank straps back and tighten them to 40 foot pounds.
  • Put on the ground strap and connect the fuel line in the front of the tank. Start the engine of your Town & Country and check for leaks.


  • Read more :

    Nov 09, 2015 | Chrysler Cars & Trucks

    1 Answer

    1997 chrysler town and country alarm a 1997 chrysler town and country alarm systemhow do I disconnect a 1997 chrysler town and country alarm system


    You can't. You can't . you can't ... Have the codes read and find the problem. Fix it. Could be just a bad key.

    Feb 19, 2015 | Chrysler Cars & Trucks

    2 Answers

    Just had a front rotor on my 1997 chrysler town and country mini van replaced and now the abs light comes on randomly. does that mean that the abs system is broken? or did the person changing the rotor do...


    Most likely sloppy work & disturbed the wiring to ABS Sensor

    There is no excuse for that

    Shops do not road test before or after work, & don't
    make good use of there scan tools

    Stay away from the big name franchises

    Jul 18, 2012 | 1997 Chrysler Town & Country

    1 Answer

    I have 1997 town country it starts then stops can re start then stalls again and again


    sounds like a fuel pump thats starting to go out. Sorry would need more information for a more precise diagnostic. Most likely a fuel delivery issue

    Mar 29, 2012 | 1997 Chrysler Town & Country

    2 Answers

    Van will not start . It will not turn over when I try to start it. It is like it is not getting any gas.


    1997 town and country alarm is shuting van down how do i disconnect it???????????

    May 08, 2010 | 1997 Chrysler Town & Country

    1 Answer

    Trying to locate the fuel filter for a 1996 Chrysler Town and Country van


    1996 Chrysler Truck Town & Country 4WD 3.8L MFI 6cyl
    The Fuel Filter is located under vehicle, driver side, below seating area, front of fuel tank, mounted on frame rail in fuel line.

    Hope help with this (remember rated this).

    Mar 13, 2010 | 1996 Chrysler Town & Country

    1 Answer

    Where is rear blower motor located on a 1997 Town


    It is behind the right rear quarter trim panel in the heater housing.

    Apr 25, 2009 | 2000 Chrysler Town & Country

    1 Answer

    Cranks but won't start


    Check to see if you have a humming sound for a few seconds when you put the key in "on" position. If not, check the fuel pump relay. Just swap it out with one that looks the same. The A/C relay is the same. If it starts, replace the relay. If you replace the relay and it still doesn't start. most likely the fuel pump module has failed. The fuel pump module is located insde the fuel tank.

    Aug 26, 2008 | 1997 Chrysler Town & Country

    3 Answers

    2001 Chrysler Town & Country mini-van stalling at all speeds


    2001 Chrysler Town and Country- Won't start. Turn over. It acts like the fuel is not getting to the engine. After many attempts , it starts and runs like there are no problems. The car has 120,000 and has never had a problem. Is the fule pump bad?

    Jun 21, 2008 | 2001 Chrysler Town & Country

    Not finding what you are looking for?
    1997 Chrysler Town & Country Logo

    Related Topics:

    12 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chrysler Experts

    yadayada
    yadayada

    Level 3 Expert

    75005 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    7710 Answers

    Are you a Chrysler Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...