Question about Chevrolet Express

1 Answer

2010 chevy express 2500 passenger turn and brake not working

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Chevrolet Expert
  • 259 Answers

Bad bulb

Posted on Apr 23, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 115 Answers

SOURCE: pulsating and vibrating brakes on 2003 chevy express, new pads and rotors

Rust build up is commonly found on the hubs sandwiched by the rotors/hubs

Posted on Sep 05, 2009

  • 4340 Answers

SOURCE: I have A 2000 Chevy 3500 Express Van and the brake

Hi,

When you said that you checked the brake switch, did you check it live? Meaning verified live power to the switch, press switch, and then power came out the other terminal?

If so, also verify zero power on brake press, at the offending brake light bulb terminal. You must verify the test light each time you move it...leave running lights on...

After verifying that there is no power coming, after the brake is pressed, note the wire color and find it where it comes to the steering column and test there... This would eliminate wires and connections between front and the rear of the vehicle, unlikely, but needs to be tested.

After verifying no power at that terminal, then yes the t/s switch is certainly suspece. This may be the time to get a mechanic to verify and replace the switch, there are locks, tilt mechanisms, air bags, column bearings, etc involved. Failures risk loss of vehicle control (locking or binding for example.)..

Hope this gets you going in the right direction.

Posted on Sep 09, 2009

Testimonial: "Thank You. I tried those things and it seemed to be the Emergency Flasher switch in the multi function switch."

  • 12173 Answers

SOURCE: 2004 chevy 3500 express passenger van transmission

if ur replacing it remove front grill disconnect both lines and carefully remove retaining clips from radiator if replacement is original eguipt mount & reconnect --if its a universal follow instructions usually cut off fittings and use clamps and hose to hook up

Posted on Oct 27, 2009

  • 310 Answers

SOURCE: Chevy express 1500 can 2500 coil springs fit or the leave spri

yes they will fit. be careful use all the suspension parts, life springs coils a-arms upper lowers its a all day projected get a coil spring compresser

Posted on Jan 29, 2010

Testimonial: "Thanks for the info "

  • 1 Answer

SOURCE: how to replace brake light in 2008 chevy express cargo van

Yes, the snaps are hard to remove. I would suggest that once you get the old snaps out, go to an automotive store (Pep-Boys) and find a different style snap, to make it easier the next time the bulb needs to be replaced.

Posted on Oct 23, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is the Headlight switch for the Chevy Express 2500 defective


The replacement switch could be defective.

Jan 30, 2015 | Cars & Trucks

1 Answer

Where is the Body control module location 2008 Chevy express 2500?


It is tucked up under the dash on the passenger side. You will have to remove the passenger knee bolster which is retained with 2 screws along the bottom and a few clips at top.

Dec 29, 2014 | 2008 Chevrolet Express

1 Answer

Body control module location 2008 Chevy express 2500


body control module is on the passenger side of the dash - remove the passenger lower knee bolster and its directly behind it.

Dec 29, 2014 | 2008 Chevrolet Express

2 Answers

Body control module location 2008 Chevy express 2500


Body Control Module (BCM) is located in the
Lower right side of the instrument panel behind the knee bolster !

Dec 29, 2014 | 2008 Chevrolet Express

1 Answer

No brake, turn signal, or flashers at rear of 2006 chevy express 2500


Sounds like a bad turn signal switch. I bet if you wiggle the turn signal lever while you have your foot on the brake pedal the left and right brake lights ill intermittently work.

Apr 09, 2013 | 2006 Chevrolet Express Cargo

1 Answer

2006 chevy express 2500. While changing the brakes on my van, a rivet and clip pulled through the rear wheel dust plate, I'm unsure on how to fix this as now one half of the shoe is rubbing agains


get a washer welded in its place but if you dont want to go that way you will need to pull the brake shoes the drive axle just to get to the backing plate so you can remove the old one and install a new one

Jan 16, 2013 | 2006 Chevrolet Express

1 Answer

Left rear turn signal and brake light not working. fuse is good, bulb is good. back-up lights work.


I have a 2007 Chevy Express with the same problem. Just happened. Brake and turn signal not working on left side. Fuses good, bulbs good (dual element lamp, turn signal and break are same element) running lights work (other element) Relay blinks fast and not getting voltage at light for blinker or brake. Is there something else in the circuit I need to check. Took it to an ASE mechanic and he couldn't or didn't want to fix it. THANKS Let you know if I fix it tomorrow.

Jul 31, 2011 | 2007 Chevrolet Express Passenger

1 Answer

I have a 1999 chevy 2500 classic with a diesel and the passenger side brake and turn signal stopped working replaced the bulb still nothing and the running lights work i am stumped


Typically, this is an indicator that the turn signal switch on the steerint column is bad. The switch can be removed and looked at and it will look perfect, but somehow it is burned out or otherwise inoperative. Been there, done that.

May 01, 2010 | 1999 Chevrolet C/K 2500

2 Answers

Reverse and interior lights out, chevy express van


Fuse block under the hood. Driver's side, under the brake master cylinder. Number 18. TCB#2. Replace the fuse.

There is an under-engineered ground in the reverse circuit. If you back up with the dome lights on, it could blow that fuse. There should be some extra fuses under the cover of the fuse block.

Apr 25, 2010 | 2007 Chevrolet Express Passenger

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...