Question about 1995 Volvo 850

1 Answer

Volvo 850 seatbelt won't pullout

Seat belt won't extend

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Volvo Expert
  • 412 Answers

You need a new belt unit. I have replaced 2 in my car.

Posted on Apr 15, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
repairpal
  • 128 Answers

SOURCE: 93` 850 volvo. no timming marks

If your timing belt belt broke, you have damaged the valves and the cylinder head will need to be removed and rebuilt, or replaced.

Posted on Dec 29, 2008

alicantecoli
  • 22219 Answers

SOURCE: seat belt 95 volvo 850

remove the door pillar trim and un bolt it.slide seat forewards and remove the door surround rubbers then take off the door pillar trim

Posted on Jan 01, 2009

  • 2 Answers

SOURCE: Replace seat belt

take off trim along lower door jamb, remove cover between doors. unbolt torques type bolt holding upper seat belt.same with the lower or floor connection bolt. need to buy large torques bit!! attn.. theres a elect. conn. to reconnect on the new or used belts, srs light may half to be reset at dlr. good luck !!

Posted on Jan 07, 2009

  • 39 Answers

SOURCE: 1996 Volvo 850 Timing Belt Replacement

the public library has a great online service. otherwise just take a picture of before and make the after look the same and mark the wheels so there in the same spot

Posted on Dec 06, 2009

  • 3 Answers

SOURCE: Seat belt stuck

I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

Posted on Mar 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 Volvo 850 the seat belt won't release so I can't put on my seatbelt when driving. Is this expensive to fix.


The locking mechanism is plastic and usually brakes apart inside. It needs to be replaced. Because it is a 96 model, I would not trust used parts. Buy new from Volvo. They run in the $200 range for the part.

May 22, 2012 | 1995 Volvo 850

1 Answer

A family member has a Volvo 850 (1996) and had a crash. Now the seat belt pretensioners have locked the seat belts solid. I've tried resetting the ECU, took it to Volvo and they wanted to replace the whole...


Hi,

That volvo and most of modern cars today uses a small explosive charge, placed in that retaining gear of seat belts. It will be activated to a collision.

To activate that seat belt, you must replace the whole retaining gear with that same type of safety precaution system.

The only way you could get a cheaper normal seatbelt is to replace it with an ordinary retaining gear lock, mostly Japanese seat belt or the older pre 1990 type that has no explosive charge.


Hope that clears everything and tightens up your problem!


Thanks for using Fixya!

Dec 16, 2010 | 1996 Volvo 850

1 Answer

'06 Volvo V50 drivers seat belt is jammed, there is no play in the belt and the ratchet locks immediatly no matter how gently it's pulled. Same problem with passenger side the day before but it righted...


I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

good luck and don't give up.

Feb 07, 2010 | 2008 Volvo V50

3 Answers

Seat belt stuck on 1995 850 volvo


I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

Dec 31, 2009 | 1996 Volvo 850

2 Answers

Driver seat belt will not extend out from door pillar.


I solved this on my 95 volvo 850 glt as follows:

pull the seatbelt pilar cover off from the door jamb. this runs vertically up the pilar between the front an back door (beside the front seats. Once opened loosen the belt by gently pulling the belt upward toward the roof. You'll have to do this sometimes in small increments. Once the seatbelt is pulled out all the way, spray small amount of lubricant into the joint where at the top of the belt spool. Also use a screw driver to push spool upward while pulling the belt. At first it's only going to release a little but eventually the lubricant will work its way into the seam at the top of the belt spool and loosen up the stuck inertia catch. Until it completely loosens you might have to remove the pilar cover again and work the seatbelt out (also use the screw driver technique described above) in order to use the seatbelt. When parking, I would relatch the seatbelt and pull the slack up around the back of the head rest. After a day or so it worked normally.

Nov 05, 2009 | 2000 Volvo S80

1 Answer

Driver side seat belt is fully retracted and will not release.


Try giving it a solid tap with something hard (screw driver handle) while jiggling the seatbelt.

Jun 01, 2009 | 1995 Volvo 850

1 Answer

Drivers side seatbelt retracter will not work volvo 1996


YOU HAVE TO UNTANGLE IT IT MAYBE TRICKY BUT JUST IN MY OPINION GET AUSED ONE FOR 10-20 AND DONT FORGET TO UNPLUG NEG BATTERY CABLE FIRST UNLESS YOU WANT THE SRS LIGHT TO COME ON

Mar 26, 2009 | 1996 Volvo 850

1 Answer

Seat belt 95 volvo 850


remove the door pillar trim and un bolt it.slide seat forewards and remove the door surround rubbers then take off the door pillar trim

Jan 01, 2009 | 1995 Volvo 850

3 Answers

Rear passenger side seat belt is stuck, and I can't work out how to get to the mechanism without damaging the seat.


If it is a 850 sedan like mine then you'll have to remove the speaker covers and then pull up the rear deck cover, then you can get to the mechanism.

Jul 27, 2008 | 1996 Volvo 850

Not finding what you are looking for?
1995 Volvo 850 Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...