Question about 1999 Lexus RX 300

1 Answer

Rx300 1999 wheel vibration- mostly when do left hand turn

Left rear rotor has deep grooves? related?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 279 Answers

It sounds like it might be a bad hub,CV shaft,or even poor brakes.A good mechanic will be able to tell you within 10 minutes of taking off the front wheels.The rotors on a car should be free from any marks or grooves.This is an indication that your brakes are in need of immediate attention and service.It is possible that your brakes are worn out on all four tires.I cannot stress the need for IMMEDIATE attention to this problem.good luck

Posted on May 16, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Do you know about the deep groove ball bearing?


If it fell out then it can't do it's job which is to regulate the pressure within the pump and is "shot."

Oct 09, 2012 | Cars & Trucks

1 Answer

Rotated & balanced tires. new driveshaft & center carrier bearing u-joints new shocks front & rear replaced rear axle bearings and seals new left rear rotor parking brake shoes new disc brake...


You will need to check things logically. Run the truck in the air and note where the vibration is at. Take the wheels OFF and put a few lug nuts to hold the rotors on, take the truck to 45mph or whatever the vibration is the worst. is it still there? if its gone, check wheels/ tires. if its still there, check rotors, axles. A drive shaft will make a rapid vibration at low speeds since it turns 3 to 4 times faster than the wheels. does it vibrate on or off the gas? Can you power through the vibration like go 60 and then coast back through? You have replaced a lot of parts that would not cause vibrations. Are you just changing parts willy nilly or is someone actually checking and verifying that these parts really bad?

Jul 18, 2011 | 2001 Chevrolet Silverado

4 Answers

Steering wheel shakes at high speed when brakes are applied


This is caused by the front disk brake rotors being warped from heat and running out of true, the wobble of the warped rotors causes the wheel to shake when you apply the brakes, it is worse the higher the speed you apply them at. Have the front rotors machined flat again or just replace them.

Mar 16, 2011 | 1998 Toyota Camry

2 Answers

HOW DO YOU KNOW WHEN TO CHANGE YOUR ROTARS


If they are warped ,the brake pedal,and,or the vehicle will shake when applying the brakes,or the rotors will be scored too bad to resurface.

Sep 12, 2010 | 2006 Ford F-150

3 Answers

2007 camry brakes vibrating


Installing new brake pads on toyota camry solara 2006 front rotors and pads and rear pads. Steering wheel would shake while breaking on 50+ miles per hour speeds. All fixed now.

Jun 22, 2010 | 2007 Toyota Camry

2 Answers

2006 Jeep Grand Cherokee grinding while steering


I'd bet your brake rotors are grooved and need to be resurfaced (or replaced if they are too thin). This also means you should replace the pads too.

Apr 03, 2010 | 2006 Jeep Grand Cherokee

1 Answer

I have a 2003 325xi........when i step on my brakes, the pedal pulsates like crazy and there's tremendous vibration. i feel like i won't be able to stop in time. it's really really scary! i got the front...


You can do a quick check yourself to see if the back rotors are warped. Warping is the most common cause of your problem and normally is the front rotors, but not necessarily the only one. All you have to do is block the front wheels of the car and jack up the rear one side at a time. With the wheel clear of the ground, turn it by hand for a few turns. If the rotor is warped you should feel some extra drag at some point when you are turning the wheel. Do both wheels and double check the front. I have seen new rotors that had to be turned because they weren't straight.
If you don't feel anything I would be inclined to look at the ABS because it can create a pulsation when it is working. Hope this helps.

Sep 07, 2009 | 2003 BMW 325

2 Answers

Vibration when stoping in brake pedel


probably not mechanical. i'd check into the anti-lock sensor.

Apr 25, 2009 | 2003 Jeep Grand Cherokee

1 Answer

When i use the brake, especially at high speds it makes a loud vibrating noise, the sterring wheel vibrates and shakes a little. this starting happening after i got al alignment and new tires put on. i...


The alignment would not affect your breaking as the alignment only controles the direction that the front wheels face. You may need to check your rotors and make sure they do not need replaced and check the breaks while you are at it. The pads should be evenly worn and the rotor should be evenly worn as well. There should be no deeps grooves in the rotor or break pads.

Nov 13, 2008 | Toyota Matrix Cars & Trucks

9 Answers

Frontend problem


that sounds like the pressure regulator of your brakes is broken. The pressure does not release from the left side.
Unless it is the calliper, but i think you already checked that out. Pressure regulator is the main cause for problems like this.
It regulates pressure between back and front side

Jun 27, 2008 | 2005 BMW 7 Series

Not finding what you are looking for?
1999 Lexus RX 300 Logo

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

905 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...