Question about 2000 Chevrolet Silverado 1500

1 Answer

How can i fix my temperature problme on 2000 Silverado ?

My temperature on mirror stopped working on 2000 Silverado how can i fix it ?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 5,351 Answers

Really? You care that much? Probably the sensor which tells it the temp, but could be the wiring or the display itself.
Does anything else not work? Check fuses.

Posted on May 17, 2014

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
STR8JCKTED
  • 42 Answers

SOURCE: 2000 silverado 1500

IF THE WHOLE HOUSING IS SHAKING YOU WILL HAVE TO PULL THE INSIDE PANEL AND RETIGHTED I THINK 3 OR 4 BOLTS

Posted on Nov 12, 2008

  • 1 Answer

SOURCE: both side power mirrors won't work on 2000 silverado

Silverado power mirror/s do not work.
Assuming you have power to the switch, the switch contacts are bad. Each contact may go bad at different times.Pry the switch panel from the door, disconnect the plug to the switch, a small screwdriver may help. Remove the switch by pushing the retaining lugs in & pry out.
Now take it to a clean workbench along with 2 small thin screwdrivers.
Insert 1 driver in beside one of the keeper lugs & pry slightly, continue to the next until the switch comes apart. No springs will fly out.
You will see a control knob & housing, A blue vinyl like cover, Lift the blue cover off, now you will see the contacts on the board.
Take a cotton swab with carb cleaner & scrub the contacts, even a piece of 320 sandpaper.
Next, on the under side of the blue vinyl like cover there brass like contacts fixed to the cover, they need cleaning.
I cut a few 1/8'''x1/8'' # 320 sandpaper,A 1/8'' dowel & hot glued a piece of s-paper on the 1/8'' x6'' dowel.
I then carefully slowly spun the s-paper on the contact. then to the next contact with a new piece of sandpaper & so on.
Lastly cleaning with carb cleaner & blowing dry.
Reassemble, hookup & test Walla! both mirrors work. Time, 20 to 30 min.

Posted on Oct 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My rear view mirror with temp and compass sometimes will not work. It will show all the digital shows up at once and not the temp, but sometimes it works ok. What can I do?


Does the compass work when the temperature goes out? If the compass still works then chances are that the ambient temp sensor is defective. Also, could be wiring to the sensor. If the compass goes out with the temperature then chances are the mirror itself is defective. Cheapest most common problem is the ambient temp sensor. It's behind the grill by the condenser at the front of the vehicle.

Aug 20, 2014 | 2003 Chevrolet Silverado 1500

1 Answer

All the following seemed to have happened at the same time: Heating system has stopped and cannot get on at all, oil light always on even though filled to max, oil temp not moving at all from min temp and...


wow slow done man, one at a time.
1. Your heater not working is related to your radiator, water pump and thermostat condition. Have your radiator a good clean flush and take it from there.
2. Your electricmirrors are related to your mirror wirings, check them using an OHm meter.
3.Oil light and oil temperature always on and not moving is because your oil switch light and temperature oil sensor is sensing low or no oil meaning defective sensor.
4. Take it to a garage or repair shop as you need to have an automechanical know-how to fix them all your problems.

Sep 02, 2010 | 2000 Audi A6

2 Answers

I have an 2001 chevy pickup. i just put a new mirror in


Did the mirror have a temperature read out before?All you should have to do is hook up the mirror to the connector and everything should work.There aren`t any separate hook ups.

Nov 24, 2009 | 2001 Chevrolet Silverado 1500

1 Answer

Electro-Chromatic Rear View Mirror compass and temperature rarely displays, when it does display it varies from bright to very dim.


Have your resolved the issue stated above. I have been having the same problem. Now my display has stopped working completely.

Sep 01, 2009 | 2000 Chevrolet Silverado 1500

1 Answer

Mirrors only work up and out 2000 silverado, how do i test?


if you have power mirrors on both sides and they both only work side to side, most likely the switch.Highly unlikely but it is possible for both sides up and down to go out. without a wiring diagram and a test light you would be best to attempt to replace the control.

Jul 16, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Window problems


The fix for this is to replace the regulator. That is the only way you can by replacement parts, as a unit.

May 26, 2009 | 2000 Chevrolet Silverado

2 Answers

Both side power mirrors won't work on 2000 silverado


Silverado power mirror/s do not work.
Assuming you have power to the switch, the switch contacts are bad. Each contact may go bad at different times.Pry the switch panel from the door, disconnect the plug to the switch, a small screwdriver may help. Remove the switch by pushing the retaining lugs in & pry out.
Now take it to a clean workbench along with 2 small thin screwdrivers.
Insert 1 driver in beside one of the keeper lugs & pry slightly, continue to the next until the switch comes apart. No springs will fly out.
You will see a control knob & housing, A blue vinyl like cover, Lift the blue cover off, now you will see the contacts on the board.
Take a cotton swab with carb cleaner & scrub the contacts, even a piece of 320 sandpaper.
Next, on the under side of the blue vinyl like cover there brass like contacts fixed to the cover, they need cleaning.
I cut a few 1/8'''x1/8'' # 320 sandpaper,A 1/8'' dowel & hot glued a piece of s-paper on the 1/8'' x6'' dowel.
I then carefully slowly spun the s-paper on the contact. then to the next contact with a new piece of sandpaper & so on.
Lastly cleaning with carb cleaner & blowing dry.
Reassemble, hookup & test Walla! both mirrors work. Time, 20 to 30 min.

Feb 12, 2009 | 1999 Chevrolet Silverado 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

79 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...