Question about 2009 Chrysler Town and Country

1 Answer

2009 t&c blower fuse relay location

Blower motor relay location

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 52 Answers

It depends if you have auto a/c or manual. All power comes from the integrated power module under the hood. There is no front relay, but the rear blower has a relay, which is in the same module.

Posted on May 15, 2014

Testimonial: "what are the controls for the front fan to work, as in relays fuses controllers"

  • emchugh107
    emchugh107 May 15, 2014

    where are they and what is the most common fix

  • spikedude41
    spikedude41 May 16, 2014

    The control sends a ground signal through the blower resistor and then to the motor. The other side of the motor is a constant 12volts from the module.

×

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dgjtex
  • 405 Answers

SOURCE: Front blower motor doesn't work, rear does

yes, all blower motors have them to control their speed, High, medium, low.. etc. I earn nothing by helping you, but my rating, a fixya rating and I will walk you through this

Posted on Dec 20, 2008

  • 1596 Answers

SOURCE: 2005 Town Country front blower motor inop fuse/relay ok

Break Down And Replace The Blower Motor


REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIR-BAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN AN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY OR DEATH OR DEATH.

NOTE: The blower motor is located on the passenger side of the vehicle under the instrument panel. The blower motor can be removed from the vehicle without having to remove the HVAC housing.

  1. Disconnect and isolate the negative battery cable.
  2. Remove the passenger side cowl trim panel.
  3. Position the carpet to access the front upper screw that secures the air inlet housing.
  4. Remove the recirculation door actuator.
  5. Disconnect the blower motor wire lead connector from the blower motor resistor or power module, depending on application.
    1. Remove the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing.
    2. Remove the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and remove the lower HVAC housing.
    3. Push the rubber grommet through the opening in the lower air inlet housing.
    4. Route the blower motor wire lead through the opening in the lower air inlet housing and remove the lower air inlet housing from the vehicle.
    5. Position the recirculation-air door as necessary to access and remove the three screws that secure the blower motor to the lower half of the HVAC housing.
    6. Gently flex the recirculation air door downward to gain access to remove the blower motor from the HVAC housing. NOTE: To aid in installation, note the position of the blower motor mounting tabs prior to removal
      1. Remove the blower motor from the HVAC housing by rotating and tilting the blower motor as necessary.
      INSTALLATION

      1. Gently flex the recirculation-air door downward to gain access to install the blower motor into the HVAC housing.
      2. Position the blower motor to the HVAC housing and tilt and rotate the blower motor as necessary to install it into the HVAC housing.
      3. Align the blower motor mounting tabs to the locations noted during removal and install the three screws that secure the blower motor to the HVAC housing. Tighten the screws to 2 N·m (17 in. lbs.).
      4. Route the blower motor wire lead through the opening in the lower air inlet housing and seat the rubber grommet.
      5. Position the recirculation door pivot shaft into the lower air inlet housing and install the inlet housing.
      6. Install the four screws (from the bottom) that secure the lower air inlet housing to the upper air inlet housing and the lower HVAC housing. Tighten the screws to 2 N·m (17 in. lbs.).
      7. Install the one screw (from the top) that secures the lower air inlet housing to the upper air inlet housing. Tighten the screw to 2 N·m (17 in. lbs.).
      8. Connect the blower motor wire lead connector to the blower motor resistor or power module, depending on application.
      9. Install the recirculation door actuator.
      10. Reposition the carpet.
      11. Install the passenger side cowl trim panel.
      12. Reconnect the negative battery cable.
      13. Perform the heater-A/C control calibration procedure.

Posted on Feb 07, 2009

  • 323 Answers

SOURCE: Where is rear blower motor located on a 1997 Town

It is behind the right rear quarter trim panel in the heater housing.

Posted on Apr 25, 2009

  • 100 Answers

SOURCE: 2001 Town & Country lxi. Front blower

Ummm if the blower motor is bad it's a ***** to replace, I'd spring for a dealership repair to replace the motor
try this (But I doubt it) look under the hood on the firewall near the far right side, if you see the back of the blower motor, whack it with a hammer, this may work and it's tmporary at best, if you're very lucky the blower can be unbolted and removed on he engine side, but that's rare
Sorry

Posted on Aug 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004. Why is the blower motor not receiving power?


The blower motor relay in the auxiliary junction box under the hood is good ? All relays ? only one controls the blower motor ! The electronic automatic temperature control module turns it on by supplying a ground inside the module ! The 30 amp fuse for the blower motor is located in the under hood auxiliary junction box ! At the relay socket test for battery voltage at pins 30 an 86 ,power form 30amp fuse ! The other two pins 85 an 87 ,85 is circuit to the electronic temperature control module . You could test this part of the circuit too , with a test light or volt meter . But if no voltage to the blower motor ,could be the electronic temperature control module is bad ! VEHICLE RELAYS Operation Diagnosis

Jun 11, 2015 | Lincoln LS Cars & Trucks

1 Answer

Blower control relay location


Must mean the motor is going bad. If it happens again and whacking it don't help, you'll need to replace the blower motor. If the blower resistor goes bad, the blower still works on high only.

May 15, 2014 | 2009 Chrysler Town and Country

1 Answer

Where is the blower fuse


The blower motor resistor is behind the glove compartment. The blower motor relay is under the hood in the fuse panel.

Feb 27, 2013 | 2009 Jeep Liberty

1 Answer

Hi , I have a 2009 Ford E250 van and all of a sudden the switch that controls the blower motor doesnt activate the blower. I have heat if the vehicle is moving , but its not blowing heat from the vent


There is a fuse, may not be solely for the blower but it has to be fuseed! Anyway I would suggest checking all fuse's both inside and outside boxes first then locate blower relay swoop with the one next to it and test blower if its stil not working its the fan speed switch! They gave trouble on previous models! ! You'd be very unlucky for a 2009 fan motor to fail...good luck.

Jan 22, 2013 | Cars & Trucks

4 Answers

Blower stays on when car is turned off won't stop running until I disconnect the battery cable, tried the blower fuse that didn't work. 1995 olds auroa


If you pulled the 10 amp fuse in the I/P fuse block and the blower still worked than the the blower motor module is most likely the problem. It is fed by a 30 amp fus4e in the fuse block under the rear seat. That fuse is always hot and always supply power to the blower motor module. If you pull that fuse and the blower stops than it's pretty likely the blower module is the problem.

The blower module is located near the blower motor. It is usually held in place with 2 screws and will have four or five wires at the connector.

May 10, 2011 | Oldsmobile Aurora Cars & Trucks

4 Answers

Heater on my envoy only works on 3-4 setting, could that be the switch.


Thanks for the opportunity to let me help. The blower control switch in your vehicle also uses a blower relay. This relay is generally located on the firewall on the passenger side near the heater fan. You can also look in you vehicle owners manual for the location of the blower relay, it may be also be located in the fuse and relay box under the hood. Generally speaking if the highest setting doesn't work on a GM vehicle it is a high blower Relay. This item is not expensive and can be purchased at most all you local Auto parts stores. If you have a Napa, Orielly's, or AutoZone these stores will also likely help you in the location if you are unable to locate this relay. Here is a general picturepepsiman1967.jpg The installation of this relay is either to remove from the fuse box, or if located near the heater fan housing then you will need to remove the mounting screws, remove the wiring clip, then reverse to install. I hope that this has helped you. D.R. Wilkins

Nov 05, 2010 | 2004 GMC Envoy

1 Answer

I have a 96 dodge grand caravan with front and rear heat and air . i am looking for all the fuse and relay locations for the front blower motor ? the rear heat and air work but the front blower motor wont...


#26 40 amp orange fuse ---it is under the hood of vehicle in fuse box. Relay labeled "F" in passenger comp on juction block behind left side of dash is for rear blower motor, front blower motor relay is behind juction box.

Jun 17, 2010 | 1996 Dodge Grand Caravan

2 Answers

Where is the blower motor relay on 95 accord


on the very top of the fuse/relay box in driver's side kick panel. on the very top of the fuse/relay box have 3 relay , the blowe motor relay is the center one.

Jul 24, 2009 | 1994 Honda Accord

1 Answer

Blower motor relay location


UNDER THE DASH EITHER THE RGT OR THE LEFT,,,,IT WAS ON A 93

May 15, 2009 | 1994 Honda Accord

Not finding what you are looking for?
2009 Chrysler Town and Country Logo

122 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...