Question about Ford Explorer
Your turn signal flasher should be located in the front seating area, driver side, under left hand side of instrument panel between junction block and brakepedal.
Posted on Jun 09, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: WHERE IS TURN SIGNAL FLASHER
your turn signal flasher is located on the drivers side in the dash (Explaination) open the driver side door and look on the dash wherethe door closes against it and there is a little panel where your fuses go it should be in there.
Posted on Oct 04, 2008
check the switch it self may have to replace if everything is good grounds powers and lights, you can use a jumper wire to provide power to a ligh and if it illuminates you know the circuit is good, test each circuit and if all working replace
Posted on Aug 04, 2009
COMBINATION FLASHER LOCATION
The Turn Signal and Hazard Warning Flasher is combined into one unit called a Combination Flasher (Combo-Flasher) The combo-flasher controls the flashing of the hazard warning system and the turn signal system. An inoperative bulb or incomplete turn signal circuit will result in an increase in flasher speed.
The combo-flasher is mounted to the in-line bracket which is located to the right of the Junction Block. The flasher can be removed by pulling in an rearward direction. The left under panel silencer duct must be removed to access the flasher. The combo-flasher is black in color for ease of identification
Posted on Nov 26, 2009
I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.
Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.
If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)
Your going to replace it anyway, whats the harm?
Posted on Jan 28, 2010
Tips for a great answer:
Mar 03, 2015 | 2000 Chrysler Concorde
Aug 24, 2014 | Cars & Trucks
Sep 11, 2012 | 2000 Chrysler Concorde
Jan 18, 2011 | 2000 Dodge Intrepid
Oct 30, 2009 | 2000 Dodge Intrepid
Jun 25, 2009 | 2000 Dodge Intrepid
Aug 06, 2008 | 1996 Buick Century
Jul 12, 2008 | 2000 Chrysler Sebring
28 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: