Question about 2002 Acura 3.2CL

Open Question

2002 acura cl-s u joint and cv boot parts and labor cost

Pulls to the left slightly when driving and moreso when braking

Posted by Anonymous on

6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 2039 Answers

SOURCE: cv joints

in canada 2 rebuilt cv 120.00 each 1 hour labour each anywhere 350.00 and up hope it help fixya our problem thanks pierre

Posted on Jul 12, 2008

  • 1050 Answers


When you changed the joint, I'm assuming you had the shaft out. A common problem occurs when you put the shaft back in, it doesn't fully seat in the transaxle and then the differential is only connected to one wheel so it can't transmit power. You will have to disconnect the lower ball joint again, move the lower control arm down a bit, so that you can push the axle into the splines of the transmission.

Posted on Mar 08, 2009

  • 1201 Answers

SOURCE: my acura 3.0 cl makes a knocking sound on left turns

Have the cv joints checked.

Posted on Mar 11, 2009

  • 38 Answers

SOURCE: can someone with minor car repair expierience fix

Very easy fix but will take sum time and specialty tools. If you have the tools just start tareing into it. If you dont, take it to the dealer. If you need step by step instructions I can help.

Posted on Jul 26, 2009

  • 1 Answer

SOURCE: cost to replace 2002 Acura 3.2 tl transmission

your car could still be under warranty depending on the miles the car have call your Acura dealer for info. I had my transmission replaced in Feb 09 and it was done for FREE!!

Posted on Aug 07, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How do I tell if my rear cv axle is broken?

You asked about the rear cv joint. Why do you think it's broken ?
if it's broken it will make a noise when trying to pull away, making a clicking noise when turning is front cv joints.
wth the car in park, jack one side up and try to turn the wheel by hand .... If you can and it makes a noise or it spins free it's broken. If you can't turn it try the other side. If you can't turn the other side either you don't have a broken rear cv. Damaged is a different thing.

Feb 01, 2015 | 2002 Ford Explorer

1 Answer

Clicking on turns left and right

CV joints may be going bad, could be the left or right, never heard of both sides going @ same time, but who knows until they get checked. Inspect the BOOTS, for torn conditions allowing grease to come out, that one would be the suspect bad cv joint, will get worst , the retainer band may have come off on outside joint throwing grease out, needs replaced, call for parts cost for the complete cv joint, one side. otherside may be ok, but be prepared in case it needs replaced also !

Mar 04, 2013 | 2002 Chevrolet Malibu

1 Answer

While driving when you turn the wheel slightly to the right you hear a noise with some vibration. front tires and brakes are new. could this be cv joints or struts?

Need more info but sounds like power steering gearbox or cv joints. What happens when you turn all the way left or right? Is it worst or better and what do the noises sound like? Whining or grinding?

Jul 18, 2012 | 2002 Saturn L-Series

2 Answers

Mechanic says i need new front axles......

Usually once the boot is torn, dirt goes in, and all of the lubricant goes out. If you have been driving it this way, it will damage things faster. Normally you hear a "click" when turning out of a bad cv joint.It is a safer solution to just replace both, but of coarse, not cheaper.

Aug 19, 2009 | 1992 Honda Accord

1 Answer

Car Rumbles, CV Joint?

you may have wheel bearn going. they will make noise grinding when you trun

Mar 22, 2009 | 1992 Buick Park Avenue

2 Answers

"Clanking" Noise When I Turn Left

well if you do it your self about 13.00 if you do it at a shop about 150.00 it's either a cv joint or a tie rod good.

Jan 03, 2009 | 1987 Subaru Gl 4WD

1 Answer


The hood latch pull hamdel should be next to your left foot mounted on the kick panel. The noise is probally a CV-joint going out on one of your front drive axles. there should be a rubber boot over the joint, and it is busted. making dirt & road film, plus water washing the grease out from around the CV-joint. You will need to replace it. About $100.00 per axle, if you do the work????

Jul 27, 2008 | 1994 Acura Vigor

Not finding what you are looking for?
2002 Acura 3.2CL Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8211 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides