Question about 1994 Honda Accord

1 Answer

Auto electrical troubleshooting

I just bought a car and the front turn signals aren't working. The bulbs were just replaced. Pretty sure its a problem with the wiring. Previous owner must've rewired everything to add on extras

Posted by on

  • Patrick Kennedy
    Patrick Kennedy May 16, 2014

    Also, I belive I found the fuse box under the driver-side dash and connected it but then it started clicking constantly and drained battery power to the starter so I re-disconnected it.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Welcome Back:

    Visited the website for 2 consecutive days.

  • Expert
  • 62 Answers

Probably a poor alarm install. Look under the dash and see if any cheap connectors are installed. Then show that to the dealer.

Posted on May 16, 2014

Testimonial: "There is no alarm installed and unfortunately, we didn't get it from a dealer..."

  • Patrick Kennedy
    Patrick Kennedy May 18, 2014

    Nevermind, whay we thought was the relay unit, was actually an alarm, just disconnected. you were right. Thanks. Now we just need to figure out how to remove it....

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 94 Answers

SOURCE: change front turn signal

You have to remove the signal unit from the bumper using a normal " + " screwdriver then twist the bulb holder at the back of the sinal unit.

Posted on Nov 30, 2008

johnny5846
  • 379 Answers

SOURCE: I need to know where a flasher is located on a Honda Accord Ex?

its in the underdash fuse/relay box , left kickpanel , since you have the new part it should be easy to identify now .

J5

Posted on Jan 18, 2009

  • 435 Answers

SOURCE: replace front turn signal bulbs

odd speed blinker is a message to tell you that a light bulb has burned or is disconnected. All front lights can be replaced from the engine compartment EXCEPT the turn signal :( .Unfortunately you will have to pull the headlight assembly out in order to reach the turn signal bulb. If the light was off since the assembly was replaced, there is a chance that the socket was simply left unplugged.

Posted on Apr 20, 2010

  • 1374 Answers

SOURCE: Honda 2005 CRV - The

Bypass head light switch and see what you get. Three items can cause your problem . The head light switch, flasher relay , shorts in circuit. I would go with switch.

Posted on Aug 18, 2010

flbergeron68
  • 541 Answers

SOURCE: The left front turn signal

the flasher relay needs to be replaced

Posted on Jan 02, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My left turn signal recently stopped working. Before ceasing to work, the turn signal (just the left) would blink very rapidly (machine gun speed).


sounds like one of light bulbs was malfunctioning and caused the flasher unit to blink rapidly and iy burned out. Replace front and rear turn lite bulbs and see if flasher flashes. if not check fuse and replace fuse. If fuse okay replace flasher unit. Good luck

Jul 08, 2016 | 1997 Plymouth Voyager

2 Answers

What could be causing the front turn signals to not work?


Hi, it sounds like bad wiring like you say, you're gonna have to get rid of all the add on stuff, cause the way I see it, it might requiere a higher capacity fuse, the down side is you leave your computer more expose to electric damage and/or a short circuit leading to a fire (dangerous). Best solution is... get rid of all that stuff and if you feel it's best, re-wire.

May 17, 2014 | 1994 Honda Accord

1 Answer

Rear Turn signal is not working


Aren't your brake lights and turn signal lights on the same bulb, same filament? Recheck the bulb in the rear, as the rapid blinking is an indication of a burnt out bulb. If the bulb is the correct one and is good, check the connector and socket at the housing for a loose or poor connection.

May 26, 2012 | Dodge Durango Cars & Trucks

1 Answer

2008 Chevy Cobalt front right turn signal is not working. Back right signal blinks fast. Left signals work just fine. I tried replacing the bulb and it did not work. Do I need to replace the...


No - headlight ok.
The reason that the Right turn signal blinks fast is that there is half the normal load (resistance)
on the right side, since the Right front turn signal isn't working.
Since you replaced the Right front turn signal bulb, your problem lies in the bulb socket or
the wiring to the socket.
(1) try cleaning out the socket - there's probably a contact problem in the socket. You
may need to squeeze the contacts together to provide good contact to the socket contact.
(2) if contacts inside the socket are ok, try back-probing the socket - to make sure that the
socket is getting 12V DC to light the bulb. Replacing a bulb socket is easy, and commonly done.
Any auto parts dtore should be able to sell you a new socket - its just a matter of cutting out the
old one, and then splicing in the new one. Most shops will use small wire nuts, buried under several
wraps of E-tape (electrical tape).
(3) if bulb AND socket ok, you have the worst problem known to man - a wiring fault. In this case,
you'll want to run a new wire from the flasher module (under the dashboard) to the turn signal.

Jul 29, 2011 | 2008 Chevrolet Cobalt

1 Answer

2000 concord turn signal lights stopped working


It can be a multitude of problems.

Is it the front or the back?
If it is the front or and you have the ability to get it out, does it have the appearance of being "burnt-out" (be careful to never touch an electrical system on a car without disconnecting the battery first and letting it cool down). Without touching the bulb itself (the oil from your fingers can cause the bulb to burn out) inspect the area around the socket of the bulb and make sure it is tight. If it is and still will not turn on after making sure it is tight, remove the bulb after it cools down, take the bulb and users manual to the closest auto dealer and find a replacement bulb. If it still doesn't work. Talk to the sales associate at a place such as AutoZone or Oreillys. They can show you the ins and outs of your car.

Mar 21, 2011 | 2000 Chrysler Concorde

1 Answer

Turn signals work intermittently what is wrong


Hello. Generally speaking- with turn signals, they either work or they don't work at all.

Here are the basic troubleshooting tips- if the light blinks extremely fast, that means a bulb is out on that particular side; either the left or right side. You will have to check whether the bulb is burned out in the front of the car or in the rear light assembly.

If the lights (either side) do not come on at all OR they do come on without flashing, the turn signal relay needs to be replaced.

And most likely this is the root of the turn signal working intermittently- you'll have to replace the relay- which is the easiest fix on any car.

Look in your car's owner's manual and look under the headings: electrical or turn signal lights or electrical panel, etc. It will tell you where to find the relay cluster for the signal lights. You can go to your local auto parts store to buy one (they are inexpensive) and I'm sure the counter person will show you where to find the burned out relay if not actually install it for you.

Hope this helps!

John

Oct 02, 2009 | 2002 Pontiac Grand Am

2 Answers

2002 Volvo V70, left turn signal will quick flash, rt side works


this issue appears many times because the wrong wattage bulb was used. the system measures the amperage flow to the individual bulb. if it falls outside the factory range ,, the indicator light will come on. I had a 1990 volvo myself. had a terrible time keeping good tail lights in that ****** but ABSOLUTELY loved that car. loved it so much I bought another (1998) model. it just wasnt the same driving experience as the 90 model though.
hope this helps...

Jun 24, 2009 | 2004 Volvo V70

2 Answers

1998 Ford Escort Left Front Turn Signal


replace rear left globe and this will solve both problems cheers MAL

Mar 17, 2009 | 1998 Ford Escort

2 Answers

Front right turn signal


i had a bad socket that was my problem on mine.

Dec 10, 2008 | 2000 Oldsmobile Intrigue

Not finding what you are looking for?
1994 Honda Accord Logo

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...