Question about 2000 Ford Focus

1 Answer

2000 focus se heater fan is running all the time

2000 focus se heater fan is running all the time and switch will not adjust speed or turn it off

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Try to pull the nob off and see if you can turn it off with some pliers the nobs like to strip does it stay one when the car is off?

Posted on Jun 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 focus temp gauge fluctuate from norm to red when travelling at speed ..but all coolant levels ok and not loosing anything and fan working.


Hello, on your model the Head sensor sends a signal thru a resistor pak and the ECU. If the fan runs on high speed when you turn on the A/C then the resistor pak is good. If the resistor pak is bad neither of the fans will run when the A/C is on. Change the resistor pak.

If the fan runs on high with the A/C on, then the head sensor is not indicating a high temperature condition when the A/C is off. The A/C switch overides the head sensor. The head sensor is on the Passengers' side of the car above the Alternator. The head sensor is not throwing a signal to start the High speed fan. The head sensor is a long pin screwed into the head at that location.

While you say the fan is working, it may not be working well enough because of the head sensor.

Mar 13, 2011 | 2001 Ford Focus

1 Answer

Fan switch only has 1 speed, only works on high and drips water below glove box


THE BLOWER MOTOR RESISTOR FAULTY IF YOU HAVE ONLY 1 FAN SPEED ALSO AC AND HTR CONTROL SWITCH BAD.WATER LEAK UNDER GLOVE BOX COULD BE THE HEATER CORE LEAKING IF LEAKING ALL THE TIME WHEN THERE IS NO RAIN.

Dec 11, 2010 | 2001 Ford Focus

1 Answer

MY CAR BEEN LEAKING COOLENT AND NOW THE HEATER FAN ONLY WORKS ON 4 SPEED 123 WONT COME ON


leaking coolant has nothing to do w/heater fan. maybe just bad switch. check fan switch.do need to fix coolant leak to.

Nov 24, 2010 | 2000 Ford Focus

1 Answer

Removal of heater fan switch on dash.


Chances are it is in fact not the switch. These systems are wired so that at high speed setting battery power is connected directly to the fan. However lower settings switches through a set of resistors. These are mounted on a circuit board which in your case is mounted on the firewall on the passenger side of the vehicle under the wiper. Check this before you turn the control panel into a heap of spares on the garage floor.

Aug 02, 2010 | 2000 Dodge Caravan

1 Answer

Jeep cherokee 2000 heater fan does't run


If it doesn't run on any speed then check fuses and relay's under the hood in the power distribution box,if all are good then use a test light or volt meter on fan motor wires with fan switch set on high,if you have power there then replace fan motor,if the fan works on some speeds and not others than check the fan speed control module,it is located in the air duct on pass side below glove box.

May 03, 2010 | 2000 Jeep Cherokee

1 Answer

How to fix heater on ford focus tried a new motor


check the wiring to the reostat (the resistor that controls the fan speed) also check the reostat has not burnt out. (the reostat should be near the heater motor housing)

please let me know if this helps
cheers
big mike :)

Dec 18, 2009 | 2000 Ford Focus

1 Answer

The temperature guage on my 2000 focus auto is


you need to see where the temp sender is on the engine,and check the electrical plug ,it may be lose or dirty,make the obvious like battery terminals are tight and you havent washed the engine recently,as water will do this possibly gauge but unlikely

Oct 26, 2009 | 2000 Ford Focus

1 Answer

Heater fan only works on fastest speed


Your blower motor resistor has gone bad, it should be located next to your blower motor in the car, held in place with a couple of screws, remove it and replace it. The resistor is responsible for making the blower motor run at slower speeds than high or (4). Let me know if this helps.

Jun 16, 2009 | 2000 Ford Focus

Not finding what you are looking for?
2000 Ford Focus Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...