Question about Buick Skylark

Open Question

Need engine diagram for 1994 buick skylark

Need to know where the hoses go from the heater core to the engine

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
playon186
  • 45 Answers

SOURCE: how to replace a heater core out of 97 buick skylark

There is a free way to find out where it is which is what you'll have to do first, go to any parts place which should have a diagram or they can just tell you over the phone. i will tell you this, hope that it's on the passenger side because if it's on the driver side you will need to pull the dash to get to it. If it's on the passenger side like the blower motor you can just drop the glove box door down to get to it. It looks like a little box woth two or three small hoses or pipes going to it which are failrly easy to disconnect. Hope this helped, good luck!

Posted on Nov 04, 2008

Ad
proJekttaLon
  • 91 Answers

SOURCE: 1994 buick lesabre heater core removal

The heater core is located under the dash, in the center. The container holding the core looks like a black plastic box. Remove the ash tray for easier access. You may have to also remove some other covers under the dash. You must first drain the radiator then you have to disconnect the hoses. There are two hoses connected to nipples of the heater core that go thru the center of the firewall. Remove the screws that hold on the cover to the heater core. Then you should be able to get the old one out. There might be a couple of other minor steps but I'm sure you can figure them out. For re-installation just go in reverse order to put it all back together.

Posted on May 25, 2009

techbuster
  • 5081 Answers

SOURCE: How to replace heater core on 1997 Buick Skylark

You will need a piece of pipe about 2" to 3"long that will fit inside the diameter of the two heater hoses at the firewall and two hose clamps. (1)disconnect the two hoses at the firewall; (2)slip a clamp on each hose; (3)slip the piece of pipe into both hose ends to connect the two hoses together; (4)install and tighten clamps on each end of hoses over pipe. (You might want to put a little grease on the pipe for easier removal when you are ready to install new core.) Start engine and check for leaks at the connections.

Posted on Nov 06, 2009

capsman
  • 111 Answers

SOURCE: removal of heater core 1992 buick skylark

You locate the heater core by following the heater hoses in the engine compartment. These hoses need to be disconnected. Then, working inside the passenger compartment, take off all of the control panel. You'll see screws underneath if you lie on your back. The only trick is to pop out the vent louvers -- just pop them out with a screw driver. There are screws behind them. Take out the glove box. Take off the heater outlet duct and the heater core cover. Pull the heater core straight back to avoid breaking the drain tube. Remove some clamps and that's it.

Posted on Jan 01, 2010

  • 5 Answers

SOURCE: how do you replace heater core on 1993 buick

it could be the electronic switch down under the dash that is faulty, not allowing the flap to close off and cycle the water through the heater core..

Posted on Feb 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My radiator started leaking and my mechanic said that he replaced the heater coil. What is a heater coil and would it cause my radiator to leak?


Your heater coil is most often located in your vehicle's firewall. To find it, locate your water pump on your engine block and follow the water hoses back to the firewall. Where these hoses end you will find your heater core. To answer your question, no, your heater coil will not cause your radiator to leak. They are two separate units.

Aug 31, 2011 | 1994 Buick Skylark

1 Answer

I need to find both heater hoses top and bottom so i can bypass the heater core for my 95 buick skylark


YOUR LOOP WILL BE MADE WHERE BOTH HOSES GO INTO THE FIRE WALL TO HEATER CORE.YOU NEED A LONGER WATER HOSE I WOULD DO THIS FIX TO GET YOU HOME.

Jan 07, 2011 | 1995 Buick Skylark

1 Answer

Does dash assy need to be removed to install heater core in a 1992 buick skylark


No the dash panel does not have to come out.You will have to remove the console if equipt.You will also have to jack the vehicle up and disconnect the heater hoses from the heater core.Let me know if you have anymore questions.Good luck.

Dec 03, 2010 | 1992 Buick Skylark

1 Answer

Replace heater core 1997 buick skylark


You will need a piece of pipe about 2" to 3"long that will fit inside the diameter of the two heater hoses at the firewall and two hose clamps.
  1. Disconnect the two hoses at the firewall;
  2. Slip a clamp on each hose;
  3. Slip the piece of pipe into both hose ends to connect the two hoses together;
  4. Install and tighten clamps on each end of hoses over pipe. (You might want to put a little grease on the pipe for easier removal when you are ready to install new core.Start engine and check for leaks at the connections.
You can check a satisfied customer ratedthis solution before inthe below link
http://www.fixya.com/cars/t3366947-replace_heater_core_1997_buick_skylark

Feb 02, 2010 | 1997 Buick Skylark

1 Answer

Removal of heater core 1992 buick skylark


You locate the heater core by following the heater hoses in the engine compartment. These hoses need to be disconnected. Then, working inside the passenger compartment, take off all of the control panel. You'll see screws underneath if you lie on your back. The only trick is to pop out the vent louvers -- just pop them out with a screw driver. There are screws behind them. Take out the glove box. Take off the heater outlet duct and the heater core cover. Pull the heater core straight back to avoid breaking the drain tube. Remove some clamps and that's it.

Dec 31, 2009 | 1992 Buick Skylark

1 Answer

How to replace heater core on 1997 Buick Skylark


You will need a piece of pipe about 2" to 3"long that will fit inside the diameter of the two heater hoses at the firewall and two hose clamps. (1)disconnect the two hoses at the firewall; (2)slip a clamp on each hose; (3)slip the piece of pipe into both hose ends to connect the two hoses together; (4)install and tighten clamps on each end of hoses over pipe. (You might want to put a little grease on the pipe for easier removal when you are ready to install new core.) Start engine and check for leaks at the connections.

Nov 06, 2009 | 1997 Buick Skylark

1 Answer

How to repair heater core


The step by step procedure to remove the heater core is given below :
  1. Disconnect the negative battery cable.
  2. Drain the engine coolant into a clean container for reuse.
  3. Raise and safely support the vehicle.
  4. Remove the rear lateral transaxle strut mount, if necessary.
  5. Remove the drain tube and disconnect the heater hoses from the core tubes, lower the vehicle.
  6. Remove the sound insulators, console extensions and/or steering column filler, as required.
  7. Remove the floor console outlet ductwork and hoses.
  8. Remove the heater core cover.
  9. Remove the heater core mounting clamps and remove the heater core.

Sep 27, 2009 | 1994 Buick Skylark

1 Answer

Need to locate access panel to replace HeaterCore 1990 Buick Skyl


  1. Disconnect the negative battery cable.
  2. Drain and recycle the engine coolant.
  3. Raise and safely support the front of the vehicle.
  4. If necessary, remove the rear lateral transaxle strut mount.
  5. Detach the drain tube, then disconnect the heater hoses from the core tubes.
  6. Carefully lower the vehicle.
  7. Remove the console if equipped.
  8. Unfasten and remove the sound insulators, console extensions and/or steering column filler, as required.
0900c152800a93fc.jpgFig. 1: Unfasten the sound insulator retaining bolts ... 0900c152800a93fd.jpgFig. 2: ... then remove the sound insulator
  1. On some models it may be necessary to remove the steering column opening filler.
  2. Remove the floor or console outlet ductwork and hoses.
  3. Remove the heater core access cover.
0900c152800a93fe.jpgFig. 3: Remove the heater core access cover
  1. Unfasten the heater core mounting clamps/bolts, then extract the heater core from the vehicle.
0900c152800a93ff.jpgFig. 4: Unfasten the heater core retaining bolts; most later models are secured with clamps 0900c152800a9400.jpgFig. 5: Remove the heater core from the vehicleTo install:
  1. Install the heater core, then secure using the clamps/bolts.
  2. Fasten the heater core cover.
  3. Connect the outlet hoses and ducts.
  4. Install the sound insulators, console extensions and/or steering column filler.
  5. Raise and safely support the vehicle.
  6. Install the drain tube and connect the heater hoses to the core tubes.
  7. If removed, install the rear lateral transaxle strut mount, if removed.
  8. Carefully lower the vehicle.
  9. Connect the negative battery cable.
  10. Fill cooling system and check for leaks. Start the engine and allow to come to normal operating temperature. Recheck for leaks and check coolant

Dec 06, 2008 | 1990 Buick Skylark

1 Answer

Heater core


Pull the panel under the glove box. You should be able to see the heater core. disconnect the two hoses under the hood on the firewall to the heater core. put a pan below to catch the antifreeze. Replace heater core. reconnect hoses.

Nov 15, 2008 | 1990 Buick Skylark

1 Answer

Heater core leek


it is behind the plastic venting under the dash it has to be removed to get to the heater core

May 19, 2008 | 1986 Buick Skylark

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...