Question about Buick Park Avenue

1 Answer

How to flush out a coolant system?

Flush out

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Buick Master
  • 342 Answers

Pick up a coolant flush kit, they have everything you will need, including instructions

If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_4c166ba81493f541

Posted on Feb 11, 2015

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
SQUIRESXX
  • 486 Answers

SOURCE: no heat have flushed coolant system. replaced

CHECK THE HIGHT OF THE HEATER MATRIX IN THE CAB , IF ITS HIGHER THAN THE FILLER/EXPANSION TANK. THEN ITS AN AIR LOCK, LOOK FOR THE HIGHEST PIPE AND SEE IF THERE IS A BLEED VALVE, IF NOT TAKE BOTH PIPES OFF THE MATRIX FEEDS AND FLUSH OUT TO SEE IF IT IS BLOCKED, AND RECONNECT LOWEST PIPE FIRST AND FILL SYSTYM TILL WATER APPEAR FROM TOP AND RECONNECT RUN MOTOR, AND KEEP TOPIN UP.

Posted on Dec 05, 2009

  • 369 Answers

SOURCE: how to replace coolant system flush

there are kits that are inexpensive that you hook up to your rad hose using a garden hose that would be your best bet it will have instructions with it to tell you how to hook it up

Posted on Feb 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a blackish color in my coolant resevore. Is this due to due to demodox coolant or do i need a radiator flush done.


You mean DexCool coolant? If it's black, you need to flush the system and refill with the recommended coolant. A radiator flush only removes 1/3 of the coolant in the system. YOu want a full coolant flush.

Sep 23, 2017 | Cars & Trucks

Tip

How to Flush the Cooling System.


Normally the engine operates at 195F, unless you have replaced the thermostat with another one at 185F. If the temperature has a tendency to rise up, the reason is a partially obstructed cooling system or/and a bad thermostat.The first part of the cooling system that gives up is the heater core, because the coolant flowing channels are thin. It is the time for a coolant flush in your car. To do it right then you need time. Plan ahead for a weekend. With a cooled engine, start with the heater core hoses. Disconnect both of them, but the dirt has to go out of your car, so with a garden hose back flush it and let the dirt to get out of your cooling system. After you will get clean discharge,it is the time for coolant bottle, remove it, discharge the used coolant and clean it. The third to come is the radiator. Open the drain cook, or disconnect the lower radiator hose, and disposal used coolant properly. Now open the radiator cap and flush with water the radiator till discharge will be clear.You think that you are done? Not yet. There is half of old dirty coolant trapped in the system. Install everything, and connect all coolant system hoses, radiator, heater core and coolant bottle. Now you have to run your car with water. Fill out the cooling system with distilled water, start engine, turn on the heater high, and run till upper radiator hose get hot. That means the thermostat opens. Let the engine to cool down, open the radiator cap, and draining cook or lover radiator hose and drain everything. You can use flush detergent, if you wanted, at this stage, but flushing with detergent will add 4 more hours, because the detergent is colorless and you have to guess how many fill and drain processes to do, to get rid of it. I do not do it, but if your cooling system is very dirty you have to do it. After the last drain, fill the cooling system with concentrated antifreeze and 30% distilled water. The reason is because it is more water trapped inside the cooling system. The goal is to reach 50/50concentration. You need a coolant tester to find this. Start the engine and add coolant till radiator is full. Install the radiator cap and bleed the system. After driving you car for a day or so, let engine to cool down, open the radiator cap check the concentration of coolant with the tester, and add antifreeze or distilled water as necessary. It is a good idea to replace the thermostat while flushing the radiator. This procedure has to be done every 2 to 3 years. It is up to you to decide to use RED GM Dex-Cool or GREEN Prestone antifreeze. In all my cars I have replaced Dex-Cool with Prestone, but I flush the system every 2 years, and I never had a cooling system problem in all my cars.

on Nov 14, 2010 | Chevrolet Avalanche Cars & Trucks

1 Answer

Trans fluid ed in coolant bottle did flush and two week brown oily goo in bottle


Flush coolant system again. Do you have a brown sludge in the oil. Do this get Preston coolant flush, drain radiator drain coolant tank, fill radiator with water, add the Preston run vehicle for about 15 min remove lower radiator hose from radiator. This will allow all residue to be removed from engine. Replace radiator hose. Fill radiator with appropriate amount of coolant. Disconnect tank from system and let water run through tank until it is clear. Reconnect tank and you should be good. Unless you have oil and coolant mixed which means a blown head gasket or cracked block

Jun 14, 2017 | Cars & Trucks

1 Answer

How do you flush?


