Question about 1999 Dodge Caravan

1 Answer

Ac works only on high

I can't control the air fan, it only works on high speed...thanks for your help

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

U need a blower motor resist or control module depends on y m m remember that can help me help u always state the year make & model of the car

Posted on Jun 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The defrost, heater and Ac all went out on my 1993 maxima.


If the blower worked, but couldn't get cold air, there may be a leak of refrigerant in the A/C system. If you're complaint is about the lack fan-forced air; that could be a problem with the fan speed switch or a bunch of other places. Most often however, it is the speed control resistor. Have a look at this thread to learn more about it:

Air conditioner fan switch only works on high Nissan Forums Nissan Forum

Nov 30, 2015 | AC Cars & Trucks

2 Answers

Overheats unless ac is running


The thermostat may be stuck. If it dosent open then the engine will overheat. If you turn the ac on then the air rushing around the engine will help cool it down. Replace the thermostat and it should fix it

Dec 30, 2012 | 2008 Pontiac Grand Prix

1 Answer

Why mini cooper 03 overheats while the AC is on?


Check to see if the electric cooling fans are working. Some of the fans have 2 speeds and some need to operate on high speed constantly when the air is on. High speed could be a burnout.

There should be a temperature sensor, a fan Relay, and then the electric cooling fans.

Oct 01, 2012 | 2003 Mini Cooper

1 Answer

2008 chrysler 300 heater/ac control only changes functions when fan is on high


sounds like a electrical issue in the switchs there not flashing a trouble code are they

Nov 20, 2011 | 2008 Chrysler 300

1 Answer

AC and Heater fan will only work on high speed, all fuses good. any ideas thanks, Dave


When the blower fan will only work on high speed setting this means the fans speed control resistor is burned out, when it fails the fan defaults to high speed only. The fan resistor is located next to the fan and held into the cooling air duct by 2 screws near the blower motor. The part is fairly cheap and easy to replace.

May 11, 2011 | 2000 Mercury Villager

2 Answers

01 grand.prix ac fan switch only works on high. has a duel temp controller when you turn fan off the only way fan comes back on is to move the temp controller levers


Hi!!
When the Blower Motor Resistor (controls blower speeds) goes bad, the blower motor works only on HIGH SPEED. REPLACE IT.
BLOWER MOTOR RESISTOR Removal & Installation
  • Disconnect negative battery cable.
  • Remove right lower instrument panel insulator panel.
  • Disconnect blower resistor connector located behind right side of dash.
  • Remove blower resistor screws and blower resistor.
To install, reverse removal procedure
Good Luck!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa!!

Feb 18, 2011 | 2001 Pontiac Grand Prix

1 Answer

Heat/ac blower motor works on high. intermittent on other speeds.


Check the blower resistor pack - usually located in the heater air ducting in the blower fan airflow. Check for loose connections and open circuit resistors on the unit.
If speed 4 works always, its unlikely to be the blower motor ground connection.

Aug 10, 2009 | 2004 GMC Canyon

3 Answers

Heat/AC Blower fan speed only works on High


Alot of people have the same problem with the fan switch and blown bulbs. There really is no fix for this. Jeep really screwed up when designing the heater control assembly. The cheapest solution is to buy another unit off Ebay. Can always go to the dealer but be ready to PAY for there mistakes.

Jan 14, 2009 | 2005 Jeep Grand Cherokee

1 Answer

AC fan speed


i had this same problem in my chevy prism-- my fan regulator had broken. (apparently it usually happens around 100k miles, i hear) in my car, the vents wouldn't even blow air at all on anything but high--- not just AC, but normal vented air as well.

cost about $80 to have the problem fixed by my mechanic in Jersey. hope that helps!

Oct 14, 2008 | 1988 Jeep Cherokee

Not finding what you are looking for?
1999 Dodge Caravan Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...