Question about 2003 BMW 530i

1 Answer

Bmw 2002 530i code p1747 - 2003 BMW 530i

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • BMW Master
  • 7,515 Answers

For the best solution of your problem visit this site
BMW 5 Series 1982 2007 Factory service repair manual

Posted on Apr 23, 2016


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Error codes PO600 and P1747

P1747 CAN-Bus Monitoring
P0600 Serial Communication Link
These codes indicate a communications failure between the transmission control unit and ABS/traction system. These modules share information which allow them to operate properly. It is likely that one of the modules has an internal fault.
With these generic codes it is not possible to determine the exact nature of the issue. Your best bet is going to be a dealer diagnosis using their sophisticated equipment so that the root cause can be determined and eliminate any guess work. The p codes are too generic in this case, unfortunately.

Jun 03, 2016 | 2001 BMW X5 4.4

1 Answer

I have p1747 code will that lite up the red light top right corner of my dash on a 2000 crown viv police intercepter

That is a transmission code...

P1747 (EPC Shift Solenoid). Not uncommon for police interceptors...

Here is a discussion of other possible causes:

May 13, 2015 | Cars & Trucks

1 Answer


transmission fault. CAN-BUS monitoring.

May 01, 2014 | 2003 BMW 5 Series

2 Answers

Got a code p1747 what could be the problem for this code

P1747 refers to a transmission issue. The PCM has detected a malfunction within the EPC (Electronic Pressure Circuit) circuit. You may notice that the engine goes into limp mode or you start to notice a harsh shift point. If you need more information just let me know. Please be specific. The more you write, the better and faster I may help you solve this problem, good luck.

Feb 18, 2014 | 1995 Dodge Caravan

1 Answer

Codes p1747 and p0500

The 500 code is vehicle speed sensor,the other is spooky BUS system failure ECM?EGS controller. The 500 is probably your shift problem. Hopefully the other is a ghost.Seems you should be able to manually shift and get low gear

Feb 03, 2014 | Cars & Trucks

1 Answer

P1747 code

P1747 Pressure Control Solenoid "A" Short Circuit
P0500 Vehicle Speed Sensor
maxidas ds708

Feb 28, 2013 | 1997 Mercedes-Benz E-Class

1 Answer


Controls the shift points. Replace the EPC. Its on the transmission.

Oct 15, 2012 | 1998 Ford Explorer

1 Answer

I have a 2003 ford E350 5.4L with trouble codes p1747 and p1760 , what could be causing this ?

A/T EPC (pressure control soleniod) Solenoid Circuit Malfunction
A/T EPC Solenoid Circuit Malfunction
I would think that the solenoid has failed.

May 18, 2012 | Cars & Trucks

1 Answer


Generallry, codes P1746 and P1747 are both related to the EPC electrical circuits. These codes are only generted by and electrical fault. Inspect the wiring connector at the transmission. You may have have to use a mirror to inpsect the connector on the transmission itself. Disconnect both the transmission connector and the pcm connector and check the white/yellow wire (pin 11 at trans connector and pin 81 and PCM) check this wire for an open circuit, shorts to power or ground.
If the wiring checks ok the PCM driver for the epc has failed and the PCM will need to be replaced.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Mar 29, 2012 | 2000 Ford Expedition

1 Answer

I have a P1747 code... sluggish transmission

Code definition is Electronic Pressure Control (EPC) Solenoid. This solenoid is located in the trans pan. Driving the explorer without getting it fixed could also wear down other parts in your transmission!

Jul 29, 2009 | Ford Explorer Cars & Trucks

Not finding what you are looking for?
2003 BMW 530i Logo

Related Topics:

127 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers


Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides