Question about 2001 Lexus LX 470

Open Question

Replace timing belt jeep cherokee crd 2.5lt sport

Corect timing set up

Posted by Anonymous on

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Old push rod broke I ment dont know how to set back on corect timing or if I have to ?

if all you did was replace a pushrod, than timing should be the same as before, provided you didn't change it. what engine is it. and if the rocker is adjusted improperly(too tight), it can cause the backfire. search valve adjustment for your engine.

Oct 07, 2015 | Cars & Trucks

1 Answer

How do i replace the distributor in a 91 firebird with 3.1 v6

Best practice is to remove #1 spark plug, roll engine over by hand until #1 piston at top dead center on compression stroke. Remove dist cap , find a surface outside of dist to mark direction rotor is pointing then mark dist body position. Remove dist ,you will notice as you lift dist, rotor will spin backward keep an eye on it, when the rotor stops spinning as you lift, that will be your dropin position for new distributor. That will get you close,enough to start car but you will need a timing light to set exact timing

May 01, 2012 | 1991 Pontiac Firebird

1 Answer

How to improve gas mileage on a 97 silverado 1500?

Make sure air presure in tires is corect.
Timeing is set proper.
And change the oil and use synthetic blend first time and full synthetic from then on .
You will see a change for the better. for sure

Mar 15, 2012 | 1997 Chevrolet K1500

2 Answers

How do i get my 1996 chevy tahoe distributer back in time

Remove #1 spark plug ( front left ) stuff shop rage in spark plug whole. use screw driver to helt stop up hole just bump starter a few times till you hear a POP that will be top dead center #1 check timing pointer and marks front pully adjust top cemter place dist. in appropriate pos with roter in corect position

Mar 22, 2011 | Chevrolet Chevy Cars & Trucks

1 Answer

Changed the water pump on the car and having trouble gettting it back in time

you need to get a chilton or haynes manual, so it can give you the correct location of the keyways for corect timing

Jul 03, 2010 | 1997 Chevrolet Cavalier

1 Answer

I need to know how to bypass my computer to set my timing on my 2.8l 93 s10

its been a long time since i worked on a mercury lynx but if i remember corectly it is on the firewal pasenger side behind the engine

Feb 13, 2010 | 1993 Chevrolet S-10

1 Answer

Cam belt timing 1994 Isuzu trooper big horn

no timing, cam belt must be installed corectly inorder to have right timing.

Oct 03, 2009 | 1994 Isuzu Trooper

1 Answer

How to check timing belt or set timing belt to the corect time

The timing light connects to the number one spark plug wire. (closest one to you on right side). Than aim light at crankshaft pulley. You will see a tiny arrow next to the crank shaft,
Shine the light with engine running. Point down exactly at arrow. You will see numbers flashing next to arrow on crankshaft. +5 0 -5
You want to arrow to be pointing on 0

Any car that has coil packs and NOT distributor is called distributorless. These cars are self timed by the computer. All the sensors in the car go to the computer. Than the computer adjust timing, fuel release and more.

May 20, 2009 | 1996 Dodge Intrepid

1 Answer

How to corectly set the timing on my 1996 Volkswagen Golf 1.8LACC

there should be a gap on the pulley, put the timing gun on the pulley and the gap should appear in the middle.

Mar 15, 2009 | 1996 Volkswagen Golf

Not finding what you are looking for?
2001 Lexus LX 470 Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts


Level 3 Expert

75822 Answers


Level 3 Expert

881 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides