Question about Ford Explorer

Open Question

Will not start

Dorve it with the 4-wheel drive low about 50 miles when i stopped at a stop sign it cut off and i can not get it to start again. The anti theft light is now blinking

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 3 Answers

SOURCE: How can I bypass a anti auto theft system on my 1990 cadillac seville?

I Have A Seville 1990, When That Happen To Me I Got The Inginion
Replaced Problem Solved. What Is Happening Is Your Key Has A Chip And That Chip Is A Resister And When The Valve Is Not Sented To The Computer It Disengages the Fuel Pump And Than Tells You To Wait. Soon All That Will Happen Is You Will Get The Wait 3 Mins And It Will Never Start, A Good Locksmith Can Take Care Of This For You And That Will Save You Some Money. Cause If You Go To The Dealer Ouch They Will Hit You Up. But I Asure This Is How It Will Happen Cause It Is How It Happen To Me
And Sorry There Is No By Passing The Computer

Posted on Dec 25, 2008

Ad
  • 3 Answers

SOURCE: 2001 ford taurus wont start and anti-theft light is blinking

Either you may be using a key that you had copied from the original or your chip went bad in your original key. Most of cars now a days have the key censor in the key so if it is the incorrect key it will not start your car or if it does not read that chip it will not start

Posted on Feb 05, 2009

junmag
  • 175 Answers

SOURCE: anti theft device for 1997 ford expedition

try using a spare key first

Posted on Jun 02, 2009

  • 7 Answers

SOURCE: 2004 chevy silverado 1500 4 wheel drive wont work..

try selecting from nutreul or less then 3km

Posted on Feb 20, 2010

  • 5 Answers

SOURCE: When anti theft light is blinking the car wont

On a 2003 Chevy Maibu the theft system light comes on and blinks when the system is triggered. The car will not start and the fuel pump cuts out. You must turn key to on and have all doors closed. Keep the key to on for 10 mins til theft light turns solid and then disappears. Then turn key to start and it should fire up.

Posted on Aug 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Diesel engine runs then stops then runs stops every few minutes


Mate I use to drive a freightliner and it cut out on me one day, I eventually got it started but cut out again after about 5 minutes, I rang a mechanic to come out and he found a heat sensor wire came off the radiator and that caused the motor to cut out... Hope I haven't wasted your time.......

Mar 09, 2016 | 2007 Chrysler Grand Voyager

1 Answer

My traction and ABS in light stays on my VSC light for high low light flash continually when this happened of my four-wheel-drive quit working


The 4 wheel drive will stop working, the computer relies on inputs to help your $X$ but as far as I know if its in $X$ the ABS will not work its programmed that way. Check the 4 wheels and make sure your sensors were not cut that usually happens and will light your abs and traction control light on dash.

Dec 10, 2015 | Cars & Trucks

1 Answer

When you start the car the 4 wheel high and 4 wheel low indicators light and flash four times,


To make the lights stop blinking and actually engage the transfer case you have to maintain the electric motor that engauges the transfer case. the contact points inside get worn and corroded and wont allow enough power through to rotate the servo. The motor is located on the transfer case and is held of by 3 bolts, remove and unplug. Any good 4-wheel drive shop can fix it for you for about $50 or you can take it apart and clean the contact points inside and relubricate it yourself in about 15 minutes. reinstall and your 4 wheel drive will stop flashing and actually work.

Feb 07, 2010 | 2003 Ford Expedition

2 Answers

2004 chevy silverado 1500 4 wheel drive wont work..


try selecting from nutreul or less then 3km

Feb 02, 2010 | 2003 GMC Sierra

1 Answer

Hard to shift transfer case into 4 high 2000 GV Suzuki


See Handbook you should stop car before selecting low ratio box-4 wheel drive can be selected on the move (up to 60mph)----How often do you need to select 4wheel or low ratio???

Jan 24, 2010 | 2001 Suzuki Grand Vitara

1 Answer

I put my 2000 escalade in 4 wheel low last night; and now I cannot get it switched back to 2 wheel high. I will not go above 50 miles an hour when I drive it. When I press the 2 wheel high button it...


start truck leave in park press 2 wheel high button put truck in drive move truck,check for being in 2 wheel high, if still in 4 wheel low have switch and shift solenoid checked

May 17, 2009 | 2007 Cadillac Escalade Two-Wheel Drive

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...