Question about Cars & Trucks

1 Answer

Describing the word to when someone's trying to prove himself

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,509 Answers

Show, demonstrate, validate, substantiate

Posted on May 17, 2014

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where do i start in removing manual trans on 2000 dodge dakota?

when I doubt buy a repair manual it will prove to be your best tool . the transmission has to be disconnected from the motor but usually not removed . you unbolt it from the drive shaft and the bell housing .

Jul 14, 2015 | Dodge Cars & Trucks

1 Answer

What could be problem

The first problem I encounter, is I can't read minds. I only can help if someone can describe here what the error is they encounter.
In a question it is great to enter the device name, brand, model and year of production. Then describe what you don't get, what you were expecting and since when.
Perhaps if you can share the problem this way someone here on foxy can help.

Jan 13, 2015 | Cars & Trucks

1 Answer

When someone is trying to prove themselves to another

Jackie, Another example of someone who actually doesn't know just what it is that they want, nor how to get it. No information whatsoever.

May 17, 2014 | Cars & Trucks

1 Answer

Do you need to open gearbox to replace a clutch cylinder in golf 4

As slave cylinders fail on a regular basis, I would find it difficult to believe that the gear box has to be interfered with to replace /repair the cylinder .IT may prove difficult to get to but a workshop manual would describe how to remove the cylinder

May 14, 2014 | 2004 Chevrolet Cavalier

1 Answer

I think a timing chain is broken how do i prove it

Take off the oil cap and have someone put a socket on the hormiric balancer bolt and turn the engine look in the filler whole to see if the rocker arms move if not the belt is likely gone

Nov 23, 2010 | 1997 Chevrolet S-10 Pickup

1 Answer

Got new battery, still won't start. just clicks

probable starter motor
if you can get at it have someone turn key to start and tap on starter with something it may start. it also proves a bad starter

Mar 22, 2010 | 1991 Lexus LS 400

1 Answer

My 1992 cavalier shakes while idleing in gear with foot on break but stops while in motion or idleing in park?

hi from uk the symptoms you clearly describe sound like your brake servo /vacuum cylinder is at fault ie whilst brake pedal is off all is ok ? but when pedal pressed engine falters? this is a sign that the seal on the vac piston inside the servo unit is allowing air /atmospheric air to enter the servo as you brake and this assists braking however when inner pistonseal is leaking at some point inside the servo bore ie a scoared or rusty point ?the atmospheric air passes the piston/seal and so the vacuumpipe to servo is drawing this air into inlet manifold resulting in upsetting fuel mixture ie weak too much air ratio to fuel resulting inshaking engine you describe ? try this?? if you disconnect vac pipe from servo unit then seal off the pipe with thumb then ask assistant to start engine then it should run ok ? also it should be ok when b/pedal pressed remember there will be no vac assistance ?? if above test prove right ? then you will req a new servo unit only not complete master cylinder too ? you can diy this then bleed brakes after replacing servo ? hope this helps

Feb 27, 2010 | 1992 Chevrolet Cavalier

1 Answer

My 19994 ford taurus wull turn over but will not

I hate to ask and not insult you,but having someone who is capable of making repairs, should be about to properly troubleshoot your vehicle and only repair the necessary items after being able to prove there bad

Sep 28, 2009 | 1994 Ford Taurus

1 Answer

I have a 2000 Chevy Blazer. It was tuned up about 1 month ago trying to solve a problem with quick exceleration (it wouldn't). Tune up didn't fix it and the garage cannot figure out why it's doing it....

sounds like plug up injector try cleaning injector not by put in injector cleaner in the tank ,if that doesn't solve your problem, you probably need to replace your injector whit the new in prove ones.cosidering that someone check pressure and they found at least 62 psi

Sep 23, 2009 | 2000 Chevrolet Blazer

1 Answer

I changed my transmission fluid on my 1999 mustang tried to start key wont even turn

Changing the fluid would not cause this issue your describing. try turning the steering wheel hard to the left or right to unlock the ignition.

Nov 03, 2008 | 2003 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides