Question about 2008 Chevrolet Impala SS

1 Answer

2008 impala windshield washer dic reset

Windshield washer low DIC indication. Washer full but warning remains illuminatd.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 14,585 Answers

You have a bad sensor. It's on the washer reservoir. This is a 2003 pic, But gives you an idea where to look. The sensor is the one on the right.2008 impala windshield washer dic reset - 0b881713-956c-40a5-a1eb-b595b40be6e8.gif

Posted on Jun 08, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
robmonroe
  • 67 Answers

SOURCE: Drivers Information Center in a 2005 Chevy Impala

Turn the key to the on position (not start) with the radio off. Wait 10 seconds. Press the "display" button on the radio and hold for 10 to 12 seconds. the radio display will light up . Press "display" and "1" to select functions.

This was not tested or confirmed by me, but my dad has a 2005 Impala and this is what he told me. Let me know if it works or not, and I can try to investigate it more if needed.

Posted on Jun 09, 2008

  • 373 Answers

SOURCE: the check engine light illuminates,

HI...
THis problem is caused for
Lost of correlation between ACELERATOR PEDAL POSITION
AND THROTTLE ACTUATOR MOTOR.
Because your car has no acelerator cable.
The morer probable is the Trhottle actuator motor come damaged. 90%. 10% the accelerator pedal position.
If you turn of the car it will work OK> for a few time.
But the Service engine soon. will stay on.
Yuo can go to at ANy ADVANCE AUTOPART, AUTOZONE or NAPA AUTOPART. They make a diagnostic free.
If not. I recomend get the car scanned for see exactly why the light come on. and make the right repair procedure.

OK>> I hope this help on your question...

Thank you for use fixya.

Posted on Jul 25, 2008

  • 5 Answers

SOURCE: Windshield washer fluid will not pump

the windshield washer pump might be bad. It should be located somewhere on the reservoir

Posted on Nov 27, 2008

  • 7 Answers

SOURCE: program a keyless remote on a 2006 impala

push relearn again then press and lock and unlock for about ten seconds till u hear beep

Posted on Jul 15, 2009

  • 1 Answer

SOURCE: is there a fuse fot the windshield washer pump on

there is a fuse for the windshield washer pump. It is located in the under the hood fuse box.The fuse is near the bottom marked WSW. Look in the manual for fuse box (under hood) I read that Chevy recommended repacing the 10 amp fuse with a 15amp. There are spare fuses in the bottom of the fuse box(labeled in the manual) and there is a 15 amp. I changed mine in 3 minutes and now it works. Hope I helped.

Posted on Dec 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

98 Oldsmobile Aurora There's a on my Dash it says information center and has the oil fuel speed all that it says low oil is there any way anybody knows how to reset that


Check your engine oil using the oil dipstick located on the engine - you need to add oil to the fill line as shown on the dipstick. You should have the oil replaced regularly (every 3-6 months) and keep your eye on the level if the engine is leaking oil underneath or burning a lot of it.

Mar 08, 2017 | Oldsmobile Cars & Trucks

Tip

Adding windshield washer fluid to Buick Lacrosse 2005


When the windshield washer fluid is low, a low washer fluid light may appear on the instrument panel cluster. In addition, if your vehicle is equipped with a Driver Information Center (DIC), the LOW WASHER FLUID message will appear when the fluid level is low. When you need windshield washer fluid, be sure to read the manufactures instructions before use. If you will be operating your vehicle in an area where the temperature may fall bellow freezing, use a fluid that has sufficient protection against freezing.

on Oct 08, 2010 | Buick LaCrosse Cars & Trucks

1 Answer

Need to change km/h back to MPH on 2008 Chevy Impala


To change display to a Metric or English reading, press and hold the RESET & MODE buttons for 3 (three) seconds...Good-Day! It should be listed in your owners manual under driver information center ( DIC )

Sep 21, 2014 | 2008 Chevrolet Impala

1 Answer

Tpms light on, dic indicated low tp fr, inflated to proper pressure,tpms stays on, dic wont update


TPMS - TIRE PRESSURE MONITOR WARNING LIGHT
NOTE: Tire pressure rises and falls depending on heat caused by vehicle's operation and the outside temperature. If outside temperature is low, the air inside the tire may cool, causing a lower tire inflation pressure. This may cause the low tire pressure warning light to illuminate.

When the tire pressure warning light comes on, immediately check the air pressure of all tires and adjust to the specified pressure. Make sure the warning light goes off. If the warning light stays on or flashes, there is a malfunction in the TPM system. See appropriate manufacturer service information.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Feb 13, 2012 | Cars & Trucks

1 Answer

How do you reset the change oil soon display on a 2008 yukon after changing the oil? how many quarts does it take?


Hi. You have these 4 buttons in a row (DIC buttons) you can find it near the left of the center a/c vent.. Select the button with the car icon. Press on this button repeatedly until the "% OIL Life Remaining" appears on the IPC messages screen. Stop there. Press and hold that same button until the message indicate "100% Oil Life Remaining". With a new oil filter, around 5.6 liters. And that's it. Okay, sir? : )

Jan 04, 2011 | 2008 GMC Yukon

1 Answer

What does a c on the dic mean?


Your vehicle has a Driver Information Center (DIC).
All messages will appear in the DIC display located
below the speedometer in the instrument panel cluster.
The DIC buttons are located on the instrument panel,
to the left of the instrument panel cluster.
The DIC comes on when the ignition is on. After a short
delay, the DIC will display the information that was
last displayed before the engine was turned off.
The DIC displays trip, fuel, and vehicle system
information, and warning messages if a system problem
is detected. The bottom line of the DIC shows the
shift lever position indicator. See Automatic
Transmission Operation on page 3-23
for more
information.
If your vehicle’s DIC has these features, the compass
direction and the outside air temperature may also
display on the DIC when viewing the trip and fuel
information. The compass direction appears on the top
right corner of the DIC display. The outside air
temperature automatically appears in the bottom right
corner of the DIC display. If there is a problem with the
system that controls the temperature display, the
numbers will be replaced with dashes. If this occurs,
have the vehicle serviced by your dealer/retailer.
The DIC also allows some features to be customized.
See DIC Vehicle Customization on page 4-66 for
more information.
DIC

Sep 05, 2010 | 2002 Buick Rendezvous

1 Answer

How do you reset the oil in the arcadia after you get it changed?


Hi. If you have these 4 buttons in a row (DIC buttons) you can find it near the radio. Select the button with the car icon. Press on this button repeatedly until the "% OIL Life Remaining" appears on the IPC messages screen. Stop there. Press and hold that same button until the message indicate "100% Oil Life Remaining". And that's it. Okay, sir? : )

Aug 09, 2010 | 2008 GMC Acadia

1 Answer

Dic warning "engine Oil Low - Check Level" but the oil on dipstick indicates full - also oil pressure indicates normal????


you may have a sensor bad in the crankcase that detects oil level.
I would disregard as long as the oil is changed regularly, and you have no pressure problems and the level on the dipstick is within the cross hatches or between the low and high range.

Jun 21, 2010 | 2002 Buick LeSabre

3 Answers

How do I reset the "Oil Change Warning Indication" on colorado


if you have a owners manual read it. try coloradofans.com website and search the forums. i think johnny5846 is right if you don't have a DIC (driver info center). i believe you use the DIC(tripodometer). i don't know the sequence off hand, you can also you can change your lock settings and alarm settings, etc. with the DIC.

Jan 13, 2009 | 2006 Chevrolet Colorado

Not finding what you are looking for?
2008 Chevrolet Impala SS Logo

Related Topics:

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...