Question about 2000 GMC Jimmy

1 Answer

Why does my 2000 gmc jimmy shut off while in motion?

My 2000 jimmy gives me a problem starting up and then when it does run it stalls while in motion

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 528 Answers

It could be the Throttle Position Sensor ( TPS ) or Idle air control motor. Determining this will help be a guide. If it idles but you cannot accelerate, then it could be the Idle air control ( IAC) or the MAF ( mass air control sensor).
If it idles but stalls when you try to accelerate, then I would first suspect the TPS. You could throw a lot of money at this problem and not solve it. I would suggest getting the computer scanned to find out what codes it is throwing before buying any parts to swap.
Hope this helps!!

Posted on May 17, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 180 Answers

SOURCE: where is my 1 2 shift sensor 2000 gmc jimmy

Inside trans. pan at the rear of the valve body. They have a wire clip which holds them in.

Posted on Jan 21, 2009

  • 366 Answers

SOURCE: 2000 gmc Jimmy misfiring

change fuel filter ,have inject. system cleaned

Posted on Mar 12, 2009

haider_alhar
  • 90 Answers

SOURCE: 1994 GMC Jimmy hard to start and runs rough when first started

i think if you checked the sparking plugs and map sensors then check your distributer its maybe not delivering the current nedded to perform the spark to some of the cylinders

Posted on May 30, 2009

  • 1 Answer

SOURCE: 2000 GMC Jimmy won't start

i had the same problem and replaced the fuel pressure regulator. Cost about $45 at advance auto store or about $90 at napa auto stores. Once i replace that my truck started right yup and runs like a champ

Posted on Jul 13, 2009

lindsay836
  • 677 Answers

SOURCE: How do you change a 2000 gmc jimmy blower motor?

How do you know the motor is bad ? Have you run 12 volts to it directly ?
We have the parts for you, and step by step instructions :
www.aescompaniesllc.com
Please click on contact us.

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

GMC Jimmy security alarm wont shut off


Try disconnecting battery the re connecting

Mar 15, 2014 | 2000 GMC Jimmy

1 Answer

2000 gmc jimmy starts in AM fine won't start after sitting in sun all day


Can you jumper the fuel pump and make it start and continue to run ?
Have you checked to see if you are getting spark when it won't start ?
Could be a relay or coil, ignition module, or other component.

Aug 08, 2012 | 2000 GMC Jimmy

1 Answer

2000 GMC Jimmy, starts up every time, but only runs for 10 seconds then dies. Restarts every time but will not stay running. Replaced fuel pump, fuel filter, CAM position sensor, crank position sensor,...


you say fuel pressure is good, but what is it? what is the fuel pressure when it stalls out? Spec is 60-66 psi and it wont run if its 55 psi. the fuel pump relay should be good if the pump runs. Make sure the ground for the pump is good , G402 should be on left frame rail. you may have had it off to replace the pump? maybe? it may be time to stop guessing and have a repair shop diagnose it for you. You sure have replaced a lot of good parts.

Sep 07, 2011 | 2000 GMC Jimmy

2 Answers

No heat, Full radiator, Overheating, Stalled out


It could cause all of them the stalling would be caused the engine got hot.

Dec 28, 2009 | 2000 GMC Jimmy

1 Answer

My 2000 gmc jimmy seems to have problems shifting initially in the first gear, and lately it has been redlining to 5000 rpm before shifting from 4th gear ( i think). I feel like one day it is just going to...


1-2 shift is delayed and harsh, may not shift into OD: Check Throttle Position Sensor (TPS) for smooth and linear electrical response over the entire range of motion. If not, replace.

This is one of the things i can think of that would cause the issue you gave me. Start with that since it's simple and the other thing to is you can try resetting the ECM.

Turn the ignition key to the run position (engine not running) and pull the ECM fuse out for 30 seconds. Place fuse back in and start the engine, the engine may stall but let it. The ECM is relearning the engine and transmission and then go for a test drive after idling for 1min. The transmission my be running back good as new, if not. Have the TPS checked if not replaced. Good luck and keep me posted.

Nov 05, 2009 | 2000 GMC Jimmy

1 Answer

1991 gmc jimmy over fueling at start up, it wont start unless you push the gas pedal then it runs rough if you let off it stalls. It is getting way to much fuel...


Sounds like the relay is not shutting off fuel pump. Turn the key to on position ( not start ), pump should only run for a few secounds and you will hear a click and pump should shut off, if it keeps running relay is bad. If it works like it should than fuel regulator (if there is one) would be the next posability.

Apr 08, 2009 | 1991 GMC S-15 Jimmy

1 Answer

2000 GMC Jimmy won't start


Hi: Have run into same type of problem, turned out to be a dead or very battery. Has nothing to do with the ignitin switch. With a low battery have also had trouble getting the key out of a 95 Jimmy. Boost unit to get running then discommect battery, if unit stall right away replace alternator, if stays running replace battery. If you get the unit runnimg and try to drive it as is you should find lacks power and wants to stall.

Jan 09, 2009 | 2000 GMC Jimmy

Not finding what you are looking for?
2000 GMC Jimmy Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...