An expert who has achieved level 3 by getting 1000 points
An expert that got 10 achievements.
An expert that got 5 achievements.
An expert whose answer got voted for 500 times.
Re: Sounds like a small chain being dragged on rt rear...
We are not guessing,! We are making logical conclusions based and dependant on the truth and sccuracy of information provided by the inquirer. Faiilure of common sense and confirmation of recommendations is the sole responsibility of those making the inguiries.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
With old style handbrake, you can remove some screws around the handbrake covering. The screws are sometimes well hidden so you have to look around.
When you get the covering off, there are two adjusting nuts at the rear of the handbrake. Turn the nuts until you can get "5 clicks" on the handbrake to set the brakes.
Some jack up the car while doing this so they can rotate the wheels by hand to feel when the brakes touch the pads.
Hope this helps
You may need to adjust the cable for your hand brake. The driver's side is too tight and the passenger side is too loose. Best thing to do is drop the hand brake (e-brake) down, loosen the adjuster on the drum, then lift the hand brake until you hear 5 clicks. Then adjust the handbrake cable on both sides until the disk just stops.
Hi,Front brake pad worn out. This noise comes from the wear sensor rubbing against the rotor. Replace brake pad - Presence of dirt or scored rotor. - Dust plate bent and touching rotor. - Contaminated brake pad Read more about brake problems at this website www.thecarproblems.com
you need a special tool avalable at most parts stores. its a disc brake piston turning tool. you have to rotate piston clockwise while pushing in on piston. you can fabricate something that enguages the slots and push and turn till all the way in.make sure to note position of slots and put them in same place as was before or the pin on the pads wont enguage the slot