Question about 2000 Chevrolet Blazer

Open Question

01 blazer s10 hesitates during accelration 4.3 engine

When 4x4 pump was unplugged it did not hesitate,when plugged back in and all 4x4 lights work it hesitates during accelration

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 206 Answers

SOURCE: 01 Chevrolet S10 Blazer hesitates/misfires

If it is only doing this in overdrive lock up, tap the brake if it quits see a transmission man your torque converter might be bad

Posted on Feb 15, 2009

Ad
joe24carroll
  • 2 Answers

SOURCE: 1994 4X4 Chevrolet S10 Blazer/ CAN'T GET OUT OF 4 LOW BACK TO 2 WEEL DRIVE

put it in neautral and hold the brakes then try it

Posted on Aug 11, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

89 s10 engine stalls. hesitation during acceleration.


I disagree with blood has nothing to do with injectors or fuel pump in 99% of all cases of this problem and is a very costly mistake to replace those things only to end up with only a $15 egr problem.

It is usually a faulty/bad EGR valve which is a very commonly known thing when it comes to s10's they were notorious for stalling and hesitation issues due to bad egr's from 89-94.

Jun 11, 2010 | 1989 Chevrolet S-10 Blazer

2 Answers

1993 Chevy S10 Blazer engine hesitation with smoke from exhaust


Had a 94 Olds Bravada that did a similar thing and it was EGR valve on the front of the intake. It' s easy to take off and clean with WD 40 and if you have an air compressor blow it out good.

Dec 19, 2009 | 1993 Chevrolet S-10 Blazer

1 Answer

I have 94 s10 blazer 4.3 the prob started the


throttle position sensor, or check to make sure you have vacume going to the map sensor. Alot of times the outlet on the throttle body gets plugged and there is no vacume at the map--causes it to die. unplug the throttle position sensor and then rev it up and see if its better.

Dec 04, 2009 | 1993 Chevrolet S-10

2 Answers

My 2000 s10 blazer 4x4 doesnt work.no lights on the dash.nothing.cleaned the wires on the tccm ,tested it with a test light and there is power.but no lights on the dash.no 4 hi or low or auto.what can it...


I have had luck over the years with unplugging the TCCM for about 5 minutes and plugging it back in for a reset if this doesn't work and all your fuses are ok I have also had the motor and circuit board on the side of the transfer case short out and cause this problem.

Nov 19, 2009 | 1994 Chevrolet S-10 Blazer

1 Answer

1964 VW


That would be your Accelerator pump diaphragm (part of a tune-up kit). It is a (roughly) square diaphragm that goes under the pump cover (four screws with a pivoting rod that controls the diaphragm) which is located on the right-hand side of the bottom portion (looking at the carb from the rear of the car) of all the Solex PICT carbs.
Kits are available from www.mamotorworks.com for around $15.00.
Hope this helps you.

Nov 06, 2009 | Volkswagen Cars & Trucks

1 Answer

2004 Isuzu Rodeo 3.5ltr 4X4 hesitation/misfire acceleration


The upper intake gaskets may be leaking. They are made of plastic and metal and will leak air. Do not remove the cover on very top of manifold when changing.

Jul 24, 2009 | Isuzu Rodeo Cars & Trucks

2 Answers

01 Chevrolet S10 Blazer hesitates/misfires


If it is only doing this in overdrive lock up, tap the brake if it quits see a transmission man your torque converter might be bad

Feb 15, 2009 | 2001 Chevrolet Blazer

1 Answer

2004 dodge caravan 2.4 Hesitates during Acceleration and at idele


You should definitely replace the fuel filter though this probably won't fix your hesitation. It wouldn't hurt to replace the spark plugs this is usually the culprit on these engine. I have the same engine in a '99 caravan and found the for some reason the spark plugs on cylinder 3 and 4 loosen up after one year and cause a misfire between 45 and 50 mph under load (when mildly accelerating).

Jan 06, 2009 | 2004 Dodge Caravan

Not finding what you are looking for?
2000 Chevrolet Blazer Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...