Question about 1996 Chevrolet S-10 Pickup

1 Answer

Where fuel relay 1996 chevy s10? - 1996 Chevrolet S-10 Pickup

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 2,355 Answers

Gas tank

Posted on Mar 16, 2015

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 371 Answers

SOURCE: having problems with chevy s10 replaced fuel pump

Check the cable that goes from your battery to the fuse box the relay that is clicking is on. Check for lose bolts or corrosion of the contacts or something like that. If the relay is clicking it sounds to me like it is a voltage issue going to the relay.

Posted on Oct 06, 2009

  • 3741 Answers

SOURCE: Where is the turn signal relay on a chevy s10

On 95-97 and 1998, both the turn signal and hazard flashers are located behind the lower dashboard trim just to the left of the cigarette lighter. You can not get to it without taking apart the trim (stupid design). Or you have to drill a 2" diameter hole in the trim with a velcro cover so you would never have to do it again1999 and later it is under the glove compartment
to disassemble it without drilling
It's behind the panel to the left of the cigarrette lighter. You need a Torx 25 screwdriver and another screwdriver for those hex shaped screws, forgot the size. First unscrew the 2 Torx 25 screws beneath the steering wheel. Then unscrew the rest of those Hex screws on the bottom. The panels overlap, so be prepared for a lot of unscrewing. You do need to unscrew the middle black panel on the bottom, right beneath the cig lighter. It's held by two Hex shaped screws, one on each side and are hard to unscrew. Also you need to remove your spare change sliding tray to unscrew the last hex looking screw. Once you pop your panel off, the turn signal flasher is the right one. The Hazard flasher is the left one. You can find a replacement part at Autozone, and DON'T get the $184 Flasher switch, all you need is the signal flasher. It's shaped like a cylinder with TWO prongs on it.

Posted on Nov 03, 2009

  • 1 Answer

SOURCE: where is the fuel pump relay fuse on my 1996 chevy

1997 S10 Blazer cranks but wont fire.

Posted on Feb 23, 2010

  • 180 Answers

SOURCE: I have a 1993 chevy s10 4.3l TBI that will not start.

Make sure the injectors are pulsing. Whatch to make sure mists oj fuel are coming out.

Posted on Apr 01, 2010

  • 836 Answers

SOURCE: 1987 chevy s10 fuel pump

The fuse feeds the relay, if the relay is clicking it has power, try replacing the relay before you do anythuing else. [ check the numbers on the relays in the box there may be another what's the same.

Posted on Jan 12, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What would cause you to lose fuel pressure while driving.


Chevrolet S-10 Questions - Fuel System Loses Pressure ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusJul 28, 2012 - Fuel System Loses Pressure - I have a 2003 Chevy S-10 Pick Up with the 4 ... car a few times, what essentially you are doing is priming the fuel pressure. ... A dirty fuel filter will not cause the lines to lose pressure after the engine is shut off. ... I have a 98 s10 2.2 liter and it was driving fine all day then when ...

Chevrolet S-10 Questions - My 2001 S10 has a hard starting ...

www.cargurus.com > Questions > Chevrolet > S-10

CarGurusSep 16, 2012 - My 2001 S10 has a hard starting problem if the truck sits between 1 ... Vacuum leak, have you checked fuel pressure while it sits? ... Would the spider alsocause a misfire at low rpms? .... at an idle, or squeaking while driving and it gets faster as you go? ..... 1994 Chevrolet S-10 2 Dr STD Standard Cab LB.

Chevy S-10 Won't Start - Repalced Fuel Pump and Pressure ...

www.cartruckinfo.com/chevy-s10-wont-start.html
Chevrolet S-10 pickup won't run and has no fire unless I jumper the fuel pump relay. ... Once the truck starts and is running you can remove the jumper to the fuel pump ... Iwould get the fuel pressure checked to start with, because that's where the ... 93 gmc 4.3l FI runs but dies out loss of power after 5 mins of running then ...

Stalling S10: I Have a 1994 Chevy S10 2.2l It Stalls After 35 ...


Dec 10, 2015 | 1994 Chevrolet S-10

1 Answer

Where is location the fuel pump relay in my chevy s10 1996


Start by resetting the INERTIA SWITCH. The location of the inertia switch will be found in your OWNER'S MANUAL. If you do not have your Owner's Manual, check online.

Sep 06, 2014 | Cars & Trucks

1 Answer

Where is the fuel pump rely on a 1994 chevy 5.7 2500 4x4


your problem moest likely not relay need to cheak fuel pressure and spark control modul e egr valve could be stuck also I had the same problem with my 1993 s10 relay is under the hood usely on the right side on the firewall

May 30, 2014 | 1996 Chevrolet Blazer

1 Answer

Where is the fuel pump fuse located on a chevy s10 1996 pick up


Fuel pump relay gets power from the ECM Batt fuse number 9.

Dec 06, 2012 | Cars & Trucks

1 Answer

Location of ac relay 1996 S10


My Chevy S10 AC clutch is not engaging... new compressor and dryer and hoses...new relay fuse in engine compartment...could putting more freon in help it engage?

Apr 09, 2012 | 1996 Chevrolet S-10 Pickup

1 Answer

Chevy 1996 s10 wont start it turns but that's it we replaced the fuel pump and the crank sensor. Now what do we do.


test 1- sit with driver door open,turn key to ON not start- listen for fuel pump whine as it pressurizes system- if no whine- check fuse for ECM1 or 2,if whine check fuse for eng1 .or could be fuel relay

May 03, 2011 | 1996 Chevrolet S-10 Pickup

1 Answer

Having problems with chevy s10 replaced fuel pump


Check the cable that goes from your battery to the fuse box the relay that is clicking is on. Check for lose bolts or corrosion of the contacts or something like that. If the relay is clicking it sounds to me like it is a voltage issue going to the relay.

Oct 05, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

Where is fuel shut off switch on 2002 chevy s10 zr2 4.3 liter


There is no shut off switch on a 2002 chevy S10. Sorry for the bad news.
Good luck and hope this helps, there is a fuel pump relay in the glove box behind a rear panel to the left corner in the box. The relay i believe is the middle one of the three. 

Apr 26, 2009 | 2002 Chevrolet S-10

Not finding what you are looking for?
1996 Chevrolet S-10 Pickup Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...