Question about Buick Regal

1 Answer

Where is battery location 2000 buick century?

Posted by Anonymous on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 32 Answers

Open hood, look down and to the left.

Posted on Mar 02, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
AutoDoc
  • 169 Answers

SOURCE: horn relay 95 Buick century

It is located in the convenience center to the left of the steering column.

Posted on Aug 31, 2008

  • 2 Answers

SOURCE: Where is the fuel filter located for Buick Century 2001

The fuel filter is located underneath the car in front of the gas tank.
You have release the fuel pressure. Remove the fuel filler cap, locate the fuel test port on the fuel rail on the passenger side on the end of the right real fuel rail for a 3.1L engine.
3.8L engine yhr test port is located at the pressure regulator under the trim cover.

Posted on Sep 23, 2008

Papa Chan
  • 56 Answers

SOURCE: how to replace a coolant level sensor, 2000 buick century

The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.

Posted on Jan 04, 2009

  • 468 Answers

SOURCE: 2000 Buick Century gas gauge reads full all the time

You're either looking at a short in the wire that goes to the fuel sender, or a bad fuel sender. If it was just a broken wire, it would read empty instead. The fuel sender is a permanent part of the fuel pump, so that has to be replaced as a unit.

Posted on Oct 20, 2009

  • 1 Answer

SOURCE: 2000 buick odometer want light up cant read the

Odometer and shifter display does not light up

Posted on Nov 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 buick century wont even attempt to start. Sat for two months


check fuses and relays --if sat for 2 months test battery probably dead --try to start with a boost then test battery

Sep 20, 2016 | 2000 Buick Century

1 Answer

Why nothing happens when i turn the ignitio switch on a 2000 buick century?


Check to make sure your Battery is not dead. If it has a full charge then check the connection from the +side of the Battery to the Starter is tight and not corroded. Clean both Battery terminals as well.

Apr 04, 2015 | 2000 Buick Century

1 Answer

How do I wire my amp's red wire through my 2000 Buick Century to the battery.


Run the power wire through an existing grommet in the fire wall. Then run it under the carpet/trim panels. ---------------------------------------------------------------------------------------
Super VAG K+CAN Plus 2.0

Feb 19, 2013 | 2000 Buick Century

1 Answer

Amp power cable install on 1999 Buick century


I have A 2000 BUICK century and need to know how to wire my amp red wire form the battery to the amp

Dec 25, 2012 | 2000 Buick Century

2 Answers

So the lights and the radio work so i know is not the battery but the car will not start and it doesnt make a sound so i think is the ignition problem so i dont know where is the solenoid located on a...


The solenoid is located on the starter so if the starter doesn't function then it could be a bad starter which will have to be replaced with a known good one.

But, I would try replacing or charging the battery to max. voltage to see if that makes a difference.
Sometimes, the lights and radio work, but there isn't enough charge on the battery to supply enough 'current' to the starter which takes up more current than the lights and radio combined.

Also, try to clean the battery terminals to maximize current and voltage to the starter.

Jan 30, 2011 | 2000 Buick Century

2 Answers

Where is the fuel filter located on a 2000 buick century 3100 v-6?


Hello, here is a picture of the fuel filter location. hope this helps. it is mounted on the bottom of car on the frame . it is near the left rear tire. you will get to from underneath





545ce8f.gif

Jun 19, 2010 | 2000 Buick Century

1 Answer

2000 buick century fuel filter location


Regarding the coolant level sensor, I had to remove the battery on my 2000 in order to "tap" the new sensor in. It has two O-rings on it and I couldn't get enough leverage to press it in w/o removing the battery. Perhaps others can do it w/o removing the battery but that's what I ended up doing.

Mar 10, 2010 | 2000 Buick Century

1 Answer

Canshaft sensor location


Hello, the camshaft location on a 3.1 is located under the power steering pump. The crankshaft position sensor is on the back of the block above the transmission, middleways of the motor.

Feb 21, 2009 | 2000 Buick Century

1 Answer

How to replace a coolant level sensor, 2000 buick century


The coolant level sensor is located on the radiator. If you are looking at the engine from the front of the car it will be on the left side. There will some kind of clip holding it in the radiator. Removed the clip and pull the sensor out. You will lose coolant so try to swap it out quick or drain some of the coolant out. Once new sensor is installed, install clip to keep the sensor in place and reconnect the wires to the sensor. Crank the engine and make sure the coolant level is full. This should correct your problem.

Dec 20, 2008 | 2000 Buick Century

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...