Question about 1993 Dodge Ram 250

Open Question

How to open the hood on a 1993 dodge ram 250 when the cable is broken

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: removing speedometer 1992 dodge ram 250

I don't know if it's the same as my D150. But it's pretty simple:
1) remove about six screws from under the upper lip of the dash face bessal and one under the overhand above the radio.
2) carefully jimmy the bessal straight out. It has about four spring trim-clips that will release under pressure.
3) this exposes the speedometer instrument cluster. It is one big assembly (speedometer, fuel, temp and elctrical guages, etc) attahed with about six #2 phillips face screws. Remove these.
4) There are three back contections on the cluster: two electronic and one mechanical. Carefully start to pull the cluster out along the steering column until you see the shift indicator control line ( a small fishing-line with a hook on the end) attached to a small steel flang on the base of the steering column. This can be unhooked with your fingers or needle-nose pliers.
5) as you pull the cluster further out you can reach behind and unplug the two electronic connections. The round one simply pulls straight out. The last (rectangular) one has a pinch latch you need to compress to allow the plug to come out.
your finished!

Posted on Mar 11, 2009

Ad
  • 369 Answers

SOURCE: hood will not open due to the release lever on the

Problem could be the other end of cable came loose from hood release latch under hood. You need to look through the grill closely and see if it did. I have had a few dodge caravans that this has happend to.

Posted on Dec 05, 2009

gordanddar
  • 477 Answers

SOURCE: How do I open the hood if the release isn't

Pull the release while helper presses down then lifts on hood. If it opens , lubricate the latch assembly before you close it again.

Posted on Mar 12, 2010

  • 196 Answers

SOURCE: inside latch broke off 2002 dodge ram 2500 pu.how to open hood?

im taking a guess that the inside latch your refering to is the latch inside the cab of the truck, if so inspect the cable, can you see the metal cable inside the black housing, if you do take a vice grips and grab onto tightly and pull, this should release the mechinism same as if you pulled the latch, otherwise if you can see the cable within, crawl under the front of the truck, between the radiator and grill, reach up to the latch and disconect the cable that comes from the cab, it will be the only cable coming to the latch assembly, as you remove it, it kind of just clips in place, you will see what it pulls to release the latch, grab a screw drived and lightly force the piece over to pop the hood, i know it can be frustrating from experience, took me a while the first time, and they sure dont give you much room to work with, but a little patience will pay off with this , wish you the best of luck!

Posted on Mar 21, 2010

  • 1 Answer

SOURCE: my hood latch cable is broken under the hood. how

same thing has happened to me. How did you get it fixed?

Posted on Apr 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The hood releaser is broken. How can I open the hood of my 93' Dodge Shadow?


may can take grill out to get latch or go under it get some thing to pull latch their no other way . maybe can pull cable but where did it break at inside car or at latch if can get to cable w/visegrips pull it

Dec 21, 2010 | 1993 Dodge Shadow

1 Answer

Hood release cable is broken. how to get the hood open


you can either go from under front of vehicle, and use a few extentions to take hood latch off to open hood. or take grill off if possible to get hood open. from the inside of vehicle, if there is cable you can grab onto. just take a pair of vise grips and pull on cable. have a good day !!

Nov 20, 2010 | 1996 Dodge Ram 3500 Club Cab

1 Answer

1994 dodge ram van wont start


need to narrow the field a little,1st check battery connections,turn headlights on @ turn key to start, if lights dim,,starter drawing amps,could be bad starter, is fuel pump humming when key on? if not check fuses under hood for fuel pump relay if ticks when key turned on it's good. it's either a spark or fuel issue, hope this helps!!

Aug 15, 2010 | 1993 Dodge Ram 250

1 Answer

Pulled latch, but hood won't open on 97 dodge ram van


If you pull out on hood release & it feels like some resistance cable is not broken. Have someone pull release & hold pulled outward while you hit the front of the hood near grill, with palms of your hands. If it releases upward, release 2nd catch. Raise hood & locate plastic or rubber hood stops. There is one on each side of hood screwed into radiator core support. Raise each one an even full turn. This will allow it to release properly.

Jun 23, 2010 | 1997 Dodge Ram 1500 Club Cab

1 Answer

How do I open the hood if the release isn't working? It's a 96 Dodge Ram 1500. I don't know if the cable is broken, or needs adjustmebt.


Pull the release while helper presses down then lifts on hood. If it opens , lubricate the latch assembly before you close it again.

Mar 12, 2010 | 1996 Dodge Ram

1 Answer

How do i open hood on my 96 dodge 2500 when hood release is broken


Where did the cable break? Is it still visible? You can look where the hood release was and if the cable is still there you can use pliers to pull it so it will pop your hood. try that

or
lay on your back look up under the grill area of the truck, there is a mechanisim with a claw on it grab ahold of the cable going into the mech. once its open i suggest buying a new 1 or tie rope to a shorter piece of cable

Oct 12, 2009 | 1996 Dodge Ram 2500 Club Cab

1 Answer

Change dodge ram b250 parking brake cable


try all the major auto parts stores,like pepboys,autozone,advanced auto, & if not NAPA. All else fails,try the dealer ,if that fails try ebay.

Jun 28, 2009 | 1993 Dodge Ram 250

1 Answer

How do I install a new starter in a 93 Dodge Ram van B-250 8 cyl.


Park van so that you can safely access the starter. I use ramps under front wheels and put it in park and set the parking brakes. Disconnect positive battery cable at battery, disconnect starter battery cable and ignition wires from starter solenoid (remember terminal locations as these will attach to new starter solenoid). Remove old starter. Replace with new starter. Re-attach wiring in reverse order.

Mar 26, 2009 | 1993 Dodge Ram 250

2 Answers

Hood latch cable is broke and hood is shut how do i open


This is the hard case for any hood broke the cable, if the broken part is under neith your dash board, near the handle, probably you can manage to pull the broke cable and try to open it. but if the broken part in the front hood, probably you have to take to the garage to fix it.

I had two cases like this when I had my Union 76 Services Station in N. Hollywood 80s, it is a headache problem.

Jul 28, 2008 | 1996 Dodge Ram

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

108 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...