Question about Cars & Trucks

Open Question

How to change wiper motor in 2002 town and country van

Posted by Anonymous on

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

c17hydro
  • 2984 Answers

SOURCE: my 2001 Town and Country's rear windshield wiper

Pretty straight forward.....here are the steps:

Please don't forget to rate--

Rear Window Wiper Motor Removal & Installation To Remove:

  1. Disconnect and isolate the negative battery cable.
  2. Remove the rear wiper arm.
  3. Open the liftgate.
  4. Perform the following to remove the liftgate trim panel.
    • If equipped, remove the lift motor link
    • Remove the upper frame molding
    • Remove assist handle screws
    • Disengage the hidden clips around perimeter of liftgate trim
    • Disconnect the electrical connectors.
  5. Disconnect the wire connector from the wiper motor.
  6. Remove the wiper motor mounting screws.
  7. Remove the wiper motor.
To Install:
  1. Position the wiper motor in the liftgate.
  2. Install the wiper motor mounting screws.
  3. Connect the wiring connector.
  4. Install the liftgate trim panel.
  5. Close the liftgate.

Posted on Jul 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2001 town and country and the wipers will not turn off with the car turned off and i cant change the speed of them either


The wiper module is built into the the wiper motor. First unplug it(on the drivers side, just under the wiper cowling) Look for corrosion. Clean it with battery cleaner, the plug and motor connector. If it still acts up. replace the wiper motor.

Sep 01, 2015 | 2001 Chrysler Town & Country

1 Answer

How do you get to rear spark plugs to change


Depends on which van and motor but iv found from underneath van is easy..Some if you take wiper assembly out its access is better

Jun 16, 2014 | 1999 Chrysler Town & Country

2 Answers

Replace front blower motor on 2002 Town and Country van


once you have the 5 screws out , you should be able to grab the motor and give it a twist for it to come out..

http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0996b43f802d784e

May 12, 2014 | 2001 Chrysler Town & Country

1 Answer

Wiper motor r/r 2002town&country


FRONT IS UNDER COWL, PULL ARMS OFF, SMALL TORX SCREWS 8, SHOULD SEE MOTOR UNDER THE COVER, MOTOR AND TRANSMISSION, SWAP OUT OLD FOR NEW. THE REAR NEED TO REMOVE REAR LIFTGATE PANEL

Mar 04, 2014 | 2002 Chrysler Town & Country

1 Answer

My front blower on my 2002 Town and Country won't shut off. It blows full speed any time the van is running.


replace blower motor resistor located behind the glove box apro 2 x 3 in 2 screws and wire

Jan 19, 2011 | 2002 Chrysler Town & Country

1 Answer

2002 Chrysler Town and Country Rear Heat/Air only on High


most of the time the resistor is located downwind of the blower motor so it should be not to fao from the blower motor in the right rear of the van behind the quater trim panel which is the hvac unit is located

Jun 01, 2010 | 2002 Chrysler Town & Country

1 Answer

Need to replace a wiper motor on a 2002 chrysler town and country mini van. how is this done?


Remove the wiper arms (pop off the caps at the base) and the 15mm nut. Take out the screws that hold down the wind shield cowl lift it away to expose the washer hoses. Unplug the wiper motor (center driver's side) by pulling out the red clip on it and squeezing the tab. Remove the 13mm nut from the wiper motor idler arm and take out the 3 10mm bolts that hold it in place. Squeeze it out from under the wiper transmission, or loosen the lower bolts. You'll see them. Not a difficult job, just take your time.

Hope I've helped.

Mar 06, 2010 | 2002 Chrysler Town & Country

1 Answer

I have a 2002 chy. town and country van. the


check the connector at the rear view mirror for damage or pushout pins, the mirror contains the light sensor

Aug 31, 2009 | 2002 Chrysler Town & Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...