Question about 1999 Ford Explorer

Open Question

Pcv valve on a 2007 mercury Milan location on 2.4

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 24 Answers

SOURCE: PCV Valve location diagram.....

  I will assume you you have the Duratec engine (24 valve). It is located under the intake manifold on the transmission side of the engine. Real tough to get out without some real long pliers with a ring type end on it. It needs to be twisted counterclockwise to release it. replace the hose to it while you are there also , they degrade and will cause a vacuum leak.

Posted on Oct 19, 2008

  • 3 Answers

SOURCE: PCV valve location

if i know what you are asking, look at where you put your oil in. on the valve cover to the top right should be a plug with a tubeing runs to your air clear tube where the air mass sensor and carb is located. i think that is what you are looking for.

Posted on Nov 07, 2008

  • 94 Answers

SOURCE: where is the pcv valve located on a 2003 ford ranger

  • The PCV valve can be located in several places. The most common location is in a rubber grommet in the valve cover. It can be installed in the middle of the hose connections, as well as installed directly in the intake manifold.
  • Once the PCV valve is located, make sure all the PCV system hoses are properly connected and that they have no breaks or cracks.
  • Remove the air cleaner and inspect the air and crankcase filters. Crankcase blowby can clog these with oil. Clean or replace such filters.
  • Oil in the air cleaner assembly indicates that the PCV valve or hoses are plugged.
  • Make sure you check these and replace the valve and clean the hoses and air cleaner assembly.
  • When the PCV valve and hose are in satisfactory condition and there is oil in the air cleaner assembly, perform a cylinder compression test to check for worn cylinders and piston rings.
  • Posted on Feb 27, 2009

    • 121 Answers

    SOURCE: Where is pcv valve located on 2005 taurus

    It is below the egr valve close to the intake manifold below the intake air sensor, there is a tube running to it from the engine to recirculate exhaust air with fresh air, there is a clamp holding it to the air intake that you need pliers to remove, then you need to turn counter-clockwise 90 degrees to remove, do the reverse to install. to make it easier to access remove the upper intake. The pcv valve is not visible, however, you can identify it by the 3" inch long rubber hose that connects to the steel line running into the bottom of the intake. I have the part and am going to replace it soon, although Ford really makes it difficult to remove it -
    pcv valve is located just under the throttle body. remove air cleaner assembly from throttle body and you will see a u shaped hose running horizontally.

    Posted on Jan 27, 2010

    • 547 Answers

    SOURCE: pcv valve replacement on 2003 ford escort

    The valve is located under the thermostat housing facing the front of the car. There is very little room to work with here. You'll have to pull the hose up from the valve then pull the valve out.

    Posted on Mar 05, 2010

    Add Your Answer

    Uploading: 0%


    Complete. Click "Add" to insert your video. Add



    Related Questions:

    1 Answer

    Where is the fuel filter on a 2007 mercury milan. And how min are there?

    This car has one inline fuel filter, it is located under the car at the right rear, if you lay in front of right rear tire (passenger side) and look under the vehicle you might see it. You need a special tool to release the line. Any auto parts store will have the tools needed.


    Jul 01, 2016 | 2007 Mercury Milan

    1 Answer

    Where is my shift solenoid e located in my 07 mercury milan?

    Most shift solenoids are located within the transmission oil pan, it's not a simple fix...

    Feb 20, 2015 | 2007 Mercury Milan

    1 Answer

    How to clear vacuum hose on 2007 milan?

    if you know there is suppose to be vac.pull it off aand feel with your finger you can feel it.mechanics wire, carb cleaner with red supplied tube,maybe easier to splice new peice in.

    Aug 25, 2014 | 2007 Mercury Milan V6 AWD Sedan

    1 Answer

    Milan problems

    check the EGR valve and everything connected to it.

    Jul 17, 2014 | 2007 Mercury Milan V6 AWD Sedan

    1 Answer

    Location of thermostat on 2007 mercury milan 4 cyl

    Follow the upper radiator hose to the engine.
    The thermostat should be under the water outlet for the upper hose.
    Be careful with the o-ring seal if you take the outlet off.

    Jul 05, 2012 | 2007 Mercury Milan

    1 Answer

    Where is PCV valve located on 2008 Mercury Milan 2.3 L I4 cylinder? Do you have a diagram you could send?

    On valve cover on almost all vehicles




    They regulate crankcase vacuum only SO FORGET IT

    Aug 06, 2011 | 2008 Mercury Milan

    1 Answer

    2007 mercury milan factory remote start?

    I did the same thing twice, But i can't get it to start again. What gives?

    May 12, 2010 | 2007 Mercury Milan V6 AWD Sedan

    1 Answer

    2007 mercury milan factory remote start?

    I did the same thing twice, Yet i cannot figure out how it works. What gives?

    Mar 19, 2010 | 2007 Mercury Milan V6 AWD Sedan

    Not finding what you are looking for?
    1999 Ford Explorer Logo

    Related Topics:

    302 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts


    Level 3 Expert

    80608 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers


    Level 3 Expert

    5687 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides