Question about 2006 Suzuki Swift

Open Question

Suzuki swift 02 plate sometimes won't start and immobiliser light flashing I leave it oft about 2 to10 mins then it starts when it happens the inside of car is hot due to sun how do I disable the immo

It has been quite warm here the last 3 days and the inside of the car is hot and the car starts briefly then cuts out and immobiliser light flashes I leave it for about 5 to 10 mins with car door open then it starts it is ok starting in the morning

Posted by Anonymous on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
johnjohn2
  • 5763 Answers

SOURCE: 2006 suzuki swift immobiliser light flashing and car not starting what can i do to fix it?

You may have a bad key chip, try a diffrent key in the ignition, also make sure you do not have magnet strip mini swipe cards on key chain near the ignition. this sounds like the immoboilizer system is active. this system will not allow the coils to spark.
The key would be the first thing to check. do this by using another key.if car still will not start then the key reader may be bad, this is located around the ignition . the last problem could be the module or a broken wire.The best way to check this would be with a scan tool. there will be codes stored in the anti or body module. the codes will tell you where the failure is and with some testing the problem can be found. the scan tool can help by reading the values and readings. it can tell you if the key chip is read and if the module accepts it. i think if the spare key does not start the car then it will be cheaper to have a shop diagnose the problem. this will help you from just putting parts in. also this anti theft system needs programing when certain parts are replaced.
hope this is helpful, good day

Posted on Apr 22, 2012

Ad
ericmorris69
  • 75 Answers

SOURCE: Suzuki swift ddi 1.3 oil light flashing when first

might need to reset sensor, my van does that every three thousand miles, computer controls that tracking of milage to estimate the next change, try this to see if it clears------turn on ignition so dash lights up ,right before you turn ignition for a full start,this is so the computer turns on( dont have car running) then pump gas pedal three full times and hold it down on a fourth for about ten seconds,( pump,pump,pump,hold), hopefullt this should reset the computer sensor. turn off car wait ten to fifteen seconds, and start normally, hopefully it should have the oil light on after that, if it does you might need to check with a mechanic.

Posted on May 07, 2012

danielm85948
  • 1449 Answers

SOURCE: 2001 suzuki ignis overheating,engine light illuminates

sensors wet or dirty .remove wires one at at a time and clean them .and clean the top of the sensors fuel is going rich .when doing this. and fowling the spark plugs.so clean them.






















Posted on Dec 19, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 ignis gl manual overhreating


Camshaft position sensor. I had the exact same problem. I changed it and it never stalled again.

Dec 18, 2013 | 2001 Suzuki Swift

1 Answer

2001 suzuki ignis overheating,engine light illuminates


sensors wet or dirty .remove wires one at at a time and clean them .and clean the top of the sensors fuel is going rich .when doing this. and fowling the spark plugs.so clean them.






















Dec 18, 2013 | 2001 Suzuki Swift

1 Answer

Suzuki m13a engine diagram


I HAVE SUZUKI SWIFT 1.3 WITH CHECK ENGINE LIGHT ON.IT MOVES FOR 2 KM AND SWITCHES OFF.IT STOPS FOR SOMETIME AND IT STARTS AND MOVES AGAIN.WHATS THE PROBLEM .DOES IT HAVE A CRANKSHFT SENSOR AND WHERE IS IT POSITIONED.PLIZ HELP

Oct 21, 2013 | Cars & Trucks

2 Answers

2006 suzuki swift immobiliser light flashing and car not starting what can i do to fix it?


You may have a bad key chip, try a diffrent key in the ignition, also make sure you do not have magnet strip mini swipe cards on key chain near the ignition. this sounds like the immoboilizer system is active. this system will not allow the coils to spark.
The key would be the first thing to check. do this by using another key.if car still will not start then the key reader may be bad, this is located around the ignition . the last problem could be the module or a broken wire.The best way to check this would be with a scan tool. there will be codes stored in the anti or body module. the codes will tell you where the failure is and with some testing the problem can be found. the scan tool can help by reading the values and readings. it can tell you if the key chip is read and if the module accepts it. i think if the spare key does not start the car then it will be cheaper to have a shop diagnose the problem. this will help you from just putting parts in. also this anti theft system needs programing when certain parts are replaced.
hope this is helpful, good day

Apr 22, 2012 | 2006 Suzuki Swift

1 Answer

Hi, I have a suzuki swift 2000 model, the key has snapped in the ignition, i have a used replacement ignition barrel and key. When fitted the engine turns over but won't start. I'm guessing th


This car has a chip key, you can't just put any old key in it it must be programmed to not turn on the security system and disable starting, which is what you have now, the system has locked you out.

Feb 10, 2012 | Suzuki Swift Cars & Trucks

1 Answer

1999 Suzuki Swift 1.0 Ltr, will not start no ignition lights, but it pickup and reads the key code. New battery 2 weeks old, headlights work,


is there a car starter on car sometimes the fuses burn or wires break under the dash and did you check all fuses and if i understand nothing happens when you try to start or it cranks but no start

Jan 07, 2011 | 1997 Suzuki Swift

2 Answers

Fiesta Diesel (Y Reg) intermittent starting(flashing immobiliser)


diesel ,,,just bypass the immobiliser ,20mins work

Feb 11, 2009 | 1999 Ford Escort

1 Answer

Chevy Tahoe 2004 Anti Theft Device has been activated.


leave the key on for about 5 to10 min then try to start. Are reset to computer by leaving the key on for 10 min and try to start the vehical.Do this procese 3 time then it shold reset

Jan 04, 2009 | 2004 Chevrolet Tahoe

1 Answer

2001 Suzuki Swift engine problem


Don't worry I'm sure you will get the solution of your problem, just check the link I attached 2001 Suzuki Swift Workshop Service Repair Manual

Oct 21, 2017 | 2001 Suzuki Swift

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...