Question about 1997 Toyota Corolla

Open Question

What is the cause of samp compression - 1997 Toyota Corolla

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes misfires?


If the misfire is on one a particular cylinder or perhaps 2, these issues need to be addressed and checked...
1. Power to the spark plug.
2. Coils and spark plug condition.
3. Fuel supply to the cylinder
4. Air supply to the cylinder
5. Correct fuel/ air mixture to the cylinder
6. Cylinder compression. Low compression or a cylinder compression level below spec will result in a misfire. If the compression tester shows low compression in a cylinder the causes of the poor compression reading then need to be addressed.

The fault codes generated by the computer and read by an appropriate scanner will tell you which cylinder or cylinders are misfiring.

Nov 14, 2015 | Cars & Trucks

1 Answer

I have60# in #1cylinder 150# in # 2 cylinder 150# in # 3cylinder 90# in #4 cylinder will that caus a no start


that will not cause a no start you need to look at vehicle manual to determine your vehicles compression ,what caused you to check compression for a no start?

Jan 19, 2015 | Cars & Trucks

1 Answer

How to remove a mazda 626 samp


Do you mean the sump. If so remove the engine.

Apr 17, 2014 | Mazda 626 Cars & Trucks

1 Answer

My toyota tazz 2006 model is leaking oil from underneath ,i went to the mechanics and they removed the samp and put new gasket seal still its leaking.Every 2 weeks i have to buy 5 litres of oil


If its still leaking from the pan gasket then replace the pan and also check if the PCV positive crank case valve is NOT blocked as there could be lot of pressure building up in the engine.

Nov 03, 2013 | 2005 Toyota Tazz 130

1 Answer

Loose compression engine


Not sure what loose compression is, but low compression would not be affected by changing the plugs unless the wrong plugs were installed.
The timing belt may have broken, but again that would not be caused by replacing the plugs. I would run a compression test to verify the problem.

May 29, 2013 | Mazda MPV Cars & Trucks

2 Answers

How to line up the cams?to put on timing chain.


Click on the following direct, free Link. It has the Timing Belt + Mark Diagrams for your 1999 Isuzu Trooper. It also has additional - very helpful Instructional and Directional Diagrams and Procedures including how to line up the Cams.

Let me know if this helped, or if you have additional information or questions. Feel Free to contact me at FixYa.com!



http://www.2carpros.com/car_repair_information/year/1999/make/isuzu/model/trooper/1999_isuzu_trooper_timing_belt_diagram_marks.htm

Apr 27, 2010 | 1999 Isuzu Trooper

1 Answer

Why is my oil signal keeps buzzing on my speedometer?


Could be your oil pressure switch is bad also could be depending on the mileage worn oil pump.What weight of oil are you running if it is a diesel you need 15w40 or equivalant.Try running a heavier weight oil.

Oct 19, 2009 | 1998 Volkswagen Jetta

Not finding what you are looking for?
1997 Toyota Corolla Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...