Question about 1991 Chrysler LeBaron

2 Answers

Where is the fuel filter on a 1991 chrysler lebaron located

V6 convertable

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 3,679 Answers

Built into the fuel pump

Posted on May 16, 2014

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 71 Answers

Passenger side frame rail just before the fuel line heads up toward the engine/catalytic converter. Make sure car is cold.

Posted on May 16, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: i have 1991 Chrysler Lebaron

i called our local parts store and i was told the fuel filter is located on the passenger side of the car, past the back door, attached to the frame under the car! i was also told that the fuel pump access port is located under the back seat. we have had some really cold weather here in washington this past week and the parts person said that they have had about 5 calls per day about cars that won't start because of water in the gas filter that has frozen! so add a gas dryer and change the fuel filter and away we go! woohoo!

Posted on Dec 23, 2008

csmock132
  • 4669 Answers

SOURCE: Chrysler le baron 1991 3.0 V6

If all you did was remove the pan and service it then 3 and 3/4 liters will fill it. If it was rebuilt and has no fluid at all then it will take 8 and 1/2 liters

Posted on Jun 22, 2009

  • 127 Answers

SOURCE: 1989 Chrysler Lebaron 2.5 Turbo Running slugglish

hallo
check if you have a spark when engine dies. if not, check the rpm sensor or ignition coil. both have the simptoms like you describe.

marko

Posted on Oct 08, 2009

  • 1 Answer

SOURCE: My 1991 chrysler lebaron convertible with 119,000

I went through the sme thing. I replaced every sensor on the motor. It turned out to be a very dirty gas tank. I replaced it. And it runs like a top now.

Posted on Mar 12, 2010

  • 1024 Answers

SOURCE: I need a picture showing the location of the water

it's inside the timing belt cover. you must take all the drive belts and pulleys that in the way then remove the plastic timing cover.

Posted on Mar 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where do I find the fuel filter on an 89 chrysler lebaron


On 1989 Chrysler Lebaron 2.2L TBI 4cyl the Fuel Filter is located under vehicle, passenger side, below trunk area, next to fuel tank, mounted in fuel line.

Hope this helps; remember to rating this answer leaving a testimonial comments. Thank you for using Fixya.

Oct 17, 2011 | 1989 Chrysler LeBaron

1 Answer

Do u know the firng order for a 1991 chrysler lebaron convertible 3Liter 6 cylinder motor


Check this diagram for 1991 Chrysler Lebaron 3.0 liter SOHC V-6 VIN "3"

zjlimited_788.gif

Hope this helps (remember to rating this free answer and leave a testimonial comment).

Oct 12, 2011 | 1991 Chrysler LeBaron

1 Answer

Were is the location of the fuel injector on 3.0 liter engine - 93 chry lebaron convertable?


RIGHT ABOVE THE CENTER OF THE INTAKE MANIFOLD,COVERED WITH THE BIG AIR HOSE FROM THE AIR FILTER BOX. THAT IS IF IT USES THROTTLE BODY TYPE FUEL INJECTION!

Sep 09, 2010 | 1993 Chrysler Lebaron

1 Answer

Where is the fuel filter located and how do you replace it on a l994 chrysler LeBaron v6-181 3.0L


Take passenger side rear wheel off, put it on safety stand, and look along frame rail, ahead of, or near there, in fuel line, should be mounted to frame with one bolt through bracket on filter. Just have to pull/pry those little clips out sideways, to release, then pull fitting off, then snap them back in when new one installed. make sure you relieve fuel pressure up at valve on fuel rail. (cover with rag, so no spray in face, careful.)

Aug 08, 2009 | 1994 Chrysler LeBaron

1 Answer

Chrysler le baron 1991 3.0 V6


If all you did was remove the pan and service it then 3 and 3/4 liters will fill it. If it was rebuilt and has no fluid at all then it will take 8 and 1/2 liters

Jun 22, 2009 | 1992 Chrysler Lebaron

1 Answer

I have 1991 Chrysler Lebaron LE with a fuel problem. what i need to know is where the fuel filter is located and how much cold weather might have to do with this. thank you ever so much! katy


i called our local parts store and i was told the fuel filter is located on the passenger side of the car, past the back door, attached to the frame under the car! i was also told that the fuel pump access port is located under the back seat. we have had some really cold weather here in washington this past week and the parts person said that they have had about 5 calls per day about cars that won't start because of water in the gas filter that has frozen! so add a gas dryer and change the fuel filter and away we go! woohoo!

Dec 23, 2008 | 1991 Chrysler LeBaron

1 Answer

1992 Chrysler LeBaron 3.0 L. V6 Engine runs beautifully but after 16-20 miles highway driving engine stalls as if flooded, or as if fuel is cut-off. After sitting for a few minutes, will start and run...


the owner probably rerouted the fuel line because like my 92 chrysler lebaron v6 3.0 the fuel lines keep seeming to come off and the clamps always break. I have replaced the clamps 5 times in a month and replaced filters 2 times in 2 months. The only thing i could think of is that your fuel is being cut off possibly because there is no filter to clean all the junk out. Try putting a fuel filter on and see if that will work

Aug 02, 2008 | 1995 Chrysler LeBaron

Not finding what you are looking for?
1991 Chrysler LeBaron Logo

Related Topics:

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...