Question about Cars & Trucks

1 Answer

02 xterra 3.3 ac clutch only engages when jumped across at relay full of Freon relay AMD fuses are good

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 156 Answers

Check to see if you have power at your AC, then have to check to see if you have power and ground at relay pins, if not trace wires, also your relay could be bad to

Posted on May 15, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

chiquititas
  • 1010 Answers

SOURCE: air conditioning

here is a link to your problem and a solution:
http://en.allexperts.com/q/4-Wheel-Drive-2700/2008/5/C-Clutch-engaging.htm

Posted on Jun 19, 2008

66 chrgr
  • 1011 Answers

SOURCE: cannot find relay center in 1990 corvette

check the low side switch located on the ac receiver drier for 12 volts if so jump it with a paper clip if the compressor comes on then the relay is good if not the relay is in the fuse junction box under the hood.Most likely the pressure sensor.

Posted on May 23, 2009

Molson02536
  • 3854 Answers

SOURCE: where is AC clutch relay located?

Check the A/C pressure in the line, you should have 100-105PSI with the engine not running and if you have less then 45 PSI in your system. The A/C will not activate to ensure the compressor does not seize when the clutch activates.

Thank you for using Fixya and good luck




Posted on Apr 05, 2010

  • 138 Answers

SOURCE: 2007 passat ac compressor will not engage doesnot

Check the Aircon pressure switch, try another if possible. Switch located on Aircon condenser behind front bumper. Either a to high or to low pressure in the system will prevent the compressor from engaging. Pressure switches do go faulty at times.

Posted on Jun 05, 2010

zoomer1955
  • 34 Answers

SOURCE: I have a 2001 jetta ac clutch not engaging freon

Check to see if the wires on the fan module are corroded. The fan module is under the battery. Easier to see from under vehicle. Also check the fuses first.

Posted on Apr 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

AC fuse and relay for 2001 Ford Expedition


Pull a relay out and use paper clip to jump. Usually cross corner. Watch compressor clutch and see if engages when key is turn ahead. Don't start car. If it does good. Now take alligator clips and check relay. Clip each wire to negative and positive battery post. Then clip negative to negative relay pin. And touch positive to correct pin. If it doesn't click do it another relay so you know your doing it right. If determined relay is good. And your compressor clutch did engage when testing it. You are low on freon.

Jul 11, 2016 | Ford Cars & Trucks

1 Answer

Subaru tribeca air conditioner not working


Check the power going to the compressor clutch with the AC switch on.If there is votage across the clutch, it may be bad. Not engaging.
If no voltage, you have test the circuit to see why no volts are there.

May 13, 2014 | 2006 Subaru B9 Tribeca

1 Answer

Ac clutch not engaging on a 2004 ford escape


A mechanic would check for voltage at the fuse and relay, and also check the system to see if it is full of freon. If the clutch has voltage and ground it may need to be replaced.

Jul 30, 2012 | Ford Escape Cars & Trucks

1 Answer

Location of ac relay 1996 S10


My Chevy S10 AC clutch is not engaging... new compressor and dryer and hoses...new relay fuse in engine compartment...could putting more freon in help it engage?

Apr 09, 2012 | 1996 Chevrolet S-10 Pickup

1 Answer

A/C compressor on 95 astro van does not engage at all.


There are a few reasons for the compressor not engaging. Lets start with the most common. low ac gas.A bad clutch on the compressor.Blown fuse.
Let is start with testing for low gas. (134a freon).Locate the dryer. this is on the passenger side of engine compartment. it looks like a tall cylinder, on the top side you will see a switch. unplug switch connector and jump the two terminals in connector with a piece of wire, this is the low pressure or cycling switch. you will be completing the circuit by jumping a wire across the terminals.If the compressor turns on when connectors are jumped then you are low on gas and the system needs recharging.
If the compressor does not urn on then check all fuses, if fuses are good then the next step is to go to compressor and test for power and ground. If you have power and a good ground on the connector to compressor then compressor clutch is bad.A bad clutch will some times blown fuses, so if you replace the fuse because it was blown and it blows again then clutch is bad.
Another test that will help is when you remove the connector from the cycling low pressure switch , test the connector. one wire on the connector should have power when ac is turned on,
Hope this helps let me know what the outcome is. Good day.
I have enclosed a picture of the switch and dryer to help you locate it.If you jump the terminals

Mar 23, 2012 | 1995 Chevrolet Astro

3 Answers

Air conditioning


If there is no r-12 or freon in the system it wont come on. Try jumping the pressure switch. It's a 2 wire plug somewhere one the AC lines. Just pull it off and jump the wire end with another wire.If the clutch engages you need freon or R-12.

Jul 25, 2009 | 1996 Chevrolet Corsica

2 Answers

The compressor is not engaging on 96 pontiac transport van


Check wires going into it from harness.. make sure there is no break.. If not have compressor checked at autozone or advanced auto.

Jul 04, 2009 | 1994 Pontiac Trans Sport

1 Answer

Ac problem


if the compressor is not engaging,the clutch on the front of compressor may be faulty..remove a/c clutch relay from fuse block underhood and jump relay pins 30 and 87 with engine running..clutch should engage..make sure you have power on pin 30
you may have a faulty a/c pressure transducer

Jun 20, 2009 | 2002 Dodge Stratus

1 Answer

Cannot find relay center in 1990 corvette


check the low side switch located on the ac receiver drier for 12 volts if so jump it with a paper clip if the compressor comes on then the relay is good if not the relay is in the fuse junction box under the hood.Most likely the pressure sensor.

May 23, 2009 | 1990 Chevrolet Corvette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...