Question about 1980 Mercedes-Benz 280 SLC
Posted by Anonymous on
Tips for a great answer:
Excessive belt tension will cause damage to the alternator and water pump pulley bearings, while, on the other hand, loose belt tension will produce slip and premature wear on the belt. Therefore, be sure to adjust the belt tension to the proper level.
To adjust the tension on a drive belt, loosen the adjusting bolt or fixing bolt locknut on the alternator, alternator bracket or tension pulley. Then move the alternator or turn the adjusting bolt to adjust belt tension. Once the desired value is reached, secure the bolt or locknut and recheck tension.
Fig. . . . then remove the alternator belt from the engine
Fig. . . . then remove the power steering belt from the engine
Fig. Accessory V-belt routing-Mitsubishi 3.5L and 1998-00 3.0L SOHC Galant engines
ALTERNATOR AND A/C COMPRESSOR
Mar 21, 2013 | 1996 Mitsubishi Mirage
Jul 10, 2012 | 1994 Chrysler Concorde
Inspect the drive belt(s) every 30,000 miles or 24 months. Determine the belt tension at a point halfway between the pulleys by pressing on the belt with moderate thumb pressure. If the deflection is found to be too much or too little, perform the tension adjustments.
On some Acura models it will be necessary to work from beneath the vehicle when servicing the accessory drive belts.
Before adjusting, inspect the belt to see that it is not cracked or worn. Be sure that its surfaces are free of grease and oil. If contamination is present, belt replacement is recommended.
Fig. Fig. 13: Belt routing and alternator belt adjustment-2.5L engine
REMOVAL & INSTALLATION
Many Acura models are equipped with a theft deterrent audio system. Make sure you have the necessary code before disconnecting the battery.
May 05, 2012 | Cars & Trucks
Nov 12, 2010 | 1988 Mercury Grand Marquis
Remove the alternator/power steering and water pump drive belt to gain access to the air conditioning belt.
Loosen the tensioner pulley locknut, then turn the adjusting screw to raise or lower the tensioner pulley assembly. Remove the belt.
Install the belt.
To adjust the belt, loosen the tensioner pulley nut and adjust the belt tension by tightening the adjusting screw. Tighten the pulley nut to 40 ft. lbs. (54 Nm) after adjustment.
Install the alternator/power steering and water pump drive belt and adjust.
Start the engine and check for proper belt alignment and any abnormal noise.
Nov 01, 2010 | 1995 Dodge Intrepid
Oct 11, 2010 | 1997 Nissan Maxima
After adjustment is satisfactory, tighten the idler pulley bolt, and then tighten the adjustment bolt.
Reconnect the negative battery cable.
When replacing more than 1 belt, it is a good idea to make note or mark what belt goes around what pulley; this will make installation easier if you mix up the belts.
Sep 25, 2010 | 1997 Nissan Maxima
Jul 16, 2010 | 1999 Ford Escort
Oct 29, 2009 | 2000 Dodge Avenger
Jun 13, 2008 | 1998 Dodge Neon
10 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: