Question about 2001 Lincoln LS

1 Answer

MY WIPER MOTER MAKES A NOISE WHEN YOU TURN THEM ON THE WIPERS WILL NOT GO UNLESS YOU PUSH THEM BY HAND

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,392 Answers

Replace the wiper motor.

Posted on Jun 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Windscreen wipers wont move nissan micra moter making noise tho


sounds like motor is spining. problem could be striped gears conecting motor to wipers

Sep 17, 2013 | Cars & Trucks

1 Answer

The Wiper fuse keeps blowing? Any Ideas?


Does the fuse blow as soon as you turn on the switch? Or do the wipers operate for a bit then the fuse blows? Will the wipers work in intermittent mode? Can you move the wipers by hand? Unless other wiring work has been done (eg radio replaced) I suspect the wiper motor is toast.

Jun 25, 2012 | Chevrolet Cobalt Cars & Trucks

1 Answer

The wiper blades won't move . You can hear the


The Wiper Control Rod under the cover has a Push on Pivoting Arm and the Ball Broke and will not work the wipers until it is replaced

May 26, 2011 | 1988 GMC S-15

1 Answer

Wiper on 2003 ford explorer. when turned on a noise comes from under dash and wipers dont work. they will work if I turn on switch and move the wipers, they will cycle once.


it sounds like the problem is the wiper motor if they work when you move them by hand.the motor probably has a bad spot in it,first try hooking up a jumper wire from the battery ground and the other end to the wiper motor body and make sure its a good ground at the motor.if the wipers work alright then permanently hook up a ground to the motor and body,as the motor will have a bad ground not allowing the wipers to work.

Apr 24, 2011 | Ford Explorer Cars & Trucks

3 Answers

Wipers do not work. i replaced the wiper switch and checked the fuses ,The red wire to the wiper moter has power ,how do I know if the wiper moter is defective?


there are usually two hot wires going to the wiper motor .. also a ground strap that may be bad ... one of the hot wires is always on if the key is on ... that for homing the wiper blades when you turn them off .. the other power input is from the wiper control circuit .. its only on if the wiper switch is turned on .. if you have power on the homing input then that wont do anything unless the wipers are not in home position .. if you have power to the "run" wire of the motor and the ground is good then the motor should run unless its defective .. you can put a jumper cable from the ground of the wiper motor to the engine block or battery neg, to check if the ground wire is causing the trouble .. that happens frequently in some models but not sure about your E250 ...

Oct 04, 2009 | 2002 Ford E250

1 Answer

Windshield wipers just stopped working,but i can hear the moter.


There isn't a cable, its a flat bar with push on connectors at each end one of which has probably popped off
You need to take off the mesh panel that goes the width of th car just below the wind shield to access this.
There is only one motor and if you can hear it working its probably OK

Jan 24, 2009 | 1990 Lincoln Town Car

2 Answers

The wiper blades on my 1990 mazda rx7 will not turn on. can you help


First check that the nut on the arm is secute,and that the motor is running ,also check the fues ,if you cannot heare the moter and the fues is ok change the moter

Dec 02, 2008 | 1983 Mazda RX-7

1 Answer

Windshield wipers make loud noise but dont move when turned on


Probably stripped the little splines where wiper arm attaches to pivot. Flip the cover up where arm attaches to pivot, and tighten nuts on there, but be careful not to go too far, its not hard to snap the pivot stud if you tighten too much. make sure wipers are off, in park position, and move arms to where they should be, then tighten. See if you still get loud noise after. If you do, somethings wrong under cowl, in the linkages or motor. You may be able to see something with flashlight or troublelight.

Nov 21, 2008 | 1999 Dodge Caravan

Not finding what you are looking for?
2001 Lincoln LS Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

fordexpert

Level 3 Expert

5522 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...