The cooling system?
Loosen the bottom rubber radiator hose and let the coolant run out.

Buy a can of coolant system flush. Reconnect the bottom radiator hose, pour the can of coolant flush in and top up with plain water. Drive the car for about 10 minutes until the engine is warm.

Then remove the bottom radiator hose and let the water run out.
Reconnect the bottom hose and fill the cooling system with coolant/water mix. Run the engine for 5 minutes and then check the coolant level

Jan 15, 2016 | Cars & Trucks

1 Answer

What is proper method for flushing the radiator and engine in a 1999 Pontiac Montana?


1: Drain coolant system
2: Purchase coolant flush, making sure you have the proper amount for your size of coolant system
3: Pour coolant flush into your radiator, filling the rest with water
4: On the coolant flush bottle it will tell you how long to run your vehicle
5: Once done running, let cool enough to open radiator cap, and drain system COMPLETELY by first draining out of pep **** on radiator, then taking one side of the hoses off the radiator and draining those
6: Put hoses back on and fill system with coolant. When the fluid gets to the top of the fill port on radiator, start vehicle and let run, allowing air to escape the system, and fill as necessary

Oct 27, 2012 | 1999 Pontiac Montana

1 Answer

What type of coolant goes in a Buick rendevous?


The original coolant used in your vehicle was DEXCOOL. It is a redish or orangish colored coolant. If it is grean it has been flushed to conventiional coolant. If you can not tell what color it is it is overdue for a coolant flush. It will make no difference if you use DEXCOOL or conventional coolant when you flush as long as you completely flush the system over to whatever you decide to use.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Jan 22, 2012 | 2004 Buick Rendezvous

1 Answer

I have purchased 2001 model Sebring Lxi. After driving just 20 miles I heard a sound of water boiling in coolant tank. Its too much boiling & sounds horrible. what should I do? Is this a serious Issue....


waterboiling in the coolant tank is not a good sign. water needs air to boil, and if you have air in the system, you are not getting the sufficient cooling you need to keep driving your vehicle. take it in to somewhere and havea coolant flush performed on it. if you would rather do it yourself, you can drain the coolant, fill with new coolant and add some coolant flush to the new coolant to clean out the system. NOTE. DO NOT leave coolant flush fluid in vehicle. You must remove the old coolant and fill with fresh coolant and bleed the system of any air to prevent your boiling. hope this helps.

May 12, 2011 | Chrysler Sebring Cars & Trucks

1 Answer

How do you flush out the coolant system in a 2003 Implala 3400 V6


the thermostat housing is located where the radiator hose connects to the engine. you'll need a flush kit to flush it out, it comes with instructions

Jul 04, 2010 | 2003 Chevrolet Impala

1 Answer

How do I flush the coolant on a Golf 5 I need to to perform a coolant flush on my 2004 Golf 5. I have the 3 litres of G12 coolant and radiator flush. Is there anything in particular that needs to be done...


take of the top heater hose, use a funnel to insert flushing agent connect hose and flush through.with radiator cap off.take off bottom hose to radiator to drain system,reconnect all hoses,fill expansion tank to fill system...

Feb 11, 2010 | Volkswagen Golf Cars & Trucks

1 Answer

Jaguar X type Water Pump


if the pump is leaking then it needs replacing it sounds like someone in the past has introduced glycol based coolant in to a oat. organic acid tech coolant system THEY DO NOT MIX and go like brown jelly and block things up like heater/ac systems it needs a good flush using a cooling system flushing adative

Mar 22, 2017 | 2006 Jaguar X-Type

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...