Question about 2004 GMC Envoy

Open Question

Gmc dealerships in dfw

Rear door on envoy xu has a broken actuator

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 77202 Answers

SOURCE: driver door panel removal on 02 gmc envoy

2 or 3 screws and about 12 christmas tree push in clips

Posted on Oct 29, 2008

Ad
Molson02536
  • 3854 Answers

SOURCE: 2005 GMC Envoy Locked in 4WD all the time

If your luck it's going to be a $15.00 vacuum switch on the transfer case that takes about 15 min to replace, if it's the electronic solenoid to the transfer case then it's going to be cost a little more and take a little longer. If your try switching from 4WD to 2WD and hear the solenoid working by hearing the cluck's when it engages and disengage then it's going to be the vacuum switch on top of the transfer case on the drivers side. Auto Zone Sell's them for $15.00 and they will have the step by step instructions to replacing the switch. They will also have the transfer case solenoid  too, if you don't hear the solenoid. Check the fuses, the fuse may have gone bad. Good luck and hope this helps.

Posted on Jun 19, 2009

  • 4 Answers

SOURCE: Removing rear air suspension on GMC Envoy

Just behind right rear tire up in the wheel well. Air inlet is inside right rear quarter near the accessory inflator. Compressor runs 3 lines one for the accessory inflator and one for each air bag.
THere are also 2 sensors, one on each trailing arm that senses load and then raises and lowers accordingly.

Posted on Feb 17, 2010

  • 82 Answers

SOURCE: 2004 GMC Envoy rear hatch complete door wont

door lock actuator solenoid ( inside of door) needs to be replaced

Posted on Mar 25, 2010

  • 1 Answer

SOURCE: 2004 GMC Envoy rear hatch complete door wont

I have this same problem currently...did you find anything out about it?

Posted on Nov 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

2005 envoy drivers door wont open from inside or outside


Linda, The door latch linkage is probably damaged or fallen off inside the door. Pop into a good body shop and have them check the door lock/latch mechanism for you. The body shop rates tend to be more reasonable then dealership for this type of repair. Links below are just to give you an idea of what may be involved in repair.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
GMC Envoy door panels remove and install front and rear
How To Install Replace Broken Power Door Lock Front Chevy Trailblazer GMC...
Chevy Truck Door Latch
How chevy door latch works



Jun 22, 2016 | 2005 GMC Envoy

1 Answer

Went to replace passenger side blend door actuator, (2002 GMC Envoy) but actuator is ok, shaft that goes to door only turns about 1/8 turn- needs to turn 1/4 turn. what can I do?


Try system reboot. Disconnect engine battery for two minutes, reconnect and turn the ignition key to the 'on' position and wait two minutes for the system to recalibrate actuators.

Jan 09, 2014 | 2002 GMC Envoy

1 Answer

None of the buttons on the driverside door panel on my 2002 gmc envoy work


Some possibilities are; Fuse #10 in rear fuse panel, bad DDM (Driver's Door Module) or a broken wire in the wire harness that goes between the body and the door.

Sep 14, 2011 | 2002 GMC Envoy

1 Answer

I have a 2003 GMC Envoy XL when I start the car it makes a ticking noise for about a minute or 2 - coming from rear wheel well then the noise just stops


That is one of the mode control actuators in the rear HVAC unit, it is trying to move the mode door but is meeting resistance. You can access that area by removing several screws and removing the panel.

Aug 05, 2011 | 2003 GMC Envoy

1 Answer

2006 slt gmc envoy ac problems vent controls anbd


{: ) The popping sound you heard is caused by the sudden movement of an HVAC door, most probably coming from the recirculation door actuator (right dashboard area) or the mode actuator( mid dashboard area). The fan outputs could be normally working, but is being muffled by the incorrect positioning of the HVAC doors, giving an impression that there is fault in the blower controls. In other words, your vehicle is having an air distribution issue.
If there's no conflict in your climate settings, then the trouble may be in the HVAC doors binding or broken, or the actuators faulty or sticking. In both cases, servicing may involve removal of the dashboard to access these HVAC components.

Jul 20, 2010 | 2006 GMC Envoy

1 Answer

2004 GMC Envoy rear hatch complete door wont


door lock actuator solenoid ( inside of door) needs to be replaced

Mar 25, 2010 | 2004 GMC Envoy

1 Answer

04 GMC ENVOY XU While rolling up the window on my midgate I heard


the plastic part of the window regulator has broken I think on that year the motor and regulator come as a one piece replacement unit and are fairly easy to install,if you remove the inner panel you should be able to see the broken piece when you try to cycle the window.Good luck

Jan 04, 2010 | 2004 GMC Envoy

1 Answer

MY 2004 GMC ENVOY XL HAS AC IN FRONT AND AC IN THE REAR. THE REAR AC IS BLOWING BUT NOT COOLING OFF WHAT COULD BE A POSSIBLE PROBLEM


LOw on freon can cause this scenario but there is also a temp door actuator that can cause in the rear case.A good repair shop can hook up a scanner and check to see if there are any trouble code's for the a/c. Good luck

Aug 11, 2009 | 2004 GMC Envoy

2 Answers

Back door will not open from the side.


You will need to pull off the back panel to access the handle and rod. You either have a broken handle, or the rod that goes to the actuator has fallen off.

Mar 13, 2009 | 2004 GMC Envoy

Not finding what you are looking for?
2004 GMC Envoy Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